1. Introduction
Thank you for choosing the Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light. This manual provides essential information for the safe installation, operation, and maintenance of your new lighting fixture. Please read these instructions carefully before installation and retain them for future reference.
The Robert 9675-13 is an 18W LED outdoor wall light designed to provide warm white illumination (3000K) with an anthracite finish. It features an IP65 rating, ensuring protection against dust and water jets, making it suitable for outdoor use.
2. Safety Instructions
Always observe the following safety precautions to prevent injury or damage:
- Professional Installation: Installation must be carried out by a qualified electrician in accordance with local wiring regulations and safety standards.
- Power Disconnection: Always disconnect the main power supply before attempting any installation, maintenance, or repair work.
- Voltage: Ensure the supply voltage matches the requirements of the fixture (230V).
- IP65 Rating: This fixture is rated IP65 for outdoor use, meaning it is protected against dust ingress and low-pressure water jets. Ensure all seals are correctly seated during installation to maintain this rating.
- Heat: The LED module may become warm during operation. Do not touch the light source directly when it is active.
- Damage: Do not operate the fixture if any part is damaged. Contact the manufacturer or a qualified professional for repair.
- Cleaning: Use only a soft, dry, or slightly damp cloth for cleaning. Avoid abrasive cleaners or solvents.
3. Package Contents
Please check that all components are present and undamaged:
- 1 x Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light (Anthracite)
- 1 x Integrated LED board (18W, 3000K)
- Mounting hardware (screws, wall plugs)
- Instruction Manual
4. Setup and Installation
The installation of this LED outdoor wall light requires electrical wiring. It is strongly recommended that installation be performed by a certified electrician.
4.1. Preparation
- Ensure the main power supply to the installation area is switched off at the circuit breaker.
- Unpack the fixture and inspect it for any damage.
- Gather necessary tools: drill, screwdriver, wire strippers, level, pencil.
4.2. Mounting the Fixture
- Determine the desired mounting location on the wall.
- Carefully detach the mounting bracket from the light fixture, if applicable.
- Hold the mounting bracket against the wall at the desired height and mark the drilling points with a pencil. Use a level to ensure it is straight.
- Drill holes at the marked points. Insert appropriate wall plugs (provided) into the drilled holes.
- Secure the mounting bracket to the wall using the provided screws.
4.3. Electrical Connection
- Route the electrical supply cable through the designated opening in the mounting bracket and fixture.
- Connect the wires according to standard electrical codes: Live (L), Neutral (N), and Earth (PE). Ensure connections are secure and properly insulated.
- Ensure all seals and gaskets are correctly positioned to maintain the IP65 rating.
4.4. Final Assembly
- Carefully attach the main light fixture body to the mounting bracket, ensuring it is securely fastened.
- Restore power at the circuit breaker and test the light.
Image 1: Front view of the Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light, unlit.
Image 2: The Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light illuminated on a wall, showing light distribution.
5. Operating Instructions
The Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light operates via a standard wall switch connected to its power supply. There are no additional controls on the fixture itself.
- Turning On/Off: Use the connected wall switch to turn the light fixture on or off.
- Light Output: The integrated LED provides a consistent 3000K warm white light. This fixture is not dimmable unless connected to a compatible external dimming system (not included and requires professional assessment).
6. Maintenance
The Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light requires minimal maintenance.
- Cleaning: Disconnect power before cleaning. Wipe the fixture with a soft, dry, or slightly damp cloth. Do not use harsh chemicals, abrasive cleaners, or scouring pads, as these can damage the finish and seals.
- LED Module: The LED light source is integrated and not user-replaceable. If the LED module fails, the entire fixture typically needs to be replaced.
- Inspection: Periodically inspect the fixture for any signs of wear, damage, or loose connections, especially after severe weather conditions.
7. Troubleshooting
If you encounter issues with your light fixture, refer to the following troubleshooting guide:
| Problem | Possible Cause | Solution |
|---|---|---|
| Light does not turn on. | No power supply. | Check the circuit breaker and wall switch. Ensure power is restored. |
| Loose wiring connection. | (Professional assistance recommended) Disconnect power and check all wire connections. | |
| Faulty LED module. | The LED module is integrated. If confirmed faulty, the fixture may need replacement. Contact customer support. | |
| Light flickers. | Unstable power supply. | Consult an electrician to check the electrical circuit. |
| Loose connection. | (Professional assistance recommended) Disconnect power and check all wire connections. | |
| Water ingress/condensation inside fixture. | Improper sealing during installation. | (Professional assistance recommended) Disconnect power. Re-check all seals and ensure they are correctly seated. |
If the problem persists after attempting these solutions, please contact Paul Neuhaus customer support or a qualified electrician.
8. Specifications
| Feature | Specification |
|---|---|
| Brand | Paul Neuhaus |
| Model Number | 9675-13 |
| Color | Anthracite |
| Material | Iron |
| Light Source Type | Integrated LED |
| Wattage | 18 Watts |
| Voltage | 230 Volts |
| Color Temperature | 3000K (Warm White) |
| Number of Light Sources | 1 |
| Power Source | Corded Electric |
| Switch Installation Type | Wall Mount |
| Energy Efficiency Class | A++ to A |
| IP Rating | IP65 |
| Dimensions (L x W x H) | 25.00 cm x 6.30 cm x 6.30 cm |
| Item Weight | 1.32 kg |
| Batteries Required | No |
| First Available Date | 29 October 2017 |
9. Warranty and Support
Specific warranty information for the Paul Neuhaus Robert 9675-13 LED Outdoor Wall Light may vary by region and retailer. Please refer to your purchase documentation or contact your point of sale for detailed warranty terms.
For technical support, spare parts, or further assistance, please contact Paul Neuhaus customer service through their official website or the retailer from whom you purchased the product.
