1. Introduction
This manual provides essential information for the safe and efficient operation of your Cooler Depot G1.2 Commercial 2-Door Glass Merchandiser Refrigerator. Please read all instructions carefully before installation, operation, or maintenance to ensure proper use and to prevent injury or damage.
The Cooler Depot G1.2 is a high-quality commercial merchandiser refrigerator designed for displaying and storing various food and beverage products in commercial settings such as restaurants, cafes, bakeries, and grocery stores. It features a durable metal exterior, double-pane glass doors, and a bottom-mounted refrigeration system.
Image 1: Front view of the Cooler Depot G1.2 Commercial 2-Door Glass Merchandiser Refrigerator.
2. Safety Information
Always follow basic safety precautions when using this appliance to reduce the risk of fire, electric shock, or injury.
- Electrical Safety: Ensure the unit is connected to a properly grounded 115 Volt, 60 Hz electrical outlet. Do not use extension cords.
- Placement: Position the unit on a level, stable surface capable of supporting its weight. Allow adequate clearance for ventilation around the unit.
- Flammable Materials: Do not store explosive substances or flammable materials inside or near the refrigerator.
- Maintenance: Disconnect power before performing any cleaning or maintenance. Only qualified personnel should perform repairs.
- Children: Keep children away from the appliance.
3. Setup and Installation
3.1 Unpacking
- Carefully remove all packaging materials, including tape and protective film.
- Inspect the unit for any shipping damage. Report any damage immediately to the carrier and supplier.
- Retain the original packaging materials and pallet for potential returns or future transport.
3.2 Placement
- Place the refrigerator on a strong, level floor.
- Ensure adequate air circulation around the unit. Maintain a minimum of 4 inches (10 cm) clearance from walls and other objects for proper ventilation.
- Avoid direct sunlight or proximity to heat-generating appliances.
3.3 Leveling and Caster Installation
The unit is equipped with 4 lockable caster wheels for mobility. Ensure the unit is level to ensure proper door closure and drainage.
- If casters are not pre-installed, attach them securely to the bottom of the unit.
- Once positioned, lock the front casters to prevent movement.
- Use a level to verify the unit is perfectly level. Adjust casters as needed.
3.4 Electrical Connection
Connect the refrigerator to a dedicated 115 Volt, 60 Hz, 15 Amp grounded electrical outlet. The unit operates at 900 Watts. Refer to the NEMA 5-15P plug type.
Image 2: Diagram showing cabinet dimensions, weight, capacity, and key features of the G1.2BM2F-HC model.
3.5 Shelf Installation
The refrigerator includes 8 PVC-coated shelves. Install them at desired heights using the shelf clips provided.
Image 8: Interior view demonstrating adjustable shelves and LED lighting.
4. Operating Instructions
4.1 Initial Startup
After installation, allow the unit to stand upright for at least 2 hours before plugging it in. This allows the refrigerant to settle.
4.2 Powering On/Off
Locate the power switch on the front control panel. Flip the switch to the 'ON' position to power the unit. To turn off, flip the switch to 'OFF'.
Image 6: Close-up of the control panel, showing the power switch, light switch, and digital thermostat.
4.3 Temperature Control
The unit features a digital thermostat display and a knob for temperature adjustment. The operating temperature range is 0°C to 5°C (32°F to 41°F).
- Use the digital display to monitor the internal temperature.
- Adjust the temperature using the control knob or buttons adjacent to the display.
- Allow several hours for the unit to reach the set temperature after adjustment.
4.4 LED Lighting
The interior LED lights can be controlled via a separate switch on the control panel. This helps in keeping track of inventory.
4.5 Loading the Refrigerator
Do not block the internal air vents when loading products to ensure proper air circulation and consistent cooling.
5. Maintenance
5.1 Cleaning the Interior
- Disconnect power before cleaning.
- Remove shelves and clean them with mild soap and water.
- Wipe the interior surfaces with a soft cloth dampened with a mild, non-abrasive cleaner.
- Ensure the drain hole at the bottom of the interior is clear to prevent water accumulation.
Image 7: Close-up view of the interior fan and the drain hole at the bottom of the refrigerator.
5.2 Cleaning the Exterior and Glass Doors
- Wipe exterior surfaces with a soft cloth and mild detergent.
- Clean glass doors with a glass cleaner. Avoid abrasive cleaners that may scratch the surface.
5.3 Condenser Coil Cleaning
The bottom-mounted condenser coil is easily accessible for cleaning. Regular cleaning is crucial for efficient operation.
- Disconnect power.
- Locate the condenser coil at the bottom rear of the unit.
- Use a brush or vacuum cleaner to remove dust and debris from the coil fins.
Image 9: Rear view of the refrigerator, highlighting the bottom-mounted condenser area.
5.4 Automatic Defrost
This unit features an automatic defrost system, eliminating the need for manual defrosting. Ensure the drain system remains clear for proper water removal.
6. Troubleshooting
Before contacting service, review the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Refrigerator not cooling | No power; thermostat set too high; condenser coil dirty; door not closing properly. | Check power connection; adjust thermostat; clean condenser coil; inspect door seals. |
| Excessive noise | Unit not level; fan obstruction; loose components. | Level the unit; check for obstructions around fans; tighten any loose parts. |
| Water on floor | Drain line clogged; unit not level. | Clear drain line; level the unit. |
| Error codes on display | System malfunction. | Refer to the specific error code documentation or contact customer support. |
7. Specifications
The following table outlines the technical specifications for the Cooler Depot G1.2 Commercial 2-Door Glass Merchandiser Refrigerator:
Image 3: Circuit diagram and detailed technical parameters.
| Specification | Detail |
|---|---|
| Model | G1.2BM2F |
| Dimensions (L x D x H) | 53" x 32" x 81" (1350 x 810 x 2015 mm) |
| Capacity | 45 Cubic Feet (1270 Liters) |
| Item Weight | 440 Pounds (200 kg) |
| Voltage | 115 Volts |
| Wattage | 900 Watts (Operating), 620 Watts (Rated) |
| Refrigerant | R134a (Environmental friendly) |
| Temperature Range | 0°C to 5°C (32°F to 41°F) |
| Number of Doors | 2 (Double Pane Glass, Self-Closing) |
| Shelves | 8 PVC Coated Wire Shelves |
| Defrost System | Automatic |
| Certifications | NSF, UL |
| Compressor | Bottom-Mounted High Quality Compressor |
8. Warranty and Support
Cooler Depot provides the following warranty for this product:
- Parts Warranty: 3 years
- Compressor Warranty: 6 years
- Labor Warranty: 1 year
For functional failures within 1 month of purchase, a free return may be applicable. Please ensure you retain the original pallet and packaging materials, as they are required for any return shipments.
For technical support, warranty claims, or service inquiries, please contact Cooler Depot customer service. Contact information can typically be found on the manufacturer's website or your purchase documentation.
