Absaar 062085

Absaar 62085 AB-4 Fully Automatic 6/12 V Battery Charger User Manual

Model: 062085

Introduction

This manual provides essential information for the safe and effective operation of your Absaar 62085 AB-4 Fully Automatic Battery Charger. Please read these instructions carefully before use and retain them for future reference.

Safety Instructions

Always observe the following safety precautions to prevent injury or damage to the charger or battery:

Product Features

The Absaar 62085 AB-4 battery charger offers advanced features for efficient and safe battery maintenance:

Package Contents

Verify that all items are present in the package:

Absaar 62085 AB-4 Battery Charger with cables and clamps laid out

Image: The Absaar 62085 AB-4 battery charger unit, showing the main body, attached power cord, and the red and black battery clamps.

Setup

Follow these steps to set up your battery charger:

  1. Preparation: Ensure the area is well-ventilated and free from flammable materials. Turn off the vehicle's ignition and all accessories.
  2. Connect to Battery:
    • Connect the red positive (+) clamp to the positive (+) terminal of the battery.
    • Connect the black negative (-) clamp to the negative (-) terminal of the battery. If charging a battery installed in a vehicle, connect the black clamp to the vehicle chassis or engine block away from the battery and fuel line.
    Absaar 62085 AB-4 Battery Charger connected to a car battery

    Image: The Absaar 62085 AB-4 battery charger connected to a vehicle battery, showing the red clamp on the positive terminal and the black clamp on the negative terminal.

  3. Connect to Power: Plug the AC power cord into a standard electrical outlet. The charger's LCD screen will illuminate.

Operating Instructions

The Absaar 62085 AB-4 is a fully automatic charger. Once connected, it will automatically detect the battery voltage (6V or 12V) and begin the charging process.

Close-up of Absaar 62085 AB-4 Battery Charger LCD display showing voltage

Image: A close-up view of the Absaar 62085 AB-4 battery charger's LCD display, showing a voltage reading and battery charge indicator.

Charging Process:

  1. Automatic Detection: The charger will automatically detect if the connected battery is 6V or 12V.
  2. Charging Stages: The charger employs 4 intelligent charging levels to optimize battery health and charge efficiency. The LCD screen will display the current charging status.
  3. Maintenance Mode: Once the battery is fully charged, the charger automatically switches to maintenance (float) mode. This prevents overcharging and keeps the battery at optimal capacity, ideal for seasonal vehicles.
  4. Battery Test Function: The charger includes a battery test function. Refer to the LCD display for readings.
  5. Memory Function: If power is interrupted, the charger will resume the previous charging level when power is restored.

Disconnecting the Charger:

  1. Unplug the AC power cord from the electrical outlet.
  2. Disconnect the black negative (-) clamp from the battery terminal or vehicle chassis.
  3. Disconnect the red positive (+) clamp from the battery terminal.

Maintenance

Proper maintenance ensures the longevity and performance of your Absaar battery charger:

Troubleshooting

If you encounter issues with your Absaar battery charger, refer to the following table:

ProblemPossible CauseSolution
Charger not turning on / LCD not litNo power from outlet; Loose power connection; Damaged power cord.Check outlet with another appliance; Ensure power cord is securely plugged in; Inspect power cord for damage and replace if necessary (contact service).
Charger not charging batteryIncorrect battery connection (reverse polarity); Battery is severely discharged or damaged; Battery type not compatible; Loose battery clamp connection.Check battery clamp polarity (red to +, black to -); Test battery condition (if possible); Ensure battery is within 5-120 Ah range and is lead-acid, GEL, or AGM; Securely attach clamps to clean battery terminals.
Charger displays error code or warningOvercharge protection activated; Short circuit detected; Reverse polarity detected.Disconnect charger, wait a few minutes, then reconnect; Check for short circuits in cables or battery; Correct battery clamp polarity.
Charger gets warm during operationNormal operation; Poor ventilation.Some warmth is normal. Ensure adequate ventilation around the charger. If excessively hot, disconnect and contact service.

If the problem persists after attempting these solutions, please contact customer support.

Specifications

BrandAbsaar
Model Number062085 (AB-4)
Input Voltage12 Volts AC (from mains via power cord)
Output Voltage6V / 12V DC (Automatic Detection)
Current Rating4 A
Battery Capacity Range5 Ah - 120 Ah
Compatible Battery TypesLead-acid, GEL, AGM
Charging Levels4 intelligent levels
Protection FeaturesOvercharge, Short Circuit, Reverse Polarity
Ingress Protection (IP) RatingIP65 (Dust and Splash Proof)
DisplayLCD with Backlight
MaterialPlastic
ColorRed

Warranty and Support

Absaar products are manufactured to high quality standards. For warranty information or technical support, please refer to the warranty card included with your purchase or visit the official Absaar website. Please have your model number (062085) and purchase details ready when contacting support.

Manufacturer: Service Best

Related Documents - 062085

Preview ABSAAR PRO 4.0 Li Battery Charger - User Manual and Technical Specifications
Official user manual for the ABSAAR PRO 4.0 Li battery charger. Provides detailed information on features, safety precautions, technical specifications, charging modes, error indicators, and warranty for 6V/12V lead-acid, gel, AGM, and 12V LifePo4 batteries.
Preview ABSAAR 15 Amp 12V NE LED LA3 Battery Charger Technical Specifications
Detailed technical specifications and features for the ABSAAR 15 Amp 12V NE LED LA3 battery charger, including voltage, current, capacity, and operational indicators.
Preview ABSAAR S-M Battery Charger Manual - User Guide
Detailed user manual for the ABSAAR S-M Battery Charger, covering safety instructions, product features, operation, maintenance, and warranty. Includes guidance on charging types, connections, LED indicators, fuse replacement, and jump-start functionality.
Preview Absaar S-M Battery Charger Manual
This manual provides comprehensive instructions for the Absaar S-M battery charger, covering safety precautions, operating procedures, and maintenance. It details how to connect, charge, and maintain batteries using the Absaar charger, including information on different charging modes, indicators, and troubleshooting.
Preview Absaar Battery Charger Manual - S-M Series
Comprehensive user manual for Absaar S-M series battery chargers, covering operation, safety, maintenance, and troubleshooting. Includes multilingual instructions and technical specifications.