SPS Brand 6V 14Ah T1T2 Replacement Battery User Manual

1. Introduction

This manual provides essential information for the safe and effective use of your SPS Brand 6V 14Ah T1T2 Replacement Battery. These sealed lead-acid (SLA) batteries are designed as replacements for the Emergi-Lite M3019 system. Please read this manual thoroughly before installation and operation.

Package Contents:

• Eight (8) SPS Brand 6V 14Ah T1T2 Replacement Batteries

Note: Cables and connectors are not included and must be reused from your original setup.

2. Safety Information

WARNING: Improper handling of batteries can lead to serious injury or damage. Always follow safety guidelines.

• Always wear appropriate personal protective equipment (PPE), including safety glasses and gloves, when handling batteries.
• Do not short-circuit the battery terminals. This can cause sparks, heat, and potential fire or explosion.
• Do not expose batteries to open flames, excessive heat, or direct sunlight.
• Do not attempt to open, disassemble, or modify the battery.
• Keep batteries out of reach of children.
• Dispose of spent batteries according to local regulations. Do not dispose of in household waste.
• Avoid contact with battery acid. If contact occurs, flush immediately with water and seek medical attention.
• Ensure proper ventilation when charging batteries.

California Proposition 65 Warning:

This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. These include Arsenic (as arsenic oxides), strong inorganic acid mists (including sulfuric acid), and Lead. For more information, refer to the product's Material Safety Data Sheet (MSDS/SDS).

3. Setup and Installation

Follow these steps to safely replace your existing batteries. Ensure the system is powered off before beginning installation.

1. Power Off System: Disconnect all power sources from the Emergi-Lite M3019 system.
2. Locate Batteries: Identify the location of the existing batteries within your Emergi-Lite M3019 unit.
3. Disconnect Old Batteries: Carefully disconnect the cables and connectors from the old batteries. Note the polarity (positive and negative terminals) before disconnecting to ensure correct re-connection.
4. Remove Old Batteries: Remove the old batteries from the unit.
5. Insert New Batteries: Place the new SPS Brand 6V 14Ah T1T2 replacement batteries into the designated compartments.
6. Connect New Batteries: Reconnect the cables and connectors to the new batteries, ensuring correct polarity. The T1T2 terminals are designed for standard connections.
7. Secure Batteries: Ensure batteries are securely seated and connections are firm.
8. Power On System: Reconnect power to the Emergi-Lite M3019 system and verify proper operation.

Figure 1: Eight SPS Brand 6V 14Ah T1T2 replacement batteries. Each battery features two terminals for connection.

4. Operating Instructions

These are rechargeable sealed lead-acid (SLA) batteries. Once installed, they function as the power source for your Emergi-Lite M3019 system. The system itself manages the charging and discharging cycles.

• Ensure the Emergi-Lite M3019 system is operating within its specified voltage and current limits to prevent damage to the batteries.
• Allow the system to fully charge the batteries after installation or after a prolonged power outage.
• Avoid deep discharges where possible, as this can reduce battery lifespan.

5. Maintenance

Proper maintenance ensures optimal performance and extends the lifespan of your SPS Brand batteries.

• Regular Inspection: Periodically inspect the batteries and terminals for any signs of corrosion, damage, or loose connections. Clean terminals if necessary using a wire brush and a baking soda solution (for corrosion).
• Temperature: Store and operate batteries within recommended temperature ranges (typically 20°C to 25°C or 68°F to 77°F) for optimal performance. Extreme temperatures can affect battery life.
• Charging: Ensure the charging system of your Emergi-Lite M3019 is functioning correctly. Overcharging or undercharging can damage SLA batteries.
• Cleaning: Keep the battery surfaces clean and dry. Use a damp cloth to wipe away dust or dirt.
• Storage: If storing batteries for an extended period, ensure they are fully charged and recharge them every 3-6 months to prevent self-discharge and irreversible capacity loss. Store in a cool, dry place.

6. Troubleshooting

If you encounter issues with your battery system, consider the following common troubleshooting steps:

• System Not Powering On:
  • Check all cable connections to ensure they are secure and correctly polarized.
  • Verify that the Emergi-Lite M3019 system is receiving external power (if applicable).
  • Test the voltage of individual batteries with a multimeter. A significantly low voltage may indicate a faulty battery.
• Shortened Run Time:
  • Ensure batteries are fully charged.
  • Check for any excessive load on the system.
  • Batteries may be reaching the end of their service life and require replacement.
• Corrosion on Terminals:
  • Disconnect power and carefully clean terminals with a wire brush and a mixture of baking soda and water. Rinse and dry thoroughly before reconnecting.

If problems persist, consult the Emergi-Lite M3019 system's manual or contact a qualified technician.

7. Specifications

8. Warranty and Support

For warranty information and technical support regarding your SPS Brand 6V 14Ah T1T2 Replacement Batteries, please refer to the documentation provided with your purchase or contact the seller directly.

Seller: Rightprice Batteries

For specific inquiries related to the Emergi-Lite M3019 system, please consult the original manufacturer's documentation.