Skyflame 24" Round Fire Pit Glass Wind Guard Instruction Manual

1. Product Overview

The Skyflame 24" Round Fire Pit Glass Wind Guard is designed to enhance the safety and aesthetics of your outdoor fire pit. Made from durable tempered glass with polished edges, it helps maintain a steady flame by shielding it from wind, while also providing a protective barrier.

Image 1.1: The Skyflame 24" Round Fire Pit Glass Wind Guard installed on an outdoor fire pit.

Image 1.2: Dimensions of the 24" Round Fire Pit Glass Wind Guard.

Key Features:

• 24-inch round design, suitable for approximately 19-inch fire pits.
• Constructed from heat-resistant tempered glass with polished edges for safety.
• Effectively guards flames from wind, promoting a more stable burn.
• Provides an additional safety barrier, protecting against accidental contact with hot fire glass or lava rocks.
• Designed for easy installation, disassembly, and cleaning.

2. Package Contents

Verify that all components are present and undamaged before proceeding with assembly.

Image 2.1: All components included in the package.

• Tempered Glass Panels (x4)
• Bottom Brackets (x4)
• Upper Brackets (x4)
• Rubber Feet (pre-attached to bottom brackets)
• Screws and Allen Wrench (for assembly)

3. Setup and Installation

Follow these steps to assemble and install your Skyflame Glass Wind Guard.

1. Unpack Components: Carefully remove all glass panels and hardware from the packaging. Inspect for any damage.
2. Attach Brackets: Align the holes in the tempered glass panels with the holes in the upper and bottom brackets. Secure the glass panels to the brackets using the provided screws and Allen wrench. Ensure the rubber feet on the bottom brackets are facing downwards.

Image 3.1: Detail of corner brackets, tempered glass, rubber feet, and bottom gap.
3. Form the Circle: Connect the four glass panels to form a complete circle. Ensure all screws are tightened securely, but do not overtighten to avoid stressing the glass.
4. Placement on Fire Pit: Carefully place the assembled wind guard onto your fire pit. It is recommended to maintain a 2-3 inch clearance between the fire pit burner and the glass wind guard for optimal performance and safety.


Image 3.2: Important safety information regarding placement and clearance.

Attention: Do not place the glass wind guard directly in the fire pit. Getting too close to the flame may cause the glass to burst or melt the rubber base.

4. Operating Instructions

The wind guard helps to stabilize flames and enhance the visual appeal of your fire pit.

• Ensure the wind guard is securely placed on the fire pit with adequate clearance before igniting the flame.
• The glass panels reflect the flames, creating an enhanced visual effect.
• The bottom gap in the design ensures smooth airflow, which is crucial for proper combustion and flame stability.

Image 4.2: Visual comparison of flame behavior with and without the wind guard.

5. Maintenance

Proper maintenance will ensure the longevity and clear appearance of your glass wind guard.

• Cleaning: Use a soft cloth and a mild glass cleaner to clean the glass panels. Avoid abrasive cleaners or scouring pads that could scratch the glass.
• Inspection: Regularly inspect the glass panels for cracks or chips. If any damage is found, replace the affected panel immediately to prevent further breakage.
• Hardware: Periodically check the tightness of all screws in the brackets. Retighten if necessary, but do not overtighten.
• Storage: If storing the wind guard for an extended period, disassemble it and store the glass panels in their original packaging or a padded container to prevent damage.

6. Troubleshooting

Here are some common issues and their solutions:

7. Specifications

8. Warranty and Support

For warranty information or technical support, please contact Skyflame customer service. Refer to your purchase documentation for specific warranty terms and contact details.

You can also visit the official Skyflame store for more information: Skyflame Store