1. Introduction
Thank you for choosing the TROTEC IRD 1200 Radiant Heater. This manual provides essential information for the safe and efficient operation, installation, and maintenance of your device. Please read these instructions carefully before initial use and keep them for future reference.
Image 1.1: Front view of the TROTEC IRD 1200 Radiant Heater. This heater features a sleek black and silver design with a digital display on the right side.
2. Important Safety Instructions
Always observe all safety warnings and instructions provided with the device. Failure to do so may result in electric shock, fire, or serious injury.
- This appliance is intended for heating purposes only.
- Do not use the appliance in potentially explosive atmospheres or near flammable materials.
- Ensure the power supply voltage matches the rating on the appliance's label.
- Do not immerse the appliance in water or other liquids.
- Keep children and unauthorized persons away from the appliance.
- Do not cover the heater during operation. Maintain adequate clearance from combustible materials.
- The appliance is rated IP55, providing protection against dust and water jets. However, avoid direct exposure to heavy rain or prolonged water spray.
- Always disconnect the power supply before cleaning or maintenance.
Image 2.1: TÜV Rheinland and GS Certified logos, indicating product safety and quality compliance.
3. Package Contents
Verify that all components are present and undamaged upon unpacking:
- TROTEC IRD 1200 Radiant Heater
- Mounting brackets and fixing kit
- Remote control
- User Manual (this document)
4. Setup and Installation
4.1 Mounting Location
The IRD 1200 can be mounted on a wall or ceiling. Choose a location that allows for optimal heat distribution and is protected from direct wind if used outdoors. Ensure sufficient clearance from ceilings, walls, and other objects as specified in the safety instructions.
4.2 Mounting Procedure
- Mark the drilling points for the mounting brackets on the desired wall or ceiling surface.
- Drill the holes and insert appropriate wall plugs (if necessary).
- Attach the mounting brackets securely using the provided screws.
- Mount the heater onto the brackets. Ensure it is firmly seated.
- Adjust the angle of the heater using the pivoting mechanism on the brackets for targeted heating. The heater can be rotated up to 90 degrees.
Image 4.1: Close-up view of the adjustable mounting brackets for wall or ceiling installation.
Image 4.2: Diagram illustrating the 90-degree rotational adjustment feature of the heater for targeted heat.
4.3 Electrical Connection
Connect the heater to a suitable grounded power outlet. Ensure the electrical circuit can handle the 1200W power consumption of the device.
Image 4.3: The TROTEC IRD 1200 heater installed on a patio wall, demonstrating a typical outdoor application.
5. Operating Instructions
5.1 Powering On/Off
To turn the heater on, press the power button on the side of the unit or on the remote control. Press it again to turn off. An indicator light will confirm operation.
5.2 Adjusting Heat Levels
The IRD 1200 features 3 heating levels. Use the '+' and '-' buttons on the remote control to cycle through the available heat settings. The current setting will be displayed on the LED screen.
5.3 24-Hour Timer
The integrated 24-hour timer allows you to set a specific operating duration. Refer to the remote control instructions for detailed timer programming.
Image 5.1: Close-up of the heater's side panel, showing the power switch and the LED display indicating the current setting.
6. Maintenance
6.1 Cleaning
Before cleaning, always disconnect the heater from the power supply and allow it to cool down completely. Use a soft, damp cloth to wipe the exterior surfaces. Do not use abrasive cleaners or solvents. Ensure no water enters the internal components.
6.2 Storage
If the heater will not be used for an extended period, clean it thoroughly and store it in a dry, dust-free environment, preferably in its original packaging.
7. Troubleshooting
If you encounter issues with your TROTEC IRD 1200, refer to the following table:
| Problem | Possible Cause | Solution |
|---|---|---|
| Heater does not turn on | No power supply Power switch off Remote control battery flat | Check power connection and outlet Ensure power switch is on Replace remote control battery |
| No heat output | Incorrect heat setting Overheating protection activated | Increase heat level Turn off, unplug, allow to cool, then restart |
| Remote control not working | Battery flat Obstruction between remote and heater | Replace battery Ensure clear line of sight |
If the problem persists after attempting these solutions, please contact customer support.
8. Specifications
Technical data for the TROTEC IRD 1200 Radiant Heater:
| Feature | Specification |
|---|---|
| Brand | TROTEC |
| Model Number | IRD 1200 |
| Power Output | 1200 W |
| Heating Levels | 3 |
| Dimensions (L x W x H) | 93 x 5.5 x 20 cm |
| Weight | 9.14 kg |
| Protection Class | IP55 (Dust and water jet protected) |
| Power Source | Electric Corded |
| Special Features | Silent operation, LED display, 24-hour timer, Remote control, Pivoting function |
| Mounting Type | Wall Mount, Ceiling Mount |
| Recommended Use | Indoor, Wind-protected outdoor areas (e.g., patios, balconies) |
9. Warranty and Support
For warranty information, please refer to the documentation provided at the time of purchase or contact your retailer. For technical support or spare parts inquiries, please contact TROTEC customer service directly.
10. Disposal
Do not dispose of this appliance with household waste. Please dispose of it in accordance with local regulations for electrical and electronic equipment. Information on collection points can be obtained from your local authorities.
