Windhager 05062

Windhager SNAP Mouse Trap Instruction Manual

Model 05062 (2-Pack)

1. Introduction

Thank you for choosing the Windhager SNAP Mouse Trap. This reusable, poison-free snap trap is designed for effective and hygienic mouse control. Please read these instructions carefully before use to ensure safe and optimal performance.

Windhager SNAP Mouse Trap, black, set on a tiled floor with a small mouse illustration in the corner.

Image 1.1: The Windhager SNAP Mouse Trap, ready for use.

2. Safety Information

  • Keep out of reach of children and pets. The trap is designed to snap shut quickly and forcefully.
  • Handle with care. Avoid placing fingers near the snapping mechanism when setting the trap.
  • Do not use in areas where non-target animals could be harmed.
  • Always wear gloves when handling the trap or disposing of caught rodents to prevent contact with potential pathogens.
A black and white cat cautiously approaching the Windhager SNAP mouse trap, which is placed near a wall. The image highlights the trap's protective mechanism.

Image 2.1: The trap features a clever protection mechanism that only activates when the bait flap is lifted, reducing risk to non-target animals.

3. Setup

  1. Baiting the Trap:

    Open the bait compartment by lifting the small flap on the trap. Place a small amount of bait (e.g., peanut butter, hazelnut spread, chocolate cream, or bacon) into the designated bait cup. Close the flap securely. Avoid overfilling the bait cup.

    Close-up of the Windhager SNAP mouse trap showing the bait compartment with a small amount of bait inside.

    Image 3.1: Baiting the trap. Use a small amount of attractive bait.

  2. Setting the Trap:

    Press the rear part of the trap down firmly until it clicks into place. The trap is now armed and ready. Ensure your fingers are clear of the snapping mechanism during this process.

    The Windhager SNAP mouse trap set on a tiled floor, ready for use. The image shows the trap in its armed position.

    Image 3.2: The trap is easily set by pressing down until it locks.

  3. Placement:

    Place the armed trap in areas where mouse activity is suspected, such as along walls, in corners, or near entry points. Mice tend to travel along edges. For best results, place the trap parallel to the wall with the bait entrance facing the wall.

    A diagram showing the dimensions of the Windhager SNAP mouse trap (95mm height, 48mm width, 45mm depth) and indicating it's reusable with a clever protection mechanism.

    Image 3.3: Dimensions of the trap for optimal placement.

4. Operating Instructions

Once set, the Windhager SNAP Mouse Trap will activate when a mouse attempts to access the bait by lifting the bait flap. The trap is designed for a quick and humane catch.

  • Regularly check the traps.
  • Upon a successful catch, the trap will be in its closed position.
  • To dispose of the caught mouse, hold the trap over a waste bin and press the rear part of the trap to release the mouse without direct contact.
  • The trap can then be re-baited and reset for continued use.
A product image showing two Windhager SNAP mouse traps in their packaging, emphasizing easy emptying without touching the animal and being chemical-free.

Image 4.1: The trap allows for hygienic disposal without direct contact with the rodent.

5. Maintenance

The Windhager SNAP Mouse Trap is made from high-quality plastic, making it durable and easy to clean for repeated use.

  • After each use, clean the trap with warm, soapy water.
  • Rinse thoroughly and allow to air dry completely before re-baiting and resetting.
  • Proper cleaning helps remove residual odors that might deter future catches.
Close-up of the Windhager SNAP mouse trap on a tiled floor, highlighting its high-quality plastic construction for durability and easy cleaning.

Image 5.1: The trap's high-quality plastic construction ensures durability and ease of cleaning.

6. Troubleshooting

  • Trap not catching:
    • Ensure the trap is properly baited with an attractive food source.
    • Verify the trap is fully armed and clicked into place.
    • Check placement: Mice often prefer to run along walls. Place the trap perpendicular or parallel to the wall with the bait entrance facing the wall.
    • Consider using multiple traps in different locations.
  • Bait taken, but no catch:
    • The amount of bait might be too large, allowing the mouse to eat without triggering the trap. Use a pea-sized amount.
    • The bait might not be sticky enough to require the mouse to pull at it, thus not triggering the mechanism. Use sticky baits like peanut butter.
    • Ensure the trap is placed on a stable, flat surface.

7. Specifications

FeatureDetail
Model Number05062
Product Dimensions (L x W x H)12L x 4.5W x 18H cm (approx. 9.5 x 4.8 x 4.5 cm; 60 g as per other spec)
MaterialHigh-quality Plastic
ColorBlack
Number of Items2 (per pack)
Target SpeciesMouse
Power SourceHand-powered
ReusableYes

8. Warranty and Support

Specific warranty information and direct support contact details are not provided within this manual. For warranty claims, product support, or further inquiries, please refer to the retailer where the product was purchased or visit the official Windhager website for the most up-to-date information.

You can find more information about Windhager products and pest control solutions on their official website: www.windhager.eu

© 2026 Windhager. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.