Lamicall Cell Phone Ring Holder Stand Instruction Manual

1. Setup Instructions

This section guides you through the proper installation of your Lamicall Cell Phone Ring Holder Stand.

1.1 Surface Preparation

Ensure the surface where the ring holder will be attached is clean, dry, and free of dust or oils. For optimal adhesion, avoid applying to soft silicone, TPU, PP, or TPE cases. A hard, smooth case surface is recommended.

1.2 Attaching the Ring Holder

1. Peel off the protective film from the 3M adhesive on the back of the ring holder.
2. Carefully align the ring holder to your desired position on the back of your phone or phone case. Press firmly for at least 30 seconds to ensure a strong bond.
3. Allow the adhesive to cure for 24 hours before first use to achieve maximum strength.

2. Operating Instructions

The Lamicall Cell Phone Ring Holder Stand offers multiple functionalities for enhanced phone usage.

2.1 Using as a Phone Grip

Insert your finger through the ring to securely hold your phone with one hand, reducing the risk of accidental drops. The ring features 360° rotation and 180° adjustability, allowing you to find the most comfortable grip angle.

2.2 Using as a Kickstand

Extend the ring and adjust its angle to prop your phone in either landscape or portrait mode. This allows for hands-free viewing of videos, reading, or video calls.

2.3 Magnetic Car Mount Compatibility

The metal construction of the ring holder allows it to attach to magnetic car mounts, providing a convenient and secure way to use your phone for navigation or hands-free calls while driving.

2.4 Official Product Video

3. Maintenance

Proper care ensures the longevity and performance of your Lamicall Cell Phone Ring Holder Stand.

3.1 Cleaning

Wipe the ring holder with a soft, dry cloth to remove dust or fingerprints. Avoid using harsh chemicals or abrasive materials, which could damage the polished metal finish.

3.2 Adhesive Replacement

The original 3M adhesive is designed for a single, strong application. If you need to re-position the holder or attach it to a new device/case, use one of the included spare 3M adhesive pads. The original adhesive is not reusable once removed.

4. Troubleshooting

This section addresses common issues you might encounter with your ring holder.

4.1 Ring Holder Not Sticking

• Surface Type: Ensure the surface is hard and smooth. The adhesive is not suitable for soft silicone, TPU, PP, or TPE cases.
• Surface Cleanliness: Verify the surface was thoroughly cleaned and dried before application. Residue can prevent proper adhesion.
• Curing Time: Allow the adhesive to cure for the recommended 24 hours before applying stress to the ring.
• Temperature: Extreme temperatures (very hot or very cold) can affect adhesive performance. Apply in a moderate environment.

4.2 Ring Becomes Loose or Separates

• Excessive Force: Avoid pulling the ring with excessive force, especially when removing the phone from tight pockets.
• Wear and Tear: Over extended periods of heavy use, the hinge mechanism may naturally loosen. If the ring separates from its base, it may be possible to snap it back into place, but its stability as a kickstand might be compromised.
• Adhesive Failure: If the entire unit detaches, the adhesive may have failed due to improper application or incompatible surface material. Use a new adhesive pad for re-attachment, ensuring proper surface preparation.

5. Specifications

6. Warranty & Support

Lamicall products are designed for durability and performance. For specific warranty details or technical support, please refer to the official Lamicall website or contact their customer service directly.

Lamicall Official Store: Visit Lamicall Store on Amazon

Please retain your purchase receipt for warranty claims.