OXO Good Grips 2-in-1 Salt and Pepper Shaker User Manual

Product Overview

The OXO Good Grips 2-in-1 Salt and Pepper Shaker is designed for convenient seasoning with both salt and pepper from a single device. Its innovative design allows users to select between salt or pepper with a simple slide of a tab, and features a sealing mechanism to protect contents from humidity.

Features

• Combines salt and pepper dispensing in one tool.
• Sliding tab mechanism for easy selection between salt and pepper.
• Integrated seal protects salt and pepper from moisture and humidity.
• Removable silicone stoppers facilitate easy and clean refilling.
• Designed for kitchen-to-table use.
• Salt capacity: 85 g (3 oz.).
• Pepper capacity: 35 g (1.2 oz.).

Setup and Filling Instructions

1. Prepare for Filling: Ensure the shaker is empty and clean before refilling.
2. Access Filling Ports: Locate the removable silicone stoppers at the bottom of the shaker. Gently pull them out to expose the filling compartments.
3. Fill Compartments: Carefully pour salt into one compartment and pepper into the other. Avoid overfilling to ensure proper sealing.
4. Secure Stoppers: Reinsert the silicone stoppers firmly into their respective compartments to prevent spills and maintain freshness.

Operating Instructions

1. Select Seasoning: On the top of the shaker, locate the sliding tab. Slide the tab to the left for salt or to the right for pepper. The selected seasoning will be indicated by a small icon or marking.
2. Dispense Seasoning: Once the desired seasoning is selected, invert the shaker and gently shake to dispense.
3. Seal After Use: To seal the shaker and protect contents from humidity, slide the tab to the center position. This closes both dispensing openings.

Maintenance and Care

• Cleaning: To clean the shaker, disassemble by removing the silicone stoppers and the top mechanism. Wash all parts with warm, soapy water. Rinse thoroughly and allow to air dry completely before reassembling and refilling.
• Drying: Ensure all components, especially the internal mechanisms and silicone parts, are completely dry to prevent clumping of salt or pepper.
• Storage: Store the shaker in a cool, dry place with the tab in the center (sealed) position to maintain the freshness of the contents.

Troubleshooting

Issue: Salt or Pepper Not Dispensing Properly

If you experience difficulty dispensing salt or pepper, the internal silicone slits may be stuck together or partially blocked. This can occur due to moisture or fine particles.

Solution:

1. Empty the shaker of its contents.
2. Remove the top mechanism.
3. With the tab set to either the salt or pepper position, use a thin, non-sharp object (such as a toothpick or a straightened paperclip) to gently poke through the dispensing holes from the outside. This action helps to separate any stuck silicone slits or dislodge blockages.
4. Repeat for both salt and pepper sides.
5. Clean the shaker thoroughly as per the "Maintenance and Care" section, ensuring all parts are dry before refilling.

Specifications

Warranty and Support

For warranty information or product support, please refer to the official OXO website or contact their customer service directly. Keep your purchase receipt for any warranty claims.

You can visit the OXO Store on Amazon for more information.