Introduction
This manual provides essential information for the safe and effective use of your LKPower AC Adapter, Model 180208033. This power supply is specifically designed to operate and charge the battery of your Autel Maxisys MS905 Mini Automotive Diagnostic Tool from standard electrical power outlets. It converts AC power from the wall outlet into the DC power required by your device.
Please read this manual thoroughly before using the product and retain it for future reference.
Important Safety Information
To ensure safe operation and prevent damage to the adapter or your device, observe the following precautions:
- Use the adapter only with compatible devices, specifically the Autel Maxisys MS905 Mini.
- Do not expose the adapter to water, moisture, or extreme temperatures.
- Avoid dropping or subjecting the adapter to strong impacts.
- Do not disassemble or attempt to repair the adapter. Refer all servicing to qualified personnel.
- Ensure the power outlet voltage matches the adapter's input specifications (100-240V AC).
- Unplug the adapter from the power outlet when not in use for extended periods.
- Keep out of reach of children.
Package Contents
- 1 x LKPower AC Adapter (Model 180208033)
Setup Instructions
-
Inspect the Adapter: Before use, visually inspect the AC adapter and its cable for any signs of damage. Do not use if damaged.
Image 1: Front and side view of the LKPower AC Adapter, showing the two-prong plug and the barrel connector cable.
-
Connect to Device: Insert the barrel connector end of the adapter cable into the power input port of your Autel Maxisys MS905 Mini Diagnostic Tool. Ensure a secure connection.
Image 2: The LKPower AC Adapter plugged into a power strip, with its cable connected to a diagnostic device.
- Plug into Power Outlet: Insert the two-prong plug of the AC adapter into a standard electrical wall outlet (100-240V AC).
Operating Instructions
Once properly connected, the LKPower AC Adapter will supply power to your Autel Maxisys MS905 Mini Diagnostic Tool. This allows you to:
- Operate the diagnostic tool directly from AC power without relying on its internal battery.
- Charge the internal battery of the diagnostic tool. The charging indicator on your diagnostic tool will typically illuminate to confirm charging status.
The adapter features built-in over voltage and over heat protection for safe and reliable operation.
Maintenance and Care
- Cleaning: Disconnect the adapter from both the power outlet and your device before cleaning. Use a soft, dry cloth to wipe the exterior. Do not use liquid cleaners or solvents.
- Storage: Store the adapter in a cool, dry place away from direct sunlight and extreme temperatures. Avoid tightly coiling the cable to prevent damage.
- Inspection: Periodically check the adapter and cable for any signs of wear or damage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device not powering on or charging. |
|
|
If the issue persists after trying these solutions, contact customer support.
Specifications
| Model Number | 180208033 |
| Brand | LKPower |
| Input | AC 100-240V, 50/60Hz, 0.3A (Worldwide AC Input) |
| Output | DC (Specific voltage not provided, designed for Autel Maxisys MS905 Mini) |
| Wattage | 12 Watts |
| Connector Type | Barrel Connector |
| Compatible Devices | Autel Maxisys MS905 Mini Automotive Diagnostic Tool |
| Special Features | Over Voltage Protection, Over Heat Protection, Travel-friendly design |
| Certifications | UL (as per product specifications) |
Image 3: Dimensions of the LKPower AC Adapter showing approximate measurements of 1.6 inches, 1.2 inches, 2.6 inches, and a cable length of 76 inches.
Warranty and Support
Specific warranty details are not provided in this manual. For warranty information, technical support, or service inquiries, please refer to the documentation included with your purchase or contact the retailer where the product was acquired.