HARIO V60 "Fit" Gooseneck Drip Kettle User Manual

1. Introduction

This manual provides essential instructions for the safe and effective use of your HARIO V60 "Fit" Gooseneck Drip Kettle. Please read this manual thoroughly before first use and retain it for future reference.

Image 1.1: The HARIO V60 "Fit" Gooseneck Drip Kettle, Matte Black.

2. Safety Instructions

Observe the following safety precautions to prevent injury or damage to the product:

• Do not fill the kettle beyond its maximum capacity (1200ml). Overfilling can cause boiling water to overflow.
• Always use the kettle on a stable, heat-resistant surface.
• The kettle and its contents will become hot during use. Use caution when handling and always use the handle.
• Keep out of reach of children and pets.
• Do not place the kettle directly on an open flame or high-power burner that exceeds the base diameter, as this may cause the water to boil out of the spout or discolor the kettle.
• Ensure the lid is securely placed during heating to prevent steam burns.
• This kettle is not dishwasher safe. Refer to the cleaning instructions.

3. Setup

1. Unpacking: Carefully remove the kettle from its packaging. Inspect for any damage.
2. Initial Cleaning: Before first use, wash the kettle interior with warm water and a mild detergent. Rinse thoroughly to remove any manufacturing residues.
3. First Boil: Fill the kettle with clean water to the maximum fill line. Bring the water to a boil, then discard it. Repeat this process once more to ensure cleanliness.

4. Operating Instructions

4.1 Heating Water

1. Fill the kettle with the desired amount of fresh, clean water. Do not exceed the 1200ml capacity.
2. Place the lid securely on the kettle.
3. Place the kettle on a suitable heat source (e.g., gas stove, electric coil, induction cooktop).
4. Heat the water to your desired temperature. Monitor the kettle to prevent over-boiling, especially on high heat settings.

4.2 Pouring for Drip Coffee

The V60 "Fit" kettle is designed for precise pouring, ideal for pour-over coffee methods.

Image 4.1: Precise pouring with the gooseneck spout.

• Grip the handle firmly. The handle design provides an ergonomic fit for controlled pouring.
• Tilt the kettle slowly to initiate a steady, controlled stream of water from the gooseneck spout.
• Adjust the tilt to control the flow rate as needed for your brewing method.

Image 4.2: Overhead view demonstrating controlled pour.

5. Maintenance

5.1 Cleaning

• After each use, allow the kettle to cool completely.
• Wash the interior and exterior with warm water and a mild, non-abrasive dish soap.
• Use a soft sponge or cloth to prevent scratching the matte black finish.
• Rinse thoroughly and dry immediately with a soft cloth to prevent water spots and maintain the kettle's condition.
• The kettle is not dishwasher safe. Hand washing is required.

5.2 Descaling

Over time, mineral deposits (limescale) may accumulate inside the kettle, especially in hard water areas. To descale:

1. Fill the kettle with a solution of equal parts white vinegar and water.
2. Bring the solution to a boil and let it simmer for 5-10 minutes.
3. Turn off the heat and let the solution sit in the kettle for at least 30 minutes, or longer for heavy buildup.
4. Discard the solution, then rinse the kettle thoroughly several times with fresh water.
5. Boil fresh water in the kettle once or twice and discard to remove any residual vinegar taste.

6. Troubleshooting

• Water boiling out of spout: This can occur if the kettle is overfilled or heated on a very high-power burner. Reduce water volume or lower the heat setting. Ensure the burner size matches or is smaller than the kettle's base.
• Kettle discolors: Extremely high heat can cause discoloration. Use appropriate heat settings and ensure the flame does not extend beyond the kettle's base.
• Lid rattles during boiling: This is a minor characteristic and generally does not affect performance. Ensure the lid is properly seated.
• Slow pouring: Ensure the spout is clear of any blockages. Regular descaling can prevent mineral buildup that might restrict flow.

7. Specifications

Image 7.1: Product dimensions.

8. Warranty and Support

Information regarding product warranty and customer support was not available in the provided product data. Please refer to the manufacturer's official website or your point of purchase for details on warranty coverage and support options.

For additional information or inquiries, you may visit the HARIO Store on Amazon.