Hunter Casablanca Universal Ceiling Fan Wall Control Switch

Product Overview

The Casablanca Wall Control provides four fan speeds and full-range light dimming for compatible ceiling fans. It features simple arrow buttons for fan and light control, along with a snap-on cover to conceal exposed screws for a clean appearance.

This wall control is designed for use with Hunter and Casablanca fans. For pull chain fans, the Casablanca Universal Receiver 99199 is required and sold separately. It is also compatible with new or existing Casablanca fans that have controls, excluding Hunter Original or DC fans.

Image: Installed Hunter Casablanca Universal Wall Control Switch, showing its sleek design on a wall.

Setup and Installation

Before installation, ensure the power to the ceiling fan circuit is turned off at the circuit breaker. This device requires two AAA batteries (not included) for operation.

Components Included:

• Wall control unit
• Wall plate
• Mounting screws
• Wire nuts

Image: Exploded view of the Hunter Casablanca Wall Control Switch components, including the control module, faceplate, screws, and wire nuts.

Installation Steps:

1. Power Disconnection: Turn off power at the main circuit breaker before beginning installation.
2. Wiring: Connect the wall control unit to the existing electrical wiring in your wall box. Ensure proper wire identification (e.g., hot wire) for correct functionality. Use the provided wire nuts for secure connections.
3. Battery Insertion: Insert two AAA batteries into the designated compartment within the wall control unit.
4. Mounting: Secure the wall control unit into the wall box using the provided screws.
5. Faceplate Attachment: Attach the decorative snap-on cover plate to conceal the mounting screws.
6. Power Restoration: Restore power at the circuit breaker.
7. Pairing: Follow the pairing instructions specific to your Hunter or Casablanca ceiling fan to link the wall control. This typically involves a sequence of button presses on the wall control after restoring power to the fan. If pairing multiple controls, ensure each is paired individually by cycling power to the fan between pairings.

Operating Instructions

The wall control features intuitive buttons for managing your ceiling fan and light.

Button Functions:

• Light Button (Bulb Icon): Toggles the light on or off.
• Light Dimming (Up/Down Arrows below Bulb Icon): Adjusts the brightness of dimmable lights. Press and hold to smoothly dim or brighten.
• Fan Speed (Up/Down Arrows below Star Icon): Cycles through four fan speed settings.
• Fan On/Off (Star Icon): Toggles the fan on or off.
• Power Button (Circle with Line Icon): Main power control for the unit.

Allow approximately one second between button presses for the receiver to register commands accurately. Some fans may exhibit a slight delay (around two seconds) for initial motor start-up.

Official Product Video:

Maintenance

The wall control unit is battery-powered. Regular maintenance primarily involves replacing the AAA batteries. Battery life can vary depending on usage, but it is recommended to replace them annually to ensure consistent performance and prevent potential issues from battery degradation.

To replace batteries, carefully remove the faceplate and then the control unit from the wall box to access the battery compartment. After replacing the batteries, re-secure the unit and faceplate.

Troubleshooting

• Control Not Responding:
  • Ensure batteries are correctly installed and not depleted. Replace if necessary.
  • Verify that the wall control is properly paired with your ceiling fan. Refer to the pairing instructions in the Setup section or your fan's manual.
  • Confirm power to the fan is on at the circuit breaker.
• Incorrect Functionality (e.g., light button controls fan):
  • This can indicate a pairing issue or incompatibility. Re-attempt the pairing process.
  • Ensure your fan model is compatible with the 99195 wall control. Some specific models, like the Casablanca Whitman 59062, may not function correctly despite general compatibility claims.
• Multiple Controls Interfering:
  • If you have multiple Hunter/Casablanca remote-controlled fans, ensure each wall control is paired individually to its respective fan. After pairing one control, unpair it (if applicable) or cycle power to the fan before pairing the next control to prevent cross-interference.
• Fan or Light Not Working After Wall Control Installation:
  • Check all electrical connections for secure wiring. Ensure the "hot" wire is correctly identified and connected.
  • If the fan previously used a pull chain, confirm that the Casablanca Universal Receiver 99199 is installed and correctly wired (sold separately).
  • In rare cases, internal fan components (like the circuit board) may fail independently of the wall control. If troubleshooting steps do not resolve the issue, consult a qualified electrician or the fan manufacturer.

Specifications

Warranty Information

This product comes with a 1-year limited warranty. Please retain your proof of purchase for warranty claims. For specific terms and conditions, refer to the warranty documentation included with your product or contact Hunter customer support.

Support

For further assistance, technical support, or to inquire about compatible accessories like the Casablanca Universal Receiver 99199, please contact Hunter customer service. Contact information can typically be found on the manufacturer's website or on the product packaging.

You can also visit the official Hunter Store for additional product information and resources: Hunter Store on Amazon.