Introduction
This manual provides essential information for the proper setup, operation, and maintenance of your POS Corded Black No Dial Telephone. This telephone is specifically designed for incoming calls only, making it ideal for environments where outbound dialing is not required, such as hotel lobbies, car rental agencies, or public areas. Please read this manual thoroughly before using the product to ensure optimal performance and longevity.
Safety Information
- Do not expose the telephone to water or excessive moisture.
- Avoid placing the telephone near heat sources or direct sunlight.
- Use only the provided cords.
- Do not attempt to open or repair the telephone yourself. Refer all servicing to qualified personnel.
- Keep out of reach of small children.
Package Contents
Verify that all items are present in the package:
- POS Corded Black No Dial Telephone Unit
- Coiled Handset Cord
- Line Cord (for connection to wall jack)
Setup
- Connect the Handset: Plug one end of the coiled handset cord into the handset and the other end into the designated jack on the telephone base.
- Connect to Telephone Line: Plug one end of the line cord into the "LINE" jack on the back or side of the telephone base. Plug the other end of the line cord into a standard telephone wall jack (RJ11).
- Placement: Place the telephone on a stable, flat surface. Ensure the metal base is secure.
Operating Instructions
This telephone is designed exclusively for receiving incoming calls.
- Receiving a Call: When the telephone rings, lift the handset from the base to answer the call.
- Ending a Call: Place the handset back onto the base to end the call.
- Ringer Control: The telephone features a real bell ringer. Locate the ringer ON/OFF switch, usually on the side or bottom of the base, to enable or disable the ringing sound.
- Handset Volume Control: Adjust the volume of the incoming audio during a call using the volume control switch or slider located on the handset.
- Dataport: The integrated dataport allows for connection of other devices, such as a modem or fax machine, if needed.
Maintenance
- Cleaning: Wipe the telephone with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Cord Care: Avoid tangling or stretching the cords excessively to prevent damage.
- Storage: If storing the telephone for an extended period, disconnect it from the wall jack and store it in a cool, dry place.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No ring when a call comes in. | Ringer switch is OFF. | Locate the ringer ON/OFF switch and set it to ON. |
| Cannot hear caller or caller cannot hear me. | Cords are not properly connected; Handset volume is too low. | Ensure all cords are securely plugged in. Adjust the handset volume control. |
| No dial tone (though this phone is incoming only, a basic line check). | Telephone line issue; Cord not connected. | Check if the line cord is securely connected to the wall jack. Test the wall jack with another working phone if possible. Contact your telephone service provider if the issue persists. |
Specifications
- Model: B0778JDG2P
- Brand: POS
- Color: Black
- Telephone Type: Corded, No Dial
- Material: Metal Base
- Power Source: Corded Electric (Line Powered)
- Compatible Networks: PSTN, Landline Networks
- Operation: Incoming Calls Only, Single-Line Operation
- Features: Real Bell Ringer (On/Off), Handset Volume Control, Dataport
Warranty and Support
For warranty information or technical support, please refer to the contact details provided by your retailer or the manufacturer, POS. Keep your purchase receipt as proof of purchase.
For general inquiries, you may visit the product page on Amazon: amazon.com/dp/B0778JDG2P
