Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your kadision 60W LED Wall Pack Light with Photocell. This outdoor lighting fixture is designed for commercial and residential applications, offering efficient illumination with a built-in dusk-to-dawn photocell for automatic operation.
Image: Four kadision 60W LED Wall Pack Lights, showcasing the product's design and quantity in a typical package.
Safety Information
Please read all instructions carefully before installation and use. Failure to follow these instructions may result in electric shock, fire, or other hazards, which could cause property damage or personal injury.
- WARNING: Risk of electric shock. Disconnect power at the fuse or circuit breaker before installing or servicing.
- Installation must be performed by a qualified electrician in accordance with all national and local electrical codes.
- Ensure the supply voltage is compatible with the fixture's requirements (100-277V).
- Do not handle the fixture with wet hands or when standing on wet or damp surfaces.
- This fixture is designed for outdoor use and is IP65 rated for wet locations.
- Do not attempt to modify or disassemble the fixture. There are no user-serviceable parts inside.
Package Contents
Verify that all components are present before beginning installation:
- kadision 60W LED Wall Pack Light (quantity as purchased, e.g., 4 units)
- Built-in Photocell (integrated)
- Integrated LEDs (pre-installed)
- Protective Pad
- Conduit Entry Plug
- Wire Nuts
Specifications
| Feature | Specification |
|---|---|
| Model Number | WP-60B-277-50K-P |
| Wattage | 60 Watts |
| Lumen Output | 7800 Lumens |
| Color Temperature | 5000K Daylight |
| Input Voltage | 100-277V |
| Material | Aluminum, Polycarbonate |
| Finish Type | Polished Bronze |
| IP Rating | IP65 (Waterproof) |
| Lifespan | >50,000 Hours |
| Dimensions (L x W x H) | 13.1" x 6.46" x 9.21" |
| Certifications | ETL/cETL Listed |
| Special Features | Dusk-to-Dawn Photocell, Energy Efficient, Hardwired |
Image: Detailed dimensions of the kadision 60W LED Wall Pack Light, including length, width, and height measurements, along with included accessories like a protective pad, conduit entry plug, and wire nuts.
Image: Close-up view highlighting the solid construction, IP65 waterproof rating, and expected lifespan of over 50,000 hours for the kadision LED Wall Pack Light.
Installation
This fixture can be mounted over an electrical junction box or directly on the wall surface using conduit entries. Ensure power is disconnected before proceeding.
Tools Required (Not Included):
- Screwdriver (Phillips and Flathead)
- Wire Strippers
- Drill (if surface mounting)
- Pencil
- Safety Glasses
Mounting Steps:
- Disconnect Power: Turn off power at the circuit breaker or fuse box to avoid electrical shock.
- Prepare Fixture: Open the fixture by loosening the screws on the side. The front cover will pivot open.
- Choose Mounting Method:
- Junction Box Mount: Align the fixture's central hole with your existing junction box. Secure the fixture to the junction box using appropriate screws (not included).
- Surface Conduit Mount: Use one of the 1/2" conduit entry holes on the sides or the center hole for wiring. Mark and drill pilot holes for mounting screws (not included) if mounting directly to the wall. Ensure a secure attachment.
- Wiring:
- Connect the black wire from the fixture to the live/hot wire from the power supply.
- Connect the white wire from the fixture to the neutral wire from the power supply.
- Connect the green wire from the fixture to the ground wire from the power supply.
- Use the provided wire nuts to secure all connections. Ensure all connections are tight and insulated.
- Close Fixture: Carefully close the fixture cover and tighten the screws to ensure a watertight seal.
- Restore Power: Turn on power at the circuit breaker.
Image: Internal view of the kadision LED Wall Pack Light showing wiring connections, 1/2" conduit entry holes, a center hole with a plug, and knock-outs. Illustrations demonstrate both junction box mount and surface conduit mount wiring configurations.
Image: A diagram illustrating suggested installation heights (12ft, 15ft, 20ft) for the 60W wall pack light and the corresponding light coverage diameter, along with a 120-degree beam angle. An example shows the light illuminating a garage area at night.
Operating Instructions
The kadision 60W LED Wall Pack Light features a built-in dusk-to-dawn photocell for automatic operation.
- Automatic Operation: The light will automatically turn ON when ambient light levels fall below approximately 20 lux (dusk) and turn OFF when sufficient daylight is detected (dawn).
- Photocell Placement: Ensure the photocell is located in an area that receives natural daylight and is not obstructed or too close to reflective surfaces, which could interfere with its operation.
- Disabling Photocell: If continuous operation or control via an external switch is desired, the photocell can be disabled by unplugging its wire connector inside the fixture. Refer to the wiring diagram in the Installation section.
- Relocating Photocell: If necessary, the photocell can be relocated using one of the conduit entry holes for optimal light sensing.
Image: A close-up view of the built-in dusk-to-dawn photocell on the kadision LED Wall Pack Light, illustrating its function to automatically turn the light on at dusk and off at dawn.
Image: A diagram illustrating the photocell sensor's operation, showing the light automatically turning off during the daytime and on during nighttime. Text explains that the light activates when ambient light levels are low (approx. 20lx) and deactivates when the sun rises. It also provides instructions for disabling or relocating the photocell.
Maintenance
The kadision LED Wall Pack Light is designed for minimal maintenance. However, periodic cleaning and inspection can ensure optimal performance and longevity.
- Cleaning: Periodically clean the lens and exterior housing with a soft, damp cloth to remove dirt, dust, and debris. Do not use abrasive cleaners or solvents.
- Inspection: Annually inspect the fixture for any signs of damage, loose wiring, or corrosion. Ensure all mounting screws are tight.
- LEDs: The integrated LEDs are designed for a long lifespan and are not user-replaceable.
- Photocell: Ensure the photocell sensor remains clear of obstructions (e.g., leaves, dirt) to maintain proper dusk-to-dawn functionality.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Light does not turn on at night. | No power, faulty wiring, photocell obstructed or malfunctioning. | Check circuit breaker. Verify wiring connections. Clear any obstructions from the photocell. Ensure photocell is not disabled. |
| Light stays on during the day. | Photocell obstructed, photocell malfunctioning, or photocell disabled. | Clear any obstructions from the photocell. Ensure the photocell is receiving sufficient daylight. Check if the photocell is accidentally disabled. |
| Light flickers or cycles on/off. | Unstable power supply, loose wiring, or photocell interference. | Ensure stable power supply. Check all wiring connections for tightness. Relocate the fixture or clear objects that might cast shadows or reflect light onto the photocell. |
| Reduced light output. | Dirty lens. | Clean the lens with a soft, damp cloth. |
If troubleshooting steps do not resolve the issue, contact customer support.
Warranty and Support
kadision provides a 5-Year Warranty for this product. This warranty covers defects in materials and workmanship under normal use.
For warranty claims, technical assistance, or any questions regarding your product, please contact kadision customer service directly via Amazon's Buyer-Seller Messaging Service. Please have your purchase details and model number (WP-60B-277-50K-P) available when contacting support.
For more information, visit the official kadision store on Amazon: kadision Store