Introduction
This manual provides essential information for the safe installation, operation, and maintenance of your Good Housekeeping Athens Model 80213 decorative bathroom ventilation exhaust fan. This unit is designed to provide superior air movement to remove excess moisture and odors from your bathroom, featuring quiet operation and integrated LED lighting. Please read all instructions carefully before beginning installation or use.
Image: Good Housekeeping Athens 80 CFM Decorative Bathroom Ventilation Fan with LED Light, showcasing its brushed nickel finish and white glass shade.
Safety Information
WARNING: To reduce the risk of fire, electric shock, or injury to persons, observe the following:
- Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes.
- Always disconnect power at the service panel before servicing or cleaning the unit.
- This unit must be properly grounded.
- Do not use this fan with any solid-state speed control device unless specifically approved for use with this unit.
- Ensure the power source is 120 Volts, AC, 60 Hz.
- The unit is ETL listed and requires a GFCI circuit for safe operation in damp locations.
- Never place any object into the fan or light assembly.
Package Contents
Verify that all components are present before beginning installation:
- Motor with Housing (All-Metal)
- Light Kit with Glass Shade
- Installation Hardware
- 2x 9.5W LED Bulbs (E26 base)
Setup and Installation
The Good Housekeeping Athens fan is designed for flush mount installation and is ready for new construction or room-side installation. Professional installation is recommended for all electrical wiring to ensure compliance with local codes and safety standards.
Pre-Installation Steps:
- Turn off Power: Disconnect power at the circuit breaker or fuse box before starting any work.
- Prepare Opening: Ensure the ceiling opening is appropriately sized for the fan housing. Refer to the product dimensions for precise measurements. The product dimensions are approximately 13.26 x 13.26 x 11.61 inches.
- Ducting: Connect appropriate ductwork to the fan's exhaust port. Ensure duct runs are as straight and short as possible for optimal performance.
Mounting the Housing:
Utilize the provided installation hardware to securely mount the all-metal housing between ceiling joists or to a suitable support structure. The unit is designed for flush mounting.
Image: Diagram showing the dimensions of the Good Housekeeping Athens fan, including 11.61" height, 13.27" width, and 14.57" diagonal measurement.
Electrical Connection:
- Connect the fan's wiring to the household electrical supply according to the wiring diagram provided in the full installation guide (not included here, refer to manufacturer's detailed instructions).
- Ensure all connections are secure and insulated.
- Confirm the fan is connected to a GFCI protected circuit.
Installing Light Kit and Grille:
- Install the two 9.5W LED bulbs into the light kit.
- Attach the light kit with the white glass shade to the fan housing.
- Secure the decorative grille to complete the installation.
Image: Exploded view illustrating the main components of a bath fan, including the housing, motor, and light assembly, useful for understanding installation steps.
Operating Instructions
The Good Housekeeping Athens fan and light operate independently or together via standard wall switches. The unit features a 'Touch' switch style, indicating it is compatible with modern wall switches.
- Fan Operation: Flip the designated wall switch to activate the ventilation fan. The fan will begin to move air at 80 CFM, effectively removing moisture and odors.
- Light Operation: Flip the designated wall switch to turn on the integrated LED light. The two 9.5W LED bulbs provide 1600 lumens of illumination.
- Combined Operation: If wired to a single switch, both the fan and light will activate simultaneously.
For optimal moisture removal, allow the fan to run for at least 15-20 minutes after showering or bathing.
Maintenance
Regular maintenance ensures optimal performance and longevity of your ventilation fan.
Cleaning the Grille and Light Shade:
- Disconnect Power: Always turn off power at the circuit breaker before cleaning.
- Remove Grille: Gently pull down the grille and light shade assembly to detach it from the housing.
- Clean Surfaces: Wipe the grille and glass shade with a soft, damp cloth. A mild, non-abrasive cleaner can be used if necessary. Do not use harsh chemicals or abrasive pads.
- Dry and Reinstall: Ensure all parts are completely dry before reattaching the grille and light shade.
Motor and Fan Blade Cleaning:
Periodically, the motor and fan blades may accumulate dust. If accessible and comfortable doing so:
- Disconnect Power: Turn off power at the circuit breaker.
- Access Motor: Remove the grille and light assembly. Carefully detach the motor assembly if possible (refer to detailed product diagrams if unsure).
- Clean Blades: Use a soft brush or vacuum cleaner with a brush attachment to remove dust from the fan blades and motor housing. Do not bend the fan blades.
- Reassemble: Reassemble all components and restore power.
LED Bulb Replacement:
The unit uses two 9.5W LED bulbs with an E26 base. While LED bulbs have a long lifespan, if replacement is needed:
- Disconnect Power: Turn off power at the circuit breaker.
- Remove Shade: Carefully remove the glass shade to access the bulbs.
- Replace Bulbs: Unscrew the old bulbs and screw in new E26 base LED bulbs of the same wattage (9.5W) or equivalent.
- Reattach Shade: Securely reattach the glass shade and restore power.
Troubleshooting
If your fan is not operating correctly, consult the following common issues before contacting support:
| Problem | Possible Cause | Solution |
|---|---|---|
| Fan or Light does not operate | No power to the unit; Loose wiring connection; Faulty switch; Blown fuse/tripped breaker | Check power supply at circuit breaker; Verify all wiring connections are secure; Test or replace wall switch; Reset breaker or replace fuse. |
| Fan operates, but light does not | Burned out LED bulb; Loose bulb connection; Faulty light kit wiring | Replace LED bulbs; Ensure bulbs are screwed in tightly; Check light kit wiring (professional assistance recommended). |
| Fan is noisy or vibrates excessively | Loose mounting screws; Obstruction in fan blades; Damaged motor; Improper ducting | Tighten mounting screws; Remove any obstructions; Contact support if motor is damaged; Inspect ductwork for kinks or blockages. |
| Poor air movement | Blocked ductwork; Fan blades dirty; Incorrect fan size for room; Backdraft damper stuck | Check and clear ductwork; Clean fan blades; Ensure fan is appropriate for room size (80 CFM for small rooms); Inspect backdraft damper for free movement. |
Specifications
Detailed technical specifications for the Good Housekeeping Athens Model 80213:
- Model Number: 80213
- Manufacturer: OceanAire HomeGoods Company
- Air Flow Capacity: 80 Cubic Feet Per Minute (CFM)
- Sound Level: 2.0 Sones (Ultra-Quiet)
- Product Dimensions: 13.26 x 13.26 x 11.61 inches
- Item Weight: 11.61 pounds
- Power Source: Hardwired (AC)
- Voltage: 120 Volts
- Wattage: 60 watts (total for fan and light)
- Type of Bulb: LED (2x 9.5W included)
- Luminous Flux: 1600 Lumens
- Mounting Type: Ceiling Mount, Flush Mount
- Switch Style: Touch (compatible with standard wall switches)
- Material: Metal & Glass
- Finish: Brushed Nickel
- Color: Brushed Nickel
- Certification: HVI, cETLus
- Special Features: Installation Hardware Included, New or Roomside Installation Ready
- Usage: Home & Bath
Image: Icon indicating 80 CFM airflow capacity.
Image: Icon representing 2.0 Sones, indicating quiet operation.
Image: Icon suggesting suitability for small rooms, typically 50-79 square feet.
Warranty Information
The Good Housekeeping Athens Model 80213 comes with the following warranty:
- Lifetime Motor Warranty: The fan motor is covered by a lifetime warranty.
- 2-Year Parts Warranty: All other parts of the unit are covered by a 2-year warranty from the date of purchase.
Please retain your proof of purchase for warranty claims. For detailed terms and conditions, refer to the warranty documentation included with your product or visit the manufacturer's website.
Customer Support
If you have any questions, require technical assistance, or need to report a problem that cannot be resolved using the troubleshooting guide, please contact customer support.
For the most up-to-date contact information, please refer to the packaging or the official Good Housekeeping website.
