Amazon Basics Portable Mini Ceramic Space Heater (Model DQ1722C)

1. Introduction

The Amazon Basics Portable Mini Ceramic Space Heater (Model DQ1722C) is designed to provide supplemental warmth for small indoor spaces such as offices, desks, or bedrooms. Its compact and lightweight design makes it easy to move and position where needed. Equipped with ceramic heating elements, it delivers quick and efficient heat. Safety features, including tip-over protection, ensure reliable operation.

2. Important Safety Information

READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.

• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when moving this heater.
• Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
• Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• Always unplug heater when not in use.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
• Do not use outdoors.
• This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
• To disconnect heater, first turn controls to OFF, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable vapors or liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
• This heater includes a Tip-Over Protection feature that automatically shuts off the unit if it is knocked over, ensuring safe operation.

3. Package Contents

• Amazon Basics Portable Mini Ceramic Space Heater (Model DQ1722C)
• Power Cord (integrated)

4. Product Overview

Figure 1: Front view of the Amazon Basics Portable Mini Ceramic Space Heater. It features a white casing with a black mesh grille, showcasing its compact and modern design.

Figure 2: Side view highlighting the secure and reliable use of the heater. It is ideal for tabletops or desks, features efficient ceramic coils for quick heating, and includes tip-over protection with auto-shutoff.

Figure 3: Illustrates the compact dimensions of the heater, measuring 5.9 inches deep, 3.2 inches wide, and 6 inches high. It is designed for spaces of 64.5-107.6 sq. ft. and has a sturdy base for any surface.

Figure 4: Rear view of the heater, showing the power cord neatly wrapped and the red power switch located at the bottom. The Amazon Basics logo is visible at the top.

5. Setup

1. Unpack the heater and remove all packaging materials.
2. Place the heater on a firm, level surface. Ensure it is at least 3 feet (0.9 m) away from any walls, furniture, or other obstructions.
3. Ensure the power switch on the back of the unit is in the OFF position.
4. Plug the power cord directly into a 120V AC wall outlet. Do not use extension cords or power strips.

6. Operating Instructions

The heater features two control knobs on the top for adjusting fan speed and heat level.

1. Power On: Flip the main power switch located on the back of the unit to the ON position. A red indicator light on the top of the unit will illuminate.
2. Adjust Fan Speed/Mode: Use the right knob to select the desired fan mode:
   • OFF: Turns the unit off.
   • FAN: Circulates air without heat.
   • I (Low Heat): Provides low heat output.
   • II (High Heat): Provides high heat output.
3. Adjust Thermostat/Heat Level: Use the left knob to adjust the thermostat. Turn the knob towards '+' for higher heat or towards '-' for lower heat. The heater will cycle on and off to maintain the set temperature.
4. Power Off: To turn off the heater, first turn the right knob to the OFF position, then flip the main power switch on the back of the unit to the OFF position. Unplug the unit from the wall outlet when not in use for extended periods.

7. Maintenance

Regular maintenance ensures optimal performance and longevity of your heater.

• Cleaning: Always unplug the heater before cleaning. Use a soft, damp cloth to wipe the exterior surfaces. Do not use abrasive cleaners or solvents. Ensure no water enters the interior of the heater.
• Storage: When not in use, store the heater in a cool, dry place. It is recommended to store it in its original packaging to protect it from dust and damage.
• Filter Cleaning: Periodically check the air intake and exhaust vents for dust and debris. Use a vacuum cleaner with a brush attachment to gently clean these areas. Do not attempt to disassemble the unit for cleaning.

8. Troubleshooting

• Heater does not turn on:
  • Ensure the power cord is securely plugged into a working 120V AC outlet.
  • Check that the main power switch on the back is in the ON position.
  • Verify that the fan/mode knob is not set to OFF.
  • If the heater was recently moved or tipped over, the tip-over protection may have activated. Place the heater upright on a flat surface and ensure the safety switch on the bottom is fully depressed.
  • The overheat protection may have activated. Unplug the heater, wait 10 minutes for it to cool down, then plug it back in and try again.
• No heat is coming out:
  • Ensure the fan/mode knob is set to either 'I' (Low Heat) or 'II' (High Heat), not 'FAN'.
  • Adjust the thermostat knob towards '+' to increase the heat setting.
• Heater is too loud:
  • Some fan noise is normal during operation. If the noise is excessive, ensure the unit is on a stable, flat surface and that the air vents are not obstructed.

9. Specifications

10. Warranty and Support

For warranty information and customer support, please refer to the documentation included with your product or visit the official Amazon Basics website. Keep your purchase receipt for warranty claims.