1. Product Overview
The FABER Floor Cleaner is a pH neutral concentrated detergent designed for the daily cleaning and routine maintenance of all types of floors and surfaces, particularly those with low or non-existent absorption. This product is suitable for both indoor and outdoor use.
Unlike many cleaning detergents, FABER Floor Cleaner contains no wax or chemical agents that can leave residues, streaks, or cause opaqueness over time. It ensures a high level of surface cleaning, leaving a fresh, pleasant fragrance without any residue buildup.
Key Features:
- PH Neutral Formula: Safe for a wide range of surfaces.
- Concentrated: Economical and effective with proper dilution.
- No Residue: Leaves no film, streaks, or dullness.
- No Rinsing Required: Simplifies the cleaning process.
- Fresh Scent: Leaves a pleasant aroma after cleaning.
- Versatile: Suitable for klinker, ceramic, natural and polished porcelain, quartz, granite, marble, and travertine.
2. Setup and Preparation
Before applying the FABER Floor Cleaner, ensure the surface is free of loose debris by sweeping or vacuuming. Prepare the cleaning solution according to the dilution instructions below.
Dilution Instructions:
The product is highly concentrated and must be diluted with water before use. The recommended dilution ratio is 2 to 3 capfuls of detergent per 5 liters (approximately 1.3 gallons) of water. Adjust the amount based on the level of dirt and the surface type.
- For light daily cleaning: Use 2 capfuls per 5 liters of water.
- For heavier cleaning or stubborn dirt: Use 3 capfuls per 5 liters of water.
Mix the solution thoroughly in a bucket or cleaning reservoir.
3. Operating Instructions
Once the cleaning solution is prepared, proceed with cleaning using traditional methods.
Application:
- Dip a mop, cloth, or sponge into the diluted cleaning solution.
- Wring out excess liquid to prevent oversaturation of the surface.
- Wash the surface as desired, ensuring even coverage.
No Rinsing Required:
A key benefit of FABER Floor Cleaner is that it does not require rinsing when used at the correct concentration. Simply wash the surface and allow it to dry naturally. The product will not leave any patina or residues.
Drying:
For best results, allow the cleaned surface to air dry completely. This process ensures that the product works effectively without leaving any marks and protects grout widths.
4. Maintenance
Regular use of FABER Floor Cleaner helps maintain the cleanliness and appearance of your floors without causing buildup or damage.
Residue-Free Cleaning:
The advanced formula ensures that no wax or chemical agents are left behind, preventing the accumulation of dulling residues that can trap dirt and diminish the floor's original shine. This characteristic makes it ideal for consistent daily cleaning.
Protecting Grout:
The neutral pH and residue-free nature of the cleaner also help protect grout lines, preventing discoloration and buildup that can occur with other detergents.
5. Troubleshooting
If you encounter issues during cleaning, consider the following:
- Streaks or Dullness: Ensure the correct dilution ratio is used. Over-concentrating the solution can sometimes lead to minor streaking, though this product is designed to be residue-free. Allow the surface to dry completely.
- Ineffective Cleaning: For very heavy or old dirt, a slightly higher concentration (up to 3 capfuls per 5 liters) may be necessary. Ensure the surface is thoroughly swept or vacuumed before wet cleaning.
- Unusual Odor: The product has a fresh scent. If an unusual or unpleasant odor is detected, ensure proper ventilation and check the product's expiration date.
For persistent issues, contact FABER customer support.
6. Specifications
| Feature | Detail |
|---|---|
| Product Name | FABER Tile Floor Cleaner |
| Model Number | Floor Cleaner 1 LT |
| Item Volume | 1 Liter (approximately 33.8 Fluid Ounces) |
| Item Form | Liquid |
| Scent | Fresh |
| Special Features | Concentrated, Neutral pH, No Rinsing, No Residue |
| Specific Uses | Tile, Floor, Shower |
| Surface Recommendation | Klinker, Ceramic, Natural & Polished Porcelain, Quartz, Granite, Marble, Travertine, all compact and low absorbent materials |
| Coverage | Approximately 10,760 square feet per 1 Liter (when diluted) |
| Product Dimensions | 2 x 2 x 10.5 inches |
| Weight | 2.38 pounds |
| Manufacturer | FABER |
7. Safety Information
Legal Disclaimer: Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition. This product is a cleaning agent and should not be ingested or used for purposes other than its intended use.
General Safety Precautions:
- Keep out of reach of children and pets.
- Avoid contact with eyes. In case of contact, rinse immediately with plenty of water and seek medical advice if irritation persists.
- Do not mix with other cleaning products, especially those containing bleach or acids, as this may produce hazardous fumes.
- Use in a well-ventilated area.
- Store in a cool, dry place, away from direct sunlight.
8. Warranty and Support
FABER has been a leader in professional chemicals for surface treatment since 1986, with over 30 years of Italian experience and success. The company is trusted by professionals and architects worldwide for quality and excellence.
For product support, technical assistance, or inquiries, please refer to the contact information provided on the product packaging or visit the official FABER website. Ensure to provide your product model number (Floor Cleaner 1 LT) and batch details when contacting support.