Lexon Slide Clock

Product Overview

The Lexon Slide Clock is a compact and intuitive digital alarm clock designed for portability and ease of use. It features a multi-function display showing time, alarm time, date, and indoor temperature. Its unique sliding mechanism allows for easy activation and deactivation of the alarm, while a touch-sensitive top surface controls the backlight and snooze function. The clock is equipped with a retractable stand for convenient placement.

Figure 1: Front view of the Lexon Slide Clock (Beige model) displaying current time, date, and temperature.

Setup

1. Battery Installation: The Lexon Slide Clock requires batteries for operation. Locate the battery compartment on the rear of the device. Insert the required batteries, ensuring correct polarity (+/-).
2. Initial Power-On: Once batteries are installed, the display should illuminate, showing default time settings.
3. Using the Retractable Stand: A retractable stand is located on the back of the clock. Gently pull it out to position the clock upright on a flat surface. Push it back in for compact storage or travel.
   

   Figure 2: Rear view with the retractable stand extended.

Operating Instructions

The Lexon Slide Clock features intuitive controls located on the rear of the device and a touch-sensitive top surface.

Setting Time and Date

1. Locate the SET, +HR, and +MIN buttons on the back of the clock.
   

   Figure 3: Rear view showing control buttons.

2. Press the SET button once to enter time setting mode. The hour digits will flash.
3. Use the +HR button to adjust the hour.
4. Press SET again to move to minute setting. The minute digits will flash.
5. Use the +MIN button to adjust the minutes.
6. Continue pressing SET to cycle through setting the date (month and day). Use +HR and +MIN to adjust.
7. Press SET one last time to exit setting mode.

Setting and Activating the Alarm

1. To set the alarm time, press and hold the SET button until the alarm time digits (usually smaller, below the main time) begin to flash.
2. Use the +HR and +MIN buttons to set your desired alarm time.
3. Press SET to confirm the alarm time.
4. To activate or deactivate the alarm, slide the screen of the clock to the right (to activate) or left (to deactivate). When activated, an alarm icon (e.g., "ALM") will appear on the display.
   

   Figure 4: Display showing activated alarm time.

Snooze and Backlight Function

• Snooze: When the alarm sounds, gently tap the top surface of the clock to activate the snooze function. The alarm will pause and sound again after a short interval (typically 5-10 minutes).
• Backlight: Tap the top surface of the clock to briefly illuminate the display backlight for better visibility in low light conditions.

Maintenance

• Cleaning: Wipe the clock's surface with a soft, dry cloth. Do not use abrasive cleaners or solvents, as they may damage the finish or display.
• Battery Replacement: Replace batteries when the display dims or functions become erratic. Always use the recommended battery type. Dispose of old batteries responsibly.
• Storage: If storing the clock for an extended period, remove the batteries to prevent leakage.

Troubleshooting

Specifications

Warranty and Support

For warranty information and customer support, please refer to the official Lexon website or contact their customer service department. Keep your purchase receipt as proof of purchase for any warranty claims.

You can visit the official Lexon store for more information: Lexon Store