Passion-Electro Replacement Remote Control

Introduction

Thank you for choosing the Passion-Electro Replacement Remote Control for your GRANDIN LD49VG279 television. This remote is a dedicated replacement, designed to provide full functionality without the need for complex programming. Simply insert the batteries, and it is ready for use. This manual will guide you through the setup, operation, and maintenance of your new remote control.

Product Overview

The Passion-Electro replacement remote control is designed to replicate the functionality of your original GRANDIN LD49VG279 TV remote. It features a standard layout for easy navigation and control of your television.

Image: Front view of the remote control, displaying the power button, channel and volume controls, navigation pad, numeric keypad, and special function buttons. The 'Passion-Electro' logo is visible at the bottom.

The remote control is ergonomically designed for comfortable handling and features clearly labeled buttons for intuitive operation. While the button layout may differ slightly from your original remote, all essential functions for your GRANDIN LD49VG279 TV are fully supported.

Setup

Battery Installation

1. Locate the battery compartment on the back of the remote control.
2. Slide the battery compartment cover downwards or press the latch and lift to open it.
3. Insert two (2) AAA 1.5V batteries (not included), ensuring the correct polarity (+ and -) as indicated inside the compartment.
4. Replace the battery compartment cover by sliding it back into place until it clicks securely.

Image: Rear view of the remote control, highlighting the battery compartment where two AAA batteries are to be inserted.

Once batteries are installed, the remote control is ready for immediate use with your GRANDIN LD49VG279 TV. No programming or code entry is required.

Operating Instructions

Point the remote control directly at your GRANDIN LD49VG279 TV's infrared receiver. Ensure there are no obstructions between the remote and the TV.

• Power Button: Press to turn the TV on or off.
• Numeric Keypad (0-9): Use to directly enter channel numbers.
• Channel Up/Down (CH+/CH-): Press to change channels sequentially.
• Volume Up/Down (VOL+/VOL-): Press to adjust the sound volume.
• Mute Button: Press to temporarily silence the TV audio. Press again to restore sound.
• Navigation Pad (Arrow Buttons & OK): Use the arrow buttons to navigate through menus and lists. Press OK to confirm selections.
• Menu Button: Accesses the TV's main menu for settings and options.
• Source/Input Button: Cycles through available input sources (e.g., HDMI 1, AV, TV).
• Colored Buttons (Red, Green, Yellow, Blue): These buttons typically correspond to specific functions within TV menus or interactive services, as indicated on your TV screen.

Refer to your GRANDIN LD49VG279 TV's user manual for specific functions related to its menu system and advanced features.

Maintenance

Cleaning

To clean the remote control, use a soft, dry cloth. For stubborn dirt, lightly dampen the cloth with water or a mild, non-abrasive cleaner. Avoid using harsh chemicals or abrasive materials, as these can damage the remote's surface or buttons.

Battery Replacement

Replace batteries when the remote's response becomes sluggish or stops working. Always replace both batteries at the same time with new AAA 1.5V batteries. Do not mix old and new batteries, or different types of batteries.

Storage

If the remote control will not be used for an extended period, remove the batteries to prevent leakage and potential damage to the device.

Troubleshooting

• Remote is not working:
  • Ensure batteries are inserted correctly with the proper polarity.
  • Replace old batteries with new ones.
  • Check if there are any obstructions between the remote control and the TV's infrared receiver.
  • Make sure the TV is powered on.
• Limited range or intermittent response:
  • Replace batteries.
  • Ensure you are within the effective operating range (up to 10 meters).
  • Remove any objects that might be blocking the signal path.
• Certain functions are not working:
  • Verify that your TV model is indeed GRANDIN LD49VG279. This remote is specifically designed for this model.
  • Some advanced TV features might require specific button sequences or menu navigation as per your TV's original manual.

Image: The infrared (IR) emitter located at the front end of the remote control, which sends signals to the TV.

Specifications

• Brand: Passion-Electro
• Model: Grandin LD49VG279
• Compatible Devices: Television (specifically GRANDIN LD49VG279)
• Connector Type: Infrared (IR)
• Power Source: 2 x AAA 1.5V Batteries (not included)
• Maximum Range: 10 meters (approx. 33 feet)
• Item Weight: 100 g
• Color: Black

Warranty and Support

For any questions, technical support, or warranty inquiries regarding your Passion-Electro replacement remote control, please contact the seller or manufacturer directly through your purchase platform. Please retain your proof of purchase for warranty claims.