Rust-Oleum Specialty Glitter Spray Paint Instruction Manual

Product Overview

Rust-Oleum Specialty Glitter Spray provides an intense sparkling finish suitable for various craft and decorative projects. This product is designed for interior use on multiple surfaces, including wood, metal, wicker, glass, ceramic, pottery, craft foam, and paper. It is formulated to deliver a radiant shimmer with full coverage, resisting stains and scratches.

• Intense glitter formula for a multi-dimensional effect.
• Dries to touch in 20 minutes.
• Covers up to 6 square feet per can.
• Resists stains and scratches.

Image: Rust-Oleum Specialty Glitter Spray Paint in Pearl White.

Safety Information

WARNING: This product can expose you to chemicals including Ethylbenzene, which is known to the State of California to cause cancer, and Toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. Always use in a well-ventilated area and wear appropriate personal protective equipment, including gloves and eye protection.

Preparation

1. Surface Preparation: Ensure the surface is clean, dry, and free of loose paint, rust, wax, oil, and grease. For best results, lightly sand glossy surfaces.
2. Protect Surrounding Area: Cover adjacent areas to protect from overspray.
3. Shake Can: Shake the can vigorously for one minute after the mixing ball begins to rattle. Continue to shake occasionally during use.

Application Instructions

1. Test Spray: Before applying to your project, test spray on an inconspicuous area or scrap material to ensure color and glitter distribution.
2. Hold Can Correctly: Hold the can upright 10-16 inches from the surface.
3. Apply Light Coats: Apply several thin coats rather than one heavy coat. Overlap each pass slightly. Applying too much at once can lead to drips and an uneven glitter effect.
4. Drying Between Coats: Allow 10-15 minutes between coats for optimal adhesion and glitter build-up.
5. Achieving Desired Effect: Continue applying thin coats until the desired glitter intensity and coverage are achieved.

Image: Demonstrating the application of glitter spray paint.

Video: Official Rust-Oleum guide on using Specialty Glitter Spray Paint.

Drying & Curing

The paint dries to the touch in approximately 20 minutes. For full handling and to ensure the glitter is set, allow the project to dry for at least 24 hours. Drying times may vary depending on temperature and humidity.

Cleaning & Storage

To clear the spray valve for future use, turn the can upside down and press the spray button for 5 seconds or until only clear gas comes out. Store the can in a cool, dry place away from direct sunlight and heat sources.

Specifications

Troubleshooting

Clogged Nozzle / Uneven Spray

If the nozzle clogs or the spray becomes uneven, remove the nozzle and clean it. You can soak it in mineral spirits or use a thin wire to clear any dried paint or glitter. Ensure the can is shaken thoroughly before and during use to keep the glitter particles evenly dispersed.

Glitter Flaking Off

To minimize glitter flaking, ensure that the paint is fully dry and cured. For projects that will experience frequent handling or wear, consider applying a clear topcoat or sealer specifically designed for glitter. Apply the topcoat in light, even layers to avoid dulling the glitter's sparkle.

Insufficient Coverage

Glitter spray is designed to add sparkle, not necessarily opaque color. For a more vibrant and full glitter effect, it is recommended to apply a base coat of paint in a similar or complementary color before applying the glitter spray. This will enhance the glitter's appearance and provide better coverage.

Warranty & Support

For specific warranty information or technical support, please refer to the contact details provided on the product label or visit the official Rust-Oleum website. Keep your purchase receipt for any warranty claims.