Introduction
This manual provides detailed instructions for the proper use and maintenance of your SportDOG SportTrainer SD-875E Remote Trainer. This system is designed to assist in dog training by providing consistent communication through tone, vibration, and static stimulation. Please read this manual thoroughly before operating the device to ensure safe and effective use.
Image: The SportDOG SportTrainer SD-875E Remote Trainer, including the handheld remote and collar receiver, shown in its retail packaging.
Setup
1. Charging the System
The SportTrainer SD-875E system utilizes quick-charge lithium-ion batteries. Before first use, fully charge both the Remote Transmitter and the Collar Receiver. A full charge typically takes approximately 2 hours.
- Connect the charging adapter to the charging ports on both the remote and collar.
- The charging indicator lights will show the charging status. Refer to the device's display for battery life.
2. Fitting the Collar Receiver
Proper fit of the Collar Receiver is crucial for effective and humane operation. The collar should be snug, allowing the contact points to make consistent contact with your dog's skin without causing discomfort.
Image: A dog wearing the training collar. The image demonstrates that the collar should fit snugly, with only one finger able to slide under the strap, and the probes should not rub the dog's skin.
- Position the Collar Receiver on your dog's neck, ensuring the contact points are beneath the neck.
- The collar should be centered, and the contact points should touch the skin.
- Check the fit by attempting to slide one finger under the strap. If more than one finger fits, the collar is too loose. If no fingers fit, it is too tight.
- Recheck the fit after several minutes of wear to ensure it remains secure and comfortable.
3. Powering On/Off
To power on the Collar Receiver, press and hold the power button until the indicator light illuminates. To power off, press and hold the power button until the indicator light turns off. The Remote Transmitter typically remains in a standby mode and does not have a dedicated power-off button, conserving battery life automatically.
Operating the System
1. Remote Transmitter Overview
The Remote Transmitter features an intuitive OLED screen and dedicated buttons for various functions.
Image: A detailed diagram of the SportTrainer 875 Remote Transmitter, highlighting the OLED screen, tone button, continuous static stimulation button, momentary static stimulation button, dog selection buttons (1-3), and intensity increase/decrease buttons.
- OLED Screen: Displays static stimulation level, selected dog, battery status, and button configuration. This screen is designed for clarity in various lighting conditions.
- Tone Button: Activates an audible tone from the collar.
- Vibration Button: Activates a vibration from the collar.
- Static Stimulation Buttons: Separate buttons for Momentary (quick pulse) and Continuous (up to 8 seconds) static stimulation.
- Intensity Buttons (+/-): Adjusts the level of static stimulation (1-10).
- Dog Select Buttons: Allows selection of which dog's collar to control (supports up to 3 dogs with additional collars).
Image: The Remote Trainer's OLED screen displaying clear information, with a dog in the background, emphasizing screen readability during use.
2. Collar Receiver Functions
The Collar Receiver delivers the selected stimulation to your dog.
Image: A detailed diagram of the SportTrainer 875 Collar Receiver, indicating its 1/2 mile range, suitability for dogs 8 lbs or larger, three types of stimulation (static, vibe, tone), and power on/off button.
- Stimulation Types: The collar provides tone, vibration, and 10 levels of static stimulation.
- Range: The system offers a 1/2 mile range for off-leash control.
- Waterproof Design: The collar receiver is built with DryTek waterproof technology, submersible up to 25 feet, making it suitable for various outdoor conditions.
Image: A dog running through water, carrying a retrieve dummy, highlighting the DryTek waterproof and submersible (up to 25ft) capabilities of the collar.
3. Multi-Dog Training
The SportTrainer SD-875E system can be expanded to train up to three dogs simultaneously with the purchase of additional Add-A-Dog® Collars. The Remote Transmitter allows you to select which dog's collar you are controlling using the dedicated dog selection buttons.
Maintenance
1. Cleaning
Regular cleaning of the Collar Receiver is recommended, especially after use in wet or dirty conditions. Clean with water and a mild soap as needed. Ensure all components are dry before charging or storing.
2. Battery Care
To maximize battery life, fully charge the Remote Transmitter and Collar Receiver when the battery indicator shows low power. Avoid prolonged storage of the device with a completely depleted battery. The system is designed for hours of runtime on a single charge.
3. Contact Point Inspection
Periodically inspect the contact points on the Collar Receiver for any signs of wear or corrosion. Ensure they are clean and free of debris to maintain effective contact with your dog's skin.
Troubleshooting
- Collar Receiver Not Responding: Ensure the collar is powered on and fully charged. Verify that the Remote Transmitter is also charged and within range. Check if the collar is properly paired with the remote.
- No Stimulation/Tone/Vibration: Confirm the collar is fitted correctly and the contact points are making proper skin contact. Increase the stimulation level on the remote. Test the function in a controlled environment.
- Charging Issues: Ensure the charging adapter is securely connected to both the device and a working power outlet. Check the charging ports for any debris. If the issue persists, contact customer support.
- Inconsistent Range: Environmental factors such as terrain, weather, and electromagnetic interference can affect range. Ensure a clear line of sight between the remote and collar when possible.
Specifications
| Feature | Detail |
|---|---|
| Model Name | SD-875E |
| Brand | SportDOG |
| Item Weight | 0.97 Pounds (15.5 ounces) |
| Item Dimensions (LxWxH) | 2.15 x 7.25 x 1.25 inches |
| Batteries | 2 Lithium Ion batteries (included) |
| Range | 1/2 Mile |
| Waterproof Rating | DryTek, Submersible up to 25 feet |
| Stimulation Types | Tone, Vibration, 10 Levels of Static (Momentary & Continuous) |
| Target Audience | Dogs (8 lbs and up, neck sizes 5" to 22") |
| Manufacturer | Radio Systems Corporation |
| Date First Available | November 27, 2017 |
Warranty Information
The SportDOG SportTrainer SD-875E Remote Trainer comes with a 3 Year Warranty. For specific terms, conditions, and to register your product, please refer to the official SportDOG website or contact customer support.
Support and Resources
For additional assistance, training tips, or to access the full user guide in PDF format, please visit the official SportDOG website. SportDOG offers U.S.-based customer care for product support.
- Official User Guide (PDF): Download Here
- Customer Care: Refer to the SportDOG official website for contact information.
Note: No official product videos from the seller were available in the provided data for embedding in this manual.
