1. Introduction
This manual provides essential information for the safe and effective use of your Reely 1563428 1:10 XS Buggy Complete Wheel Set. Please read these instructions carefully before installation and operation to ensure proper function and longevity of the product. This wheel set is designed for 1:10 XS scale RC buggies.
2. Safety Information
- Small Parts: This product contains small parts which may pose a choking hazard. Keep out of reach of small children.
- Proper Tools: Always use appropriate tools for installation to prevent damage to the wheels or your RC model.
- Adult Supervision: Installation and maintenance should be performed by or under the supervision of an adult.
- Intended Use: Use this product only for its intended purpose as a replacement wheel set for 1:10 XS scale RC buggies.
3. Product Overview and Components
The Reely 1563428 Complete Wheel Set consists of four pre-assembled wheels, each featuring a 6-spoke silver rim and a block-profile tire. These wheels are designed for optimal performance on various terrains for 1:10 XS scale buggies.
Image 1: The Reely 1563428 1:10 XS Buggy Complete Wheel Set, showing four assembled wheels with block-profile tires and silver 6-spoke rims.
Included Components:
- 4 x Complete Wheels (pre-assembled with rim and tire)
Image 2: A detailed view of one wheel, showcasing the block-profile tire tread and the silver 6-spoke rim design.
4. Setup and Installation
Tools Required:
- Wheel wrench (typically 7mm or 8mm, depending on your buggy's wheel nuts)
Installation Steps:
- Prepare the Buggy: Ensure your RC buggy is powered off and placed on a stable surface.
- Remove Old Wheels (if applicable): Use a wheel wrench to carefully loosen and remove the wheel nuts from the existing wheels. Remove the old wheels.
- Inspect Axle: Check the axle for any debris or damage. Ensure the 12mm hexagonal wheel hub adapter is correctly seated on the axle.
- Install New Wheels: Align the hexagonal opening on the back of the new Reely wheel with the 12mm hexagonal adapter on the buggy's axle. Slide the wheel onto the axle until it is fully seated against the hub.
- Secure Wheels: Place the wheel nut back onto the axle and tighten it with the wheel wrench. Do not overtighten, as this can damage the wheel or axle. The wheel should spin freely without excessive wobble.
- Repeat: Repeat the process for all four wheels.
- Final Check: Before operating, manually spin each wheel to ensure it rotates smoothly and is securely fastened.
5. Operating Instructions
Once the Reely 1563428 wheels are securely installed, your 1:10 XS buggy is ready for operation. These block-profile tires are designed for versatile performance on various surfaces. Always ensure the wheels are properly attached before each use.
- Pre-Run Check: Before each use, visually inspect all wheels for any signs of damage, loose nuts, or debris lodged in the tire tread.
- Driving Conditions: While block-profile tires offer good grip, adjust your driving style to suit the terrain and conditions.
- Avoid Obstacles: Minimize impacts with sharp objects or hard obstacles to prevent damage to the rims and tires.
6. Maintenance
Regular maintenance will extend the life and performance of your Reely wheel set.
- Cleaning: After each use, especially in dirty or wet conditions, clean the wheels. Remove any dirt, mud, or debris from the tire tread and rim using a soft brush and mild soap and water. Rinse thoroughly and allow to air dry completely.
- Inspection: Periodically inspect the tires for cuts, tears, or excessive wear. Check the rims for cracks, bends, or damage. Ensure the wheel nuts remain tight.
- Storage: Store the wheels in a cool, dry place away from direct sunlight and extreme temperatures when not in use. This helps prevent material degradation.
7. Troubleshooting
Below are common issues and their potential solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Wheel wobbles or is loose | Loose wheel nut; damaged hex adapter or axle | Tighten wheel nut. Inspect hex adapter and axle for damage; replace if necessary. |
| Poor traction | Worn tires; inappropriate terrain; debris in tread | Inspect tire tread for wear and replace if necessary. Clean debris from tread. Adjust driving style to terrain. |
| Visible damage to rim or tire | Impacts; material fatigue | Replace the damaged wheel immediately to prevent further issues or unsafe operation. |
8. Specifications
| Feature | Specification |
|---|---|
| Model Number | 1563428 |
| Brand | Reely |
| Scale | 1:10 XS |
| Suitable for Model Type | Buggy |
| Rim Colour | Silver |
| Rim Design | 6 Spokes |
| Tyre Diameter | 92 mm |
| Rim Hex Adapter | 12 mm Hexagonal |
| Tyre Width | 32 mm |
| Tyre Type / Profile | Full Wheels / Block-profile |
| Package Contents | 4 Full Wheels |
| Item Weight | Approximately 0.32 ounces (per wheel) |
9. Warranty and Support
Reely products are manufactured to high-quality standards. For any questions, technical support, or warranty inquiries, please refer to the contact information provided with your purchase or visit the official Reely website. Please retain your proof of purchase for warranty claims.
