Introduction
This manual provides instructions for the setup and operation of your new replacement remote control. This remote is designed to function as a direct replacement for original JVC TV remotes, offering similar functionality without the need for complex programming.
Setup: Battery Installation
To begin using your remote control, you must first install the batteries.
- Locate the battery compartment on the back of the remote control.
- Slide the battery compartment cover downwards or press the latch and lift to remove it.
- Insert two (2) AAA batteries (not included) into the compartment. Ensure the positive (+) and negative (-) terminals of the batteries match the diagrams inside the compartment.
- Replace the battery compartment cover by sliding it back into place until it clicks securely.
Once batteries are installed, the remote is ready for use. No programming or pairing is required.
Operating Instructions
This replacement remote control operates identically to your original JVC TV remote. Simply point the remote control directly at your television and press the desired function buttons.
- Power Button: Turns the TV on or off.
- Channel Buttons: Changes the TV channel up or down.
- Volume Buttons: Adjusts the TV volume up or down.
- Number Buttons: Directly input channel numbers.
- Menu/Navigation Buttons: Access and navigate the TV's on-screen menu.
Compatible JVC TV Models
This remote control is compatible with the following JVC TV models:
- JLC32BC3000
- JLC32BC3002
- JLC37BC3000
- JLC37BC3002
- JLC42BC3000
- JLC42BC3002
- JLC47BC3000
- JLC47BC3002
- JLE32BC3001
- JLE37BC3001
- JLE42BC3500
- JLE47BC3001
- JLE47BC3500
- BC50R
- EM28T
- EM32FL
- EM32T
- EM32TS
- EM37T
- EM39FT
- EM39T
- EM55FT
Troubleshooting
If your remote control is not functioning as expected, please try the following steps:
- Check Batteries: Ensure that the batteries are inserted correctly with the correct polarity (+/-) and are not depleted. Replace with fresh AAA batteries if necessary.
- Line of Sight: Make sure there is a clear line of sight between the remote control and the TV's infrared sensor. Obstructions can block the signal.
- Remote Sensor: Confirm that the TV's remote sensor is not blocked or dirty.
- TV Compatibility: Double-check that your TV model is listed in the "Compatible JVC TV Models" section of this manual.
If the issue persists after performing these checks, the remote control may be faulty. Please refer to the Warranty and Support section for further assistance.
Specifications
| Brand | unbrand |
| Model Name | JLC47BC3002/JLE47BC3001 |
| Model Number | JLC47BC3002/JLE47BC3001-602914541046 |
| Color | Black |
| Compatible Devices | Television |
| Connectivity Technology | Infrared |
| Controller Type | Button Control |
| Battery Type | AAA (2x 1.5V) |
| Special Feature | Ergonomic |
Maintenance
To ensure the longevity and proper functioning of your remote control:
- Keep the remote clean by wiping it with a soft, dry cloth.
- Avoid exposing the remote to extreme temperatures, direct sunlight, or moisture.
- If the remote will not be used for an extended period, remove the batteries to prevent leakage.
Warranty and Support
Specific warranty information for this unbrand replacement remote control is not provided in the product details. For any issues, questions, or to inquire about warranty coverage, please contact the seller directly through your purchase platform.