1. Introduction
This manual provides detailed instructions for the proper setup, operation, and maintenance of your Sharp GA219SA OEM TV Remote Control. This remote is designed to operate various Sharp television models, as well as compatible CATV, VCR, and DVD devices. Please read this manual thoroughly before use to ensure optimal performance and longevity of your remote control.
The Sharp GA219SA remote control is an original equipment manufacturer (OEM) product, ensuring full compatibility and functionality with the specified Sharp models. It is also a feature-compatible substitute for several other Sharp and Admiral remote models.
2. Setup
2.1 Battery Installation
The Sharp GA219SA remote control requires two (2) AA batteries for operation. Follow these steps to install the batteries:
- Locate the battery compartment cover on the back of the remote control.
- Press down on the tab and slide the cover off.
- Insert two new AA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Slide the battery compartment cover back into place until it clicks securely.
Note: Always replace both batteries at the same time. Do not mix old and new batteries, or different types of batteries. Remove batteries if the remote will not be used for an extended period to prevent leakage.
3. Operating Instructions
The Sharp GA219SA remote control features a comprehensive layout for controlling various functions of your television and connected devices. Refer to the image below for button identification.
Figure 1: Sharp GA219SA OEM TV Remote Control. This image displays the full layout of the remote, including power, device selection, number pad, channel, volume, menu, mute, and playback control buttons.
3.1 Device Selection
To control a specific device, press the corresponding button at the top of the remote:
- TV: Selects the television for control.
- CATV: Selects the cable television box for control.
- DVD: Selects the DVD player for control.
- VCR: Selects the VCR for control.
3.2 Basic Functions
- POWER: Turns the selected device on or off.
- DISPLAY: Shows on-screen information (e.g., channel number, time).
- INPUT: Cycles through available input sources on the TV.
- Number Pad (0-9): Enters channel numbers or menu selections.
- ENTER: Confirms a selection.
- 100: Used for entering three-digit channel numbers (e.g., for channel 101, press 100, then 0, then 1).
- FLASHBACK: Returns to the previously viewed channel.
3.3 Channel and Volume Control
- VOL (+/-): Increases or decreases the volume.
- CH (up/down arrows): Changes the channel up or down.
- MUTE: Silences the audio.
3.4 Menu and Navigation
- MENU: Accesses the on-screen menu of the selected device.
- Directional Arrows (up/down/left/right): Navigates through menu options.
- CH (center button): Often acts as an 'Enter' or 'Select' button within menus.
3.5 Playback Controls (for VCR/DVD)
- PLAY: Starts playback.
- STOP: Stops playback.
- PAUSE: Pauses playback.
- REV (Rewind): Rewinds the media.
- FWD (Fast Forward): Fast forwards the media.
- REC (Record): Initiates recording (VCR only, if supported).
- SKIP (left/right arrows): Skips tracks or chapters.
3.6 Personal Preference Buttons
- A, B, C, D: These buttons may have specific functions depending on the connected device and its menu system. Refer to your device's manual for their specific uses.
4. Maintenance
4.1 Cleaning
To clean the remote control, use a soft, dry cloth. For stubborn dirt, lightly dampen the cloth with water or a mild, non-abrasive cleaner. Do not use harsh chemicals or immerse the remote in water.
4.2 Battery Replacement
Replace batteries when the remote's response becomes sluggish or stops working. Always use new AA batteries and dispose of old batteries according to local regulations.
4.3 Storage
Store the remote control in a dry place, away from extreme temperatures and direct sunlight. If storing for an extended period, remove the batteries to prevent potential leakage and damage.
5. Troubleshooting
If you experience issues with your remote control, try the following troubleshooting steps:
- Remote not responding:
- Check if the batteries are inserted correctly with the correct polarity.
- Replace the batteries with new ones.
- Ensure there is a clear line of sight between the remote control and the device's infrared sensor. Obstructions can block the signal.
- Make sure you have selected the correct device (TV, CATV, DVD, VCR) using the device selection buttons.
- Buttons are sticky or unresponsive:
- Clean the remote control as described in the Maintenance section.
- If the issue persists after cleaning and battery replacement, the remote may require replacement.
6. Specifications
- Model: GA219SA
- Part Number: RRMCGA219WJSA
- Brand: Sharp
- Connectivity Technology: Infrared (IR)
- Controller Type: Button Control
- Compatible Devices: Television, CATV, VCR, DVD (specific Sharp models and feature-compatible substitutes)
- Batteries: 2 x AA (not included)
- Special Feature: Ergonomic design
6.1 Compatible Sharp TV Models (OEM Supplied)
- 27F640
- 27F641
- 32F640
- 32F641
6.2 Feature-Compatible Substitute Models
The GA219SA remote is a feature-compatible substitute for the following models and their associated devices:
- RRMCGA317WJSA GA317SA: Sharp 20F650
- RRMCGA447WJSA GA447SA: Sharp 27SF560, 27SF56B, 32SF560, 32SF56B
- G1325SA RRMCG1325CESA: Sharp 25J-M180, 25J-S200, 27J-S180, 27J-S200, CJ27S18, CJ27S20
- RRMCG1626CESB G1626SB: Sharp 27R-FS1, CR27FS1
- RRMCGA035WJSB GA035SB: Sharp 20F540, 20U-FS1, 25C340, 27C530, 27C540, 27F540, 27F541, 27F543, 27F543E, 27U-F500, 27U-F510, 27U-S650, 32C530, 32C540, 32F540, 32F543, 32U-F500, 32U-F510, 32U-F6, 32U-S650, 35UF6, 36C530, 36U-F500, 36U-F510, 36U-F6, 36U-S650, CU20FS1
- RRMCGA292WJSB GA292SB: Sharp 20F550
- Supports all features for: ADMIRAL JSJ-12778, 9HSREMT21SH001 GA336SA, Sharp LC-13AV1, LC-13AV1U, LC-13AV4, LC-13AV4U, LC-13SH1, LC-13SH1U, LC-13SH1U-D, LC-13SH1U-R, LC-15AV1U, LC-15AV4U, LC-15SH1, LC-15SH1U, LC-15SH1U-D, LC-15SH1U-R, LC-20AV1, LC-20AV1U, LC-20AV4, LC-20AV4U, LC-20DV50, LC-20SH1, LC-20SH1U, LC-20SH1U-D, LC-20SH1U-R
- RRMCGA257WJSB GA257WJSB GA257SB: Sharp 14VR70M, 21LFG1L, 21MFG1L, 21RV70M, 21VFR95S
7. Warranty and Support
As an OEM product, the Sharp GA219SA remote control is designed for reliability and compatibility with its intended devices. For specific warranty information, please refer to the documentation provided with your original Sharp television or contact Sharp customer support directly. For technical assistance or inquiries regarding this remote control, please consult the manufacturer of your Sharp television or the vendor from whom the remote was purchased.
