Introduction
Thank you for choosing the Moen 7594SRS Arbor One-Handle Pulldown Kitchen Faucet and Deck Mounted Soap Dispenser. This product combines elegant design with advanced functionality, including Power Boost technology for enhanced water flow and the Reflex system for smooth sprayer operation. The Spot Resist Stainless finish helps maintain a clean appearance. This manual provides detailed instructions for installation, operation, maintenance, and troubleshooting to ensure optimal performance and longevity of your faucet and soap dispenser.
Image: The Moen 7594SRS Arbor Pulldown Kitchen Faucet, showcasing its elegant gooseneck design and single handle in a Spot Resist Stainless finish.
Safety Information
- Always turn off the main water supply before beginning any installation or repair work.
- Wear appropriate personal protective equipment, such as safety glasses, during installation.
- Ensure all connections are secure to prevent leaks. Do not overtighten.
- If you are unsure about any part of the installation process, consult a qualified plumber.
- Keep small parts away from children to prevent choking hazards.
Package Contents
Verify that all components are present before beginning installation:
- Arbor Pulldown Kitchen Faucet
- Single Handle
- Deck Mounted Soap Dispenser with Refillable Bottle
- Sprayer Head
- Escutcheon (Deck Plate) for 3-hole installation
- Mounting Hardware
- Installation Instructions
Setup and Installation
This faucet is designed for installation through 1 or 3 holes. The included escutcheon (deck plate) is used for 3-hole installations.
- Prepare the Sink: Ensure the mounting surface is clean and dry. If using the escutcheon, place it over the sink holes.
- Install the Faucet: Insert the faucet body through the center hole (or escutcheon hole). Secure it from underneath the sink using the provided mounting hardware.
- Connect Water Lines: Connect the hot and cold water supply lines to the corresponding inlets on the faucet. Use thread sealant tape as needed and tighten connections securely.
- Install Sprayer Hose: Connect the pull-down sprayer hose to the quick-connect fitting on the faucet's underside. Ensure it clicks into place.
- Attach Weight: Install the hose weight onto the pull-down hose at the indicated position to ensure proper retraction of the sprayer head.
- Install Soap Dispenser: Insert the soap dispenser body into an available sink hole. Secure it from underneath with the provided nut. Fill the bottle with liquid soap and attach it to the dispenser pump from below the counter. The top lifts off for easy refills.
- Test for Leaks: Slowly turn on the main water supply and check all connections for leaks. Operate the faucet to ensure proper function.
Image: A diagram illustrating the dimensions of the Moen Arbor Faucet, including height, spout reach, maximum deck thickness, connection size, and indicating 1 or 3-hole installation with an optional deck plate.
Operating Instructions
- Water Flow and Temperature: The single handle controls both water flow and temperature. Lift the handle to turn on the water and adjust the flow. Move the handle left for hot water and right for cold water.
- Pulldown Sprayer: Grasp the sprayer head and pull it down from the spout. The Reflex system ensures smooth extension and secure docking when released.
- Spray Modes: The sprayer head typically features buttons to switch between aerated stream and powerful spray modes.
- Power Boost: Press the Power Boost button on the sprayer head to temporarily increase water flow for faster filling or more powerful rinsing. Release the button to return to normal flow.
- Soap Dispenser: Press down on the top of the soap dispenser to dispense liquid soap. Refill by lifting the top and pouring soap into the bottle from above the counter.
Image: A diagram detailing the Moen Reflex system, highlighting easy undocking, minimal resistance, easy spray setting changes, ergonomic spray wand, self-retracting action, and flexible hose for maneuverability.
Video: An official Moen brand video showcasing various Moen products and their features, including kitchen faucets, demonstrating their functionality and design.
Maintenance and Cleaning
- Spot Resist Stainless Finish: The Spot Resist Stainless finish is designed to resist fingerprints and water spots. Clean with a soft, damp cloth and mild soap. Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the finish.
- Sprayer Nozzles: If mineral deposits build up on the sprayer nozzles, gently rub them with your finger or a soft brush to dislodge the deposits.
- Soap Dispenser Refill: To refill the soap dispenser, simply lift the pump head from the top of the counter and pour liquid soap directly into the bottle. No need to go under the sink.
- General Cleaning: Regularly wipe down the faucet and dispenser with a soft cloth to prevent water spot accumulation and maintain its appearance.
Image: A close-up view demonstrating the Spot Resist Stainless finish on a Moen faucet, highlighting its ability to resist fingerprints and water spots for a cleaner look.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Low Water Flow | Aerator clogged with debris; partially closed shut-off valves. | Remove and clean the aerator. Ensure hot and cold water supply valves are fully open. |
| Leaks from Faucet Base | Loose mounting nut; worn O-rings. | Tighten the mounting nut under the sink. If problem persists, contact Moen support for replacement parts. |
| Sprayer Does Not Retract Fully | Hose weight improperly positioned or obstructed. | Check the position of the hose weight and ensure the hose path under the sink is clear of obstructions. |
| Soap Dispenser Clogged | Dried soap in the pump mechanism. | Remove the pump head and rinse it thoroughly with warm water. Pump warm water through the mechanism until clear. |
Specifications
- Brand: Moen
- Model Name: Arbor
- Model Number: 7594SRS (Internal Model Number: c60840ac-a1c1-4e72-8677-8dfc2470ccaf)
- Finish Type: Spot Resist Stainless (Brushed Nickel color)
- Material: Brass (Faucet Body), Stainless Steel (Handle)
- Mounting Type: Deck Mount
- Number of Handles: 1
- Hole Count: Designed for 1 or 3 holes (escutcheon included)
- Spout Design: Pull-out
- Special Feature: Pull Down Sprayer, Power Boost, Reflex System
- Soap Dispenser Capacity: 18 ounces
- Item Weight: Approximately 6.18 Pounds
Warranty and Support
This Moen product is backed by Moen's Limited Lifetime Warranty against leaks, drips, and finish defects to the original homeowner. For detailed warranty information, replacement parts, or technical assistance, please visit the official Moen website or contact Moen customer service directly. Keep your proof of purchase for warranty claims.
Moen Official Website: www.moen.com