Introduction
This manual provides instructions for the setup, operation, and maintenance of your Amazon Basics Digital Alarm Clock. This device combines a digital alarm clock with a 0.9-inch red LED display, FM radio, Bluetooth wireless music playback, and a USB charging port.
Front view of the Amazon Basics Digital Alarm Clock, showing the red LED time display.
Key Features:
- 0.9-inch Red LED Display with adjustable brightness.
- Integrated FM Radio.
- Bluetooth for wireless audio streaming.
- USB port for charging external devices.
- Dual alarm function with choice of FM radio or buzzer sound.
- SmartSnooze function (any button acts as snooze).
- AC powered with battery backup (AAA batteries not included).
Setup
Power Connection:
Connect the included AC adapter to the DC 5V input port on the back of the alarm clock and then plug it into a standard wall outlet. The unit requires AC power for primary operation.
Rear view of the alarm clock, highlighting the power input and USB port.
Battery Backup:
For uninterrupted timekeeping during power outages, install 2 AAA batteries (not included) into the battery compartment located on the bottom of the unit. Ensure correct polarity (+/-) when inserting batteries.
Battery compartment for AAA backup batteries.
Initial Time Setting:
- Press and hold the TIME SET button located on the top panel. The hour digits will begin to flash.
- Use the - or + buttons to adjust the hour.
- Press TIME SET again to confirm the hour and move to minute adjustment. The minute digits will flash.
- Use the - or + buttons to adjust the minutes.
- Press TIME SET one more time to save the time and exit time setting mode.
Operating Instructions
Top control panel of the alarm clock.
Setting the Alarm:
- Press and hold the ALARM SET button. The alarm hour digits will flash.
- Use the - or + buttons to set the desired alarm hour.
- Press ALARM SET again to confirm the hour and move to minute adjustment. The alarm minute digits will flash.
- Use the - or + buttons to set the desired alarm minutes.
- Press ALARM SET again to select the alarm source (BEEP, FM, or BLUETOOTH). The corresponding indicator will light up.
- Press ALARM SET one more time to save the alarm setting.
To turn the alarm off, press the OFF button. To activate SmartSnooze, press any button (except OFF) when the alarm sounds. The alarm will pause for 9 minutes and then sound again.
FM Radio Operation:
- Press the FM button to switch to FM radio mode.
- Use the TRACK/TUNING buttons (K<< or >>I) to manually tune to a station.
- Press and hold the TRACK/TUNING buttons for automatic scanning to the next available station.
- Adjust the volume using the VOLUME + or VOLUME - buttons.
Bluetooth Pairing and Playback:
- Press the BLUETOOTH button to enter Bluetooth pairing mode. The Bluetooth indicator will flash.
- On your mobile device, enable Bluetooth and search for "Amazon Basics". Select it to pair.
- Once paired, the Bluetooth indicator will glow steadily. You can now stream audio from your device.
- Use the PLAY/PAUSE button to control playback. Use TRACK/TUNING buttons to skip tracks.
- Adjust the volume using the VOLUME + or VOLUME - buttons.
USB Charging Port:
The USB port on the back of the unit is for charging external devices only. Connect your device's USB charging cable to this port. The clock does not require the USB port for its own operation.
Adjusting Display Brightness:
Press the DISPLAY BRIGHTNESS button repeatedly to cycle through different brightness levels (High, Medium, Low, Off).
Maintenance
- Clean the unit with a soft, dry cloth. Do not use liquid cleaners or abrasive materials.
- Keep the unit away from direct sunlight, heat sources, and excessive moisture.
- If the unit will not be used for an extended period, remove the backup batteries to prevent leakage.
Troubleshooting
| Problem | Possible Cause / Solution |
|---|---|
| Unit does not power on. | Ensure the AC adapter is securely plugged into both the unit and a working wall outlet. |
| Time/Alarm settings are lost. | This can occur if the Bluetooth button is pressed without an active Bluetooth connection. Re-enter your settings. Ensure backup batteries are installed and functional. |
| Cannot pair Bluetooth device. | Ensure the clock is in Bluetooth pairing mode (flashing indicator). Make sure your device's Bluetooth is on and within range. Try restarting both devices. |
| Poor FM radio reception. | Extend the FM antenna wire fully. Reposition the unit for better reception. |
| Clicking noise during Bluetooth playback. | This may indicate interference. Try moving the clock or the paired device to a different location. Ensure no other devices are interfering with the Bluetooth signal. |
Specifications
- Model Number: AB345
- Brand: Amazon Basics
- Display Type: Digital LED (Red)
- Power Source: Corded Electric (AC Adapter included)
- Battery Backup: 2 x AAA batteries (not included)
- Connectivity: FM Radio, Bluetooth
- Charging Port: USB (for external devices)
- Dimensions (LxWxH): Approximately 8.3 x 3 x 3 inches (20.98 x 7.49 x 7.80 cm)
- Weight: Approximately 1 Pound
- Material: Plastic
Product dimensions overview.
Warranty and Support
For warranty information and customer support, please refer to the documentation included with your purchase or visit the official Amazon Basics support page on Amazon.com.