Ecolab Neutral Floor Cleaner 6100036 - 2.5 Gallon Instruction Manual

1. Product Overview

The Ecolab Neutral Floor Cleaner is a professional-grade cleaning solution designed to effectively remove soils from various floor types without leaving a film or haze. This product cleans without stripping floor finish or dulling gloss, and typically does not require rinsing. Its ultra-low foaming properties make it suitable for daily use in automatic scrubbers and with traditional mop and bucket systems. It features a pleasant fragrance and is formulated to maintain the integrity of floor finishes.

2. Safety Information

Always read and understand the product label and Safety Data Sheet (SDS) before use. Adhere to the following general safety guidelines:

• Keep out of reach of children and pets.
• Avoid contact with eyes and skin. In case of contact, rinse thoroughly with water for several minutes. If irritation persists, seek medical attention.
• Do not ingest. If swallowed, do not induce vomiting. Drink plenty of water and seek immediate medical attention.
• Use in well-ventilated areas.
• Wear appropriate Personal Protective Equipment (PPE), including chemical-resistant gloves and eye protection (safety glasses or goggles), when handling the concentrated product or during prolonged use.
• Store in original container in a cool, dry place, away from incompatible materials and direct sunlight.

3. Setup and Dilution

The Ecolab Neutral Floor Cleaner is a concentrated product that requires dilution before use. Proper dilution is crucial for effective cleaning and to prevent damage to floor finishes.

1. Consult Product Label: Always refer to the specific dilution instructions on the product label for precise ratios based on your cleaning application and soil level.
2. General Dilution: For routine daily cleaning, a common dilution ratio is 1 to 2 ounces of cleaner per gallon of water. For heavier soil, a slightly higher concentration may be used, but do not exceed recommended limits.
3. Mixing Procedure: Always add the concentrated cleaner to water, not water to cleaner, to minimize splashing and foaming. Use a clean measuring device to ensure accurate dilution.
4. Equipment Preparation: Ensure all cleaning equipment (e.g., automatic scrubber tanks, mop buckets) is clean and free of previous chemical residues before adding the diluted solution.

4. Operating Instructions

4.1. Automatic Scrubber Use

1. Fill the solution tank of your automatic scrubber with the properly diluted Ecolab Neutral Floor Cleaner solution.
2. Select the appropriate pad or brush for your floor type and soil condition.
3. Operate the automatic scrubber according to the manufacturer's instructions, ensuring even application and recovery of the cleaning solution.
4. Typically, no rinsing is required, as the product is designed to clean without leaving residue.

4.2. Mop and Bucket Use

1. Fill a clean mop bucket with the properly diluted Ecolab Neutral Floor Cleaner solution.
2. Apply the solution evenly to the floor surface using a clean mop.
3. Allow a short dwell time (e.g., 3-5 minutes) for the cleaner to penetrate and loosen soil. Do not allow the solution to dry on the floor.
4. Agitate stubborn areas with the mop or a brush if necessary.
5. Remove the soiled solution from the floor using a clean mop or a wet vacuum.
6. No rinsing is typically required.

5. Maintenance

5.1. Product Storage

• Store the 2.5-gallon container in its original, tightly sealed packaging.
• Keep in a cool, dry, well-ventilated area, away from extreme temperatures.
• Ensure the container is stored upright to prevent leaks.

5.2. Equipment Care

• After each use, thoroughly rinse all cleaning equipment (mop buckets, mops, automatic scrubber tanks, hoses, and recovery tanks) with clean water.
• Clean and replace mop heads, pads, or brushes as needed to maintain cleaning effectiveness and hygiene.
• Regularly inspect equipment for wear and tear.

6. Troubleshooting

If you encounter issues during or after cleaning, consider the following common troubleshooting steps:

• Streaking or Haze: This may indicate that the solution is too concentrated, or that previous residues were not fully removed. Try reducing the dilution ratio slightly or ensure thorough removal of soiled solution. Ensure cleaning pads/brushes are clean.
• Insufficient Cleaning: If the floor is not getting clean, the solution might be too diluted, or the soil may require more agitation or a longer dwell time. Increase the concentration slightly (within recommended limits) or use a more aggressive pad/brush suitable for the floor type.
• Excessive Foaming: While this product is ultra-low foaming, excessive foaming can occur if the solution is too concentrated or if there are residues from other cleaning agents. Adjust dilution or ensure equipment is thoroughly rinsed.

7. Specifications

• Brand: Ecolab
• Model Number: 6100036
• Item Form: Liquid
• Scent: Unscented
• Specific Uses For Product: Floor cleaning
• Surface Recommendation: Floor
• Special Features: Low Odor
• Item Volume: 2.5 Gallons
• Number of Items: 1
• Manufacturer: Ecolab
• Package Dimensions: 13.66 x 12.68 x 6.34 inches
• Weight: Approximately 22.95 Pounds
• First Available Date: September 27, 2017

8. Warranty and Support

For specific warranty information, technical assistance, or product support, please contact Ecolab directly. You can typically find their contact details on their official website or on the product label. When contacting support, please have your product model number (6100036) and purchase information readily available.

For more information, visit the Ecolab Store on Amazon.