PureGear Curved Tempered Glass Screen Protector for Samsung S8+

Introduction

This manual provides comprehensive instructions for the proper installation and care of your PureGear Curved Tempered Glass Screen Protector for the Samsung S8+. Following these steps will ensure optimal protection and clarity for your device's screen.

Image: PureGear Curved Tempered Glass Screen Protector packaging and product.

What's in the Box

• PureGear Curved Tempered Glass Screen Protector
• Perfect Alignment Tray
• Cleaning Kit (Alcohol wipe, Cleaning cloth)
• Roller/Squeegee Tool

Setup and Installation

Follow these steps carefully for a bubble-free installation. For visual guidance, please refer to the installation video below.

1. Clean Your Device: Use the provided alcohol wipe to thoroughly clean your Samsung S8+ screen. Ensure all smudges, fingerprints, and debris are removed.
2. Dry Your Device: Immediately follow with the cleaning cloth to dry the screen completely. It is crucial to remove all dust and debris to prevent air bubbles during installation.
3. Place Device in Alignment Tray: Open the Perfect Alignment Tray and carefully place your Samsung S8+ into it, ensuring it sits snugly.
4. Apply Screen Protector: Position the screen protector within the tray. Using the roller tool, slide it from the top to the bottom of the screen protector. You may feel slight resistance initially; continue pushing through until the backing liner is completely released and the protector adheres to the screen.
5. Remove Tabs 2 and 3: Carefully peel off tabs 2 and 3 from the alignment tray. As you peel, use the roller tool to push out any potential air bubbles that may form.
6. Final Bubble Removal: Once the screen protector is fully applied, use the roller tool or the cleaning cloth to gently rub out any remaining air bubbles. Tiny bubbles or haze will typically work themselves out within a couple of days.
7. Remove Phone from Tray: Gently push your phone out of the Perfect Alignment Tray.
8. Secure Curved Edges (if applicable): For curved phone models like the Samsung S8+, use the roller tool to roll down and over the edges of the screen protector to ensure it is fully secured to the curved display.

Operating Instructions

Your PureGear Curved Tempered Glass Screen Protector is designed to maintain the original touch screen sensitivity and clarity of your Samsung S8+. It features a glossy finish and is engineered for precise touch and swiping functionality. The protector is also case-friendly, allowing for compatibility with most phone cases.

Maintenance

To keep your screen protector clean and clear, gently wipe it with a soft, lint-free cloth. For stubborn smudges, a slightly damp cloth with water or a screen-safe cleaning solution can be used. Avoid harsh chemicals or abrasive materials, as these can damage the protector's surface.

Troubleshooting

• Air Bubbles: If small air bubbles remain after installation, gently push them towards the edges of the screen using the roller tool or a soft cloth. Most small bubbles will dissipate naturally within 24-48 hours. Larger bubbles often indicate dust particles; ensure thorough cleaning before re-application if necessary.
• Edges Not Sticking: For curved screens, ensure you have firmly rolled down the edges with the roller tool as described in the installation steps. Consistent pressure helps secure the adhesive.
• Reduced Touch Sensitivity: While designed for high sensitivity, if you experience issues, ensure the screen protector is perfectly aligned and free of debris. Some phone settings allow for increased touch sensitivity for screen protectors.

Specifications

Warranty and Support

For warranty information or further support, please refer to the official PureGear website or contact their customer service directly. Keep your purchase receipt for any warranty claims.