Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your MPC Complete Remote Start/Keyless Entry Kit. This system is designed to add convenience and security features to your 2003-2004 Lincoln Towncar with a key-start ignition and gas engine. Please read this manual thoroughly before attempting installation or operation.
Image Description: A complete kit laid out, showing the main control module, bypass module, wiring harnesses, two 5-button remote controls, and various small installation accessories like zip ties and connectors. The items are presented in an open MPC branded box.
Vehicle Compatibility and Requirements
This kit is specifically designed for:
- Vehicle: Lincoln Towncar
- Model Years: 2003-2004
- Ignition Type: Conventional Key-Start Ignition ONLY.
- Engine Type: Gas Engine ONLY (Not compatible with Hybrid vehicles).
Important: This system is not compatible with vehicles equipped with a "Push-to-Start" ignition system. Ensure your vehicle meets these requirements before proceeding with installation.
Image Description: A graphic illustrating vehicle compatibility. A green circle with a checkmark shows a traditional key ignition, labeled "KEY-START IGNITION ONLY". A red circle with a cross shows a "START STOP" button, indicating it is not compatible. Text below confirms "Conventional Key-Start ONLY!" and "Does NOT work in Push-To-Start Vehicles" and "Gas Engine Only (NOT for Hybrid)".
Image Description: A visual warning showing a "START STOP" button on the left and a traditional key ignition on the right, with a large "STOP" sign in the middle. The text below reads "ENSURE YOU HAVE THE CORRECT KIT!!!", emphasizing the importance of checking ignition type.
Setup and Installation
Installation of this remote start and keyless entry system requires technical knowledge of vehicle wiring and electronics. It is recommended that installation be performed by a qualified professional. If you choose to install it yourself, proceed with caution and ensure all safety measures are followed.
General Installation Steps:
- Preparation: Disconnect the vehicle's battery before starting any wiring. Gather all necessary tools.
- Access Vehicle Wiring: Carefully remove necessary dashboard panels and trim to access the vehicle's ignition, power, and other relevant wiring harnesses. A trim removal tool (like the one pictured below) can be helpful.
- Module Placement: Mount the remote start module and bypass module in a secure, hidden location within the vehicle's dashboard, away from moving parts or excessive heat.
- Wiring Connections: Follow the detailed wiring diagram provided with your kit. Connect the remote start module to the vehicle's ignition, power, ground, door locks, and other necessary circuits. Ensure all connections are secure and properly insulated.
- Bypass Module Programming: The bypass module will need to be programmed to your vehicle's immobilizer system. Refer to the specific instructions provided with the bypass module for this critical step.
- Remote Programming: Program the included 5-button remotes to the remote start system.
- Testing: Reconnect the vehicle's battery. Test all functions of the remote start and keyless entry system thoroughly before reassembling the vehicle's interior.
- Reassembly: Carefully reassemble all removed panels and trim.
Image Description: A yellow plastic pry tool with the MPC logo and "mypushcart.com" printed on it. This tool is useful for safely removing interior trim panels without causing damage.
Installation Difficulty:
Image Description: A gauge labeled "EASE OF INSTALLATION" with a needle pointing towards "MORE DIFFICULT". This indicates that while the kit is complete, the installation process itself requires a certain level of technical skill and is not typically considered a simple plug-and-play task for beginners.
For detailed, vehicle-specific wiring diagrams and programming instructions, refer to the "cheat sheets" or technical documents provided by MPC, often accessible via their support website. These resources are crucial for a successful installation.
Image Description: A hand holding a smartphone displaying an MPC "TIP SHEET" with installation instructions, indicating digital access to guides.
Image Description: Hands holding a tablet displaying an MPC "TIP SHEET", showing the flexibility of accessing instructions on different devices.
Image Description: A person using a laptop to view an MPC "TIP SHEET", highlighting the availability of detailed guides on larger screens for easier reference.
Operating Instructions
Your MPC remote start system comes with two 5-button remote controls. These remotes provide long-range operation for starting your vehicle and controlling the keyless entry functions.
Image Description: Two identical 5-button remote controls, each with a metallic key ring and clip. The buttons are typically for lock, unlock, remote start, trunk release, and panic/auxiliary functions.
Remote Control Functions:
- Remote Start: Press the remote start button (often indicated by a circular arrow or "START" icon) twice within 3 seconds to start your vehicle. The vehicle will run for a preset duration (e.g., 15 minutes) and then shut off, or until you enter the vehicle and turn the key to the ON position.
- Remote Stop: To turn off the vehicle after a remote start, press the remote start button twice again.
- Lock: Press the lock button (often a closed padlock icon) once to lock all vehicle doors.
- Unlock: Press the unlock button (often an open padlock icon) once to unlock the driver's door, or twice to unlock all doors (may vary by vehicle and programming).
- Trunk Release: Press and hold the trunk release button (often a trunk icon) for approximately 3 seconds to open the vehicle's trunk.
- Panic/Car Finder: Press the panic button (often a horn icon or "PANIC") to activate the vehicle's alarm and horn. This can also be used to locate your vehicle in a crowded parking lot.
Note: Specific button assignments and advanced features may vary slightly based on the exact model and programming. Refer to the detailed programming guide for your specific system.
Image Description: A split image showing two cars. On the left, a car in a summer mountain setting with text "SUMMER The Right Temperature". On the right, a car in a winter snowy mountain setting with text "& WINTER For Any Season". A hand holding a remote is visible in the winter scene, illustrating the benefit of remote start for climate control.
Maintenance
The MPC Remote Start/Keyless Entry Kit is designed for reliable operation with minimal maintenance. However, periodic checks and proper care will ensure its longevity.
Remote Control Battery Replacement:
- If the range of your remote control decreases significantly or the LED indicator (if present) does not light up, the battery may need replacement.
- Refer to the specific remote control model for battery type (e.g., CR2032 coin cell).
- Carefully open the remote control casing using a small flat-head screwdriver or a pry tool.
- Remove the old battery and insert the new battery, ensuring correct polarity (+/-).
- Snap the remote control casing back together.
System Care:
- Keep the remote controls dry and avoid exposure to extreme temperatures.
- Do not attempt to open or repair the main control module or bypass module yourself, as this may void the warranty.
- Ensure all wiring connections remain secure. If you suspect a loose connection, consult a professional installer.
Troubleshooting
If you experience issues with your MPC Remote Start/Keyless Entry Kit, review the following common troubleshooting steps. For persistent problems, contact technical support.
Common Issues and Solutions:
- Remote Start Fails to Activate:
- Ensure the vehicle doors are closed, hood is closed, and the parking brake is engaged (if required by installation).
- Check if the vehicle's battery is charged.
- Verify the remote control battery is not depleted.
- Confirm you are within the remote's operating range.
- Ensure the correct button sequence is being used (e.g., press start button twice).
- Keyless Entry Not Working:
- Check remote control battery.
- Ensure you are within range.
- Verify the vehicle's central locking system is functional with the original key.
- Vehicle Starts but Shuts Off Immediately:
- This often indicates an issue with the bypass module programming or connection to the vehicle's immobilizer system. Re-check bypass module instructions or consult a professional.
- Reduced Remote Range:
- Replace the remote control battery.
- Ensure there are no large obstructions or sources of radio interference between the remote and the vehicle.
Specifications
| Model Number | B-4535-354-2 |
| Compatibility | Lincoln Towncar 2003-2004 (Key-to-Start, Gas Engine) |
| Remote Type | (2) 5-Button 1-Way Remotes |
| Remote Range | Up to 1500 feet (Long Range) |
| Wireless Remote | Yes |
| Item Weight | 3 pounds |
| Product Dimensions | 8 x 8 x 3 inches |
| Manufacturer | MPC Products |
What's in the Box:
- Remote Start Control Module
- Vehicle-Specific T-Harness (for plug-and-play connections where applicable)
- Bypass Module
- (2) 5-Button Long Range 1500' Remotes
- Installation Accessories (zip ties, connectors, etc.)
- Instruction Manual and Wiring Diagrams (often digital access)
Warranty Information
MPC remote starters and alarms carry a limited lifetime warranty through the manufacturer. This warranty covers defects in workmanship and materials under normal conditions of use for a period of one year from the date of purchase for the original purchaser.
- First Year: For warranty issues within the first year, contact MPC directly. The product must be returned at the customer's expense for warranty service.
- After First Year: After the first year, warranty issues must be handled directly through the manufacturer. A receipt from the original purchase will be required.
- Exclusions: This warranty does not cover abuse, operation inconsistent with the product's design, physical damage, damage due to improper installation, or damage resulting from exposure to the elements. Improper installation will void the manufacturer's warranty.
- Remedy: If a defect is considered "under warranty," MPC will, at its option, repair or replace the product free of charge to the original purchaser.
- Liability: MPC is not liable for any installation charges, loss, or damage of any kind incurred in the replacement or repair of any warranted product.
Product-specific warranty information will be included with the product packaging.
Support and Contact Information
For technical assistance, installation guidance, or warranty inquiries, please contact MPC's expert technical support team.
Image Description: A smiling customer support representative wearing a headset, with text overlay "FREE Expert Technical Support Monday - Friday 9am - 5pm (MST)" and the MPC Automotive Accessories logo.
- Technical Support Hours: Monday - Friday, 9 AM - 5 PM (MST)
- Online Resources: Visit the official MPC website or the MPC Store on Amazon for additional information, FAQs, and digital installation guides.
- Contact: Refer to your product packaging or the MPC website for the most current contact methods (phone, email).
