Paul Neuhaus 720-12 LED Floor Lamp User Manual

1. Introduction

Thank you for choosing the Paul Neuhaus 720-12 LED Floor Lamp. This manual provides essential information for the safe and efficient use of your new lighting product. Please read these instructions carefully before assembly, installation, and operation, and retain them for future reference.

2. Safety Instructions

• Indoor Use Only: This product is designed for indoor use in dry locations. Do not expose to moisture or extreme temperatures.
• Electrical Safety: Ensure the power supply voltage matches the lamp's requirements. Always unplug the lamp from the power outlet before cleaning or performing any maintenance.
• Stable Placement: Place the lamp on a flat, stable surface to prevent tipping.
• No User Serviceable Parts: The LED panel is integrated and not replaceable by the user. Do not attempt to open or modify the lamp.
• Avoid Obstruction: Do not cover the lamp with any materials that could impede heat dissipation.
• Children and Pets: Keep the lamp out of reach of children and pets to prevent accidents.

3. Package Contents

Carefully unpack all components and check for any damage. If any parts are missing or damaged, contact your retailer immediately.

• 1 x Paul Neuhaus 720-12 LED Floor Lamp (golden finish)
• 1 x Integrated 27W 3000K LED panel (pre-installed)

4. Setup

1. Unpack: Carefully remove the lamp and all packaging materials from the box.
2. Position the Base: Place the lamp's base on a stable, level surface in your desired location. Ensure there is enough space around the lamp and that it will not be easily knocked over.
3. Connect Power: Insert the power plug into a standard, properly grounded electrical outlet. Ensure the cable is not pinched or placed where it could be a tripping hazard.

Image: Close-up view of the lamp's circular base, showing the power cord exiting from the side.

Image: The complete Paul Neuhaus 720-12 LED Floor Lamp, illustrating its full height and the discreet power cord.

5. Operating Instructions

1. Power On/Off: Once plugged in, locate the chain switch, typically positioned near the base or along the lamp's stem. Pull the chain to turn the lamp on or off.
2. Light Output: The integrated LED panel provides a warm white light at 3000 Kelvin.

Image: A detailed view of the lamp's base, showing the integrated LED light strip glowing brightly.

6. Maintenance

• Cleaning: Disconnect the lamp from the power supply before cleaning. Use a soft, dry, or slightly damp cloth to wipe the surfaces. Do not use abrasive cleaners, solvents, or harsh chemicals, as these can damage the finish.
• LED Panel: The LED panel is designed for long-term use and is not user-replaceable. If the LED light fails, the entire fixture may need professional servicing or replacement.
• Inspection: Periodically check the power cord and plug for any signs of damage. If damage is found, discontinue use and contact a qualified electrician or the manufacturer.

7. Troubleshooting

• Lamp Does Not Turn On:
  • Ensure the power plug is fully inserted into the electrical outlet.
  • Check if the wall outlet is functioning by plugging in another device.
  • Verify that the chain switch has been pulled to the 'on' position.
• Flickering Light:
  • Ensure the lamp is connected to a stable power supply.
  • If flickering persists, try plugging the lamp into a different outlet.

If these steps do not resolve the issue, please contact customer support.

8. Specifications

9. Warranty and Support

Paul Neuhaus products are manufactured with quality and durability in mind. For information regarding warranty terms and conditions, or if you require technical assistance, please contact your retailer or visit the official Paul Neuhaus website. Please have your model number (720-12) and proof of purchase ready when contacting support.