Introduction
This manual provides detailed instructions for the setup, operation, and maintenance of your Jamo S 805 Floorstanding Speaker Pair. The S 805 is a studio tower speaker featuring a 5-inch polyfiber woofer and a 1-inch soft dome tweeter. It incorporates WaveGuide acoustic technology and a seamless magnetic grille. The design includes a patent-pending docking system for an optional S 8 ATM Dolby Atmos speaker (sold separately).
Please read this manual thoroughly before using your speakers to ensure proper installation and optimal performance.
What's in the Box
- 2 x Jamo S 805 Floorstanding Speakers
- Speaker grilles (magnetic)
- Speaker feet/stabilizers
- User Manual (this document)
Setup
1. Speaker Placement
Optimal speaker placement is crucial for sound quality. Position the speakers equidistant from your primary listening position. For stereo setups, aim for an equilateral triangle between the two speakers and the listener. Keep speakers away from corners and walls to avoid excessive bass resonance. Ensure adequate space for air circulation around the speakers.

Figure 1: Jamo S 805 Floorstanding Speaker (Black)
This image shows a single Jamo S 805 floorstanding speaker in a black finish. The speaker features a wooden-look tweeter housing at the top, a larger white polyfiber woofer below it, and a front-firing port near the bottom. The Jamo logo is visible on the lower front panel. The speaker rests on a wooden base with four stabilizing feet. Dimensions are indicated: 30.98 inches height, 9.92 inches width, and 7.52 inches depth.
2. Connecting to an Amplifier/Receiver
Use high-quality speaker wire to connect your Jamo S 805 speakers to your amplifier or receiver. Ensure correct polarity: connect the positive (+) terminal on the speaker to the positive (+) terminal on the amplifier, and the negative (-) terminal on the speaker to the negative (-) terminal on the amplifier. Incorrect polarity can result in poor sound quality.
3. Attaching Stabilizer Feet
Attach the provided stabilizer feet to the bottom of each speaker. These feet enhance stability and help decouple the speaker from the floor, improving sound clarity. Refer to the diagram below for proper attachment.

Figure 2: Jamo S 805 Speaker Dimensions
This image illustrates the physical dimensions of the Jamo S 805 floorstanding speaker. The height is approximately 30.98 inches, the width is 9.92 inches, and the depth is 7.52 inches. These measurements are important for planning speaker placement and ensuring proper fit within your listening environment.
4. Optional S 8 ATM Dolby Atmos Speaker Integration
The Jamo S 805 speakers feature a patent-pending docking system for the optional S 8 ATM Dolby Atmos speakers. If you have S 8 ATM modules, carefully align and place them on top of the S 805 speakers. Connect the S 8 ATM modules to the dedicated terminals on the S 805 speakers as per the S 8 ATM's instruction manual.
Operating Instructions
1. Power On/Off
Ensure your amplifier/receiver is powered on. The Jamo S 805 speakers are passive and do not have their own power switch. Their operation is controlled by the connected audio source.
2. Volume Control
Adjust the volume using your amplifier/receiver's controls. Start with a low volume and gradually increase it to a comfortable listening level. Avoid excessively high volumes to prevent damage to the speakers or your hearing.
3. Source Selection
Select your desired audio source (e.g., CD player, turntable, streaming device) through your amplifier/receiver.
Maintenance
1. Cleaning
Wipe the speaker cabinets with a soft, dry cloth. Do not use abrasive cleaners, waxes, or solvents. For the grilles, use a soft brush or vacuum cleaner with a brush attachment to gently remove dust. Avoid touching the speaker cones directly.
2. Handling
Handle speakers with care. Avoid dropping them or subjecting them to strong impacts. When moving, lift the speakers from the base, not by the grilles or drivers.
3. Environment
Keep speakers away from direct sunlight, heat sources, and excessive moisture. Ensure good ventilation to prevent overheating of connected electronics.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No sound from speakers |
|
|
| Distorted or unclear sound |
|
|
| Uneven sound between speakers |
|
|
Specifications
| Feature | Detail |
|---|---|
| Brand | Jamo |
| Model Name | S 805 |
| Speaker Type | Floorstanding, Woofer |
| Color | Black |
| Material | Plastic (cabinet construction) |
| Included Components | 2 speakers |
| Product Dimensions (D x W x H) | 7.52" x 9.92" x 30.98" |
| Item Weight | 46.6 pounds (per pair) |
| Woofer Diameter | 5 Inches (127mm polyfiber woofer) |
| Tweeter Size | 1 Inch (25mm soft dome tweeter) |
| Speaker Maximum Output Power | 70 Watts |
| Connectivity Technology | Wired |
| Audio Output Mode | Stereo, Surround Sound |
| Mounting Type | Floor Mount |
| Compatible Devices | Desktop, Gaming Console, Laptop, Television |
| Special Features | WaveGuide acoustic technology, Seamless magnetic grille, Patent-pending docking for S 8 ATM Atmos speaker |
| UPC | 008634002858, 715350090280 |
Warranty and Support
The Jamo S 805 Floorstanding Speaker Pair comes with a Full Warranty. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Jamo website.
For technical support, troubleshooting assistance beyond this manual, or service inquiries, please contact Jamo customer support through their official website or the contact information provided in your product packaging.







