LIVINGbasics 2-in-1 Single Serve Coffee Maker Instruction Manual

Introduction

Thank you for choosing the LIVINGbasics 2-in-1 Single Serve Coffee Maker. This appliance is designed for convenient brewing of single cups of coffee using either K-Cup pods or your preferred ground coffee. Please read this manual thoroughly before operation to ensure safe and efficient use.

Important Safety Instructions

WARNING: To reduce the risk of fire, electric shock, or injury, always follow basic safety precautions.

• Read all instructions before using the appliance.
• Do not touch hot surfaces. Use handles or knobs.
• To protect against fire, electric shock, and injury to persons, do not immerse cord, plugs, or the appliance in water or other liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair, or adjustment.
• The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock, or injury to persons.
• Do not use outdoors.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to “off”, then remove plug from wall outlet.
• Do not use appliance for other than intended use.
• Scalding may occur if the lid is removed during the brewing cycles.
• Ensure the lid is fully closed and secured before brewing to prevent leaks or spills.
• Wait approximately 15 seconds after closing the lid with a K-Cup pod inserted before pressing the start button to ensure proper piercing and prevent leakage.

Package Contents

Please check the box for the following items:

• LIVINGbasics 2-in-1 Single Serve Coffee Maker
• K-Cup Pod Holder
• Reusable Ground Coffee Filter
• Coffee Scoop
• Instruction Manual

Product Overview

Figure 1: Exploded view of the coffee maker components.

Familiarize yourself with the various parts of your coffee maker:

• Lid Tab: Used to open the top lid.
• Piercing Needle: Punctures K-Cup pods for brewing.
• Lid: Covers the brew chamber and water reservoir.
• Single-Serve Pack Holder: Holds K-Cup pods or the reusable filter.
• Water Tank: Removable reservoir for water.
• Funnel Handle & Funnel: Used with the reusable ground coffee filter.
• Main Body: The primary housing of the coffee maker.
• Brew Basket Lid & Brew Basket: Components for the reusable ground coffee filter.
• Button: Power/Start button.
• Drip Tray Cover & Drip Tray: Collects drips and supports your cup.
• Water Gauge: Indicates water level in the tank.
• Front Body: The front panel of the appliance.

Figure 2: Appliance dimensions for placement reference.

Setup and First Use

1. Initial Cleaning

1. Remove all packaging materials and labels from the coffee maker.
2. Wash the removable water tank, K-Cup pod holder, reusable ground coffee filter, and drip tray in warm, soapy water. Rinse thoroughly and dry.
3. Wipe the exterior of the coffee maker with a damp cloth.

2. First Clean Cycle (Before First Brew)

1. Place the coffee maker on a stable, flat surface.
2. Fill the water tank with fresh, cold water up to the MAX line.
3. Ensure no K-Cup pod or ground coffee is in the brew chamber.
4. Place a large mug (at least 10 oz) on the drip tray.
5. Plug the power cord into a grounded electrical outlet. The power button will illuminate.
6. Press the power button to start a brewing cycle with just water.
7. Discard the hot water. The coffee maker is now ready for use.

Operating Instructions

Brewing with K-Cup Pods

Figure 3: Quick start guide for K-Cup pod brewing.

1. Lift the lid tab to open the top lid of the coffee maker.
2. Insert a K-Cup pod into the K-Cup pod holder. Ensure it is seated correctly.
3. Fill the water tank with fresh, cold water to your desired level (up to 10 oz for a standard brew).
4. Place your coffee mug on the drip tray.
5. Close the top lid firmly. Wait approximately 15 seconds for the pod to be properly pierced.
6. Press the power button to begin brewing. The light will indicate brewing is in progress.
7. Once brewing is complete, the light will turn off. Carefully remove your hot coffee.

Brewing with Ground Coffee

Figure 4: The 2-in-1 feature allows for both K-Cup pods and ground coffee.

1. Lift the lid tab to open the top lid.
2. Open the reusable ground coffee filter. Using the provided coffee scoop, fill the filter with your desired amount of ground coffee (do not overfill).
3. Close the reusable filter and place it into the single-serve pack holder in the brew chamber.
4. Fill the water tank with fresh, cold water to your desired level (up to 10 oz for a standard brew).
5. Place your coffee mug on the drip tray.
6. Close the top lid firmly.
7. Press the power button to begin brewing. The light will indicate brewing is in progress.
8. Once brewing is complete, the light will turn off. Carefully remove your hot coffee.

Maintenance and Cleaning

Daily Cleaning

1. Always unplug the coffee maker before cleaning.
2. Remove the K-Cup pod holder or reusable ground coffee filter, drip tray, and water tank. Wash these parts in warm, soapy water. Rinse thoroughly and dry.
3. Wipe the exterior of the coffee maker with a damp, soft cloth. Do not use abrasive cleaners or scouring pads.
4. Do not immerse the coffee maker's main body in water or any other liquid.

Descaling

Over time, mineral deposits (scale) can build up in your coffee maker, affecting its performance. Descale your appliance every 3-6 months, or more frequently if you have hard water.

1. Fill the water tank with a mixture of one part white vinegar and two parts water.
2. Place a large mug on the drip tray.
3. Run a brewing cycle without a K-Cup pod or ground coffee.
4. After the cycle, let the coffee maker sit for 30 minutes with the vinegar solution inside.
5. Run several cycles with fresh, clean water to rinse out any remaining vinegar taste.

Troubleshooting

Specifications

Warranty and Support

For warranty information, technical support, or customer service inquiries, please refer to the contact information provided on the product packaging or visit the official LIVINGbasics website.