1. Introduction
This manual provides comprehensive instructions for the Thomson Universal Remote Control, model ROC1128LG, designed specifically for LG televisions. This remote is a direct replacement, pre-programmed for common LG models, and offers a learning function for additional customization. It aims to provide all essential functions of your original LG TV remote control.
2. Safety Information
- Do not expose the remote control to direct sunlight, heat, or moisture.
- Avoid dropping or subjecting the remote to strong impacts.
- Keep batteries out of reach of children. If swallowed, seek immediate medical attention.
- Dispose of used batteries according to local regulations. Do not dispose of batteries in fire.
- Clean the remote with a soft, dry cloth. Do not use abrasive cleaners or solvents.
3. Package Contents
Please check the package for the following items:
- 1 x Thomson Universal Remote Control (ROC1128LG)
- 2 x AAA Batteries
- 1 x Instruction Manual with Code List
4. Product Overview
Image: Front view of the Thomson Universal Remote Control for LG TVs. It features a black casing with various buttons for power, channel, volume, navigation, and smart TV functions.
The Thomson ROC1128LG remote control is designed with an intuitive layout for ease of use. Key areas include:
- Power Button: Located at the top, typically red.
- Numeric Keypad: For direct channel input.
- Volume Control: Buttons for increasing (+) and decreasing (-) volume.
- Channel Control: Buttons for changing channels up (+) and down (-).
- Navigation Pad: Central directional buttons (Up, Down, Left, Right) with an OK/Enter button in the middle.
- Smart TV/Menu Buttons: Dedicated buttons for accessing smart TV features, menus, and settings.
- Color Buttons: Red, Green, Yellow, Blue buttons for specific functions within menus or applications.
- Learning Function Buttons: Specific buttons or a sequence to activate the learning mode.
5. Setup
5.1. Battery Installation
- Locate the battery compartment on the back of the remote control.
- Slide open the battery cover.
- Insert the two AAA batteries, ensuring the correct polarity (+ and -) as indicated inside the compartment.
- Close the battery cover securely.
5.2. Initial Configuration (Pre-programmed)
The Thomson ROC1128LG remote control is pre-programmed for most common LG TV models and should work immediately after battery installation. Point the remote at your LG TV and test basic functions like Power, Volume, and Channel.
5.3. Manual Code Setup (If needed)
If the remote does not function correctly with your LG TV, you may need to manually enter a code. Refer to the included "Instruction Manual with Code List" for a comprehensive list of LG TV codes and detailed instructions on how to enter them. This process typically involves holding down a specific button on the remote and entering a 3 or 4-digit code using the numeric keypad.
6. Operating Instructions
Once configured, the remote control operates similarly to your original LG TV remote. Below are common functions:
- Power On/Off: Press the Power button.
- Volume Adjustment: Use the VOL+ to increase and VOL- to decrease volume.
- Channel Change: Use the CH+ to go to the next channel and CH- to go to the previous channel.
- Mute: Press the MUTE button to silence the TV. Press again to unmute.
- Numeric Input: Use the 0-9 buttons to directly enter channel numbers.
- Menu Navigation: Use the directional arrows (UP, DOWN, LEFT, RIGHT) to navigate menus and the OK button to confirm selections.
- Smart TV/Home: Press the dedicated HOME or SMART button to access your TV's smart features.
- Input/Source: Press the INPUT or SOURCE button to switch between connected devices (HDMI, AV, etc.).
7. Learning Function
The Thomson ROC1128LG remote control includes a learning function, allowing you to copy specific functions from your original LG TV remote control onto the Thomson remote. This is useful for functions not pre-programmed or for less common features.
7.1. Steps for Learning a Function
- Place the Thomson remote and your original LG remote on a flat surface, facing each other, with their IR emitters aligned, approximately 1-3 cm apart.
- Activate the learning mode on the Thomson remote. (Refer to the included manual for the exact button sequence, typically holding down a specific button for a few seconds until an indicator light blinks).
- Press the button on the Thomson remote that you wish to program. The indicator light will usually change to confirm it's ready to learn.
- Press and hold the corresponding button on your original LG remote. The indicator light on the Thomson remote should blink rapidly or change color to confirm successful learning.
- Repeat for any other functions you wish to learn.
- Exit the learning mode. (Again, refer to the manual for the specific exit procedure).
Note: The effectiveness of the learning function may vary depending on the original remote control's signal strength and type.
8. Maintenance
- Cleaning: Use a soft, dry, lint-free cloth to clean the remote control. Do not use liquid cleaners, sprays, or abrasive materials.
- Battery Replacement: Replace batteries when the remote's response becomes sluggish or stops working. Always replace both batteries at the same time with new AAA alkaline batteries.
- Storage: If the remote will not be used for an extended period, remove the batteries to prevent leakage and potential damage.
9. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote does not work. | Batteries are dead or incorrectly inserted. Remote is not correctly configured for your TV. Obstruction between remote and TV. | Check battery polarity and replace if necessary. Try manual code setup (Section 5.3). Ensure clear line of sight to TV's IR receiver. |
| Only some functions work. | Incorrect code selected. Specific functions require learning. | Try a different code from the provided list. Use the learning function (Section 7) for missing functions. |
| Learning function fails. | Original remote's battery low. Remotes not aligned correctly. Interference. | Ensure original remote has fresh batteries. Re-align remotes, ensuring IR emitters face each other closely. Try in a room with less ambient light. |
| Buttons are sticky or unresponsive. | Dirt or debris under buttons. | Clean the remote control (Section 8). Do not attempt to disassemble. |
10. Specifications
- Model Name: ROC1128LG
- Manufacturer: Hama
- Compatible Devices: LG Televisions
- Connectivity Technology: Infrared (IR Wireless)
- Power Source: 2 x AAA Batteries (included)
- Dimensions: Approximately 15.8 x 4.5 x 31.6 cm
- Weight: Approximately 86 g
- Maximum Range: 10 meters
- Number of Buttons: 52
- Special Feature: Universal, Learning Function
11. Warranty and Support
For warranty information and technical support, please refer to the documentation included with your purchase or visit the official Thomson website. Keep your proof of purchase for warranty claims.
For further assistance, you may contact Thomson customer support through their official channels. Details are typically available on the manufacturer's website or in the product packaging.
Online Resources:
