Carver 237005 Steel Pan Instruction Manual

1. Introduction

This manual provides essential information for the safe and effective use of the Carver 237005 Steel Pan. This pan is specifically designed for fluid extraction applications when used in conjunction with a hydraulic press and test cylinder outfits.

The stainless steel construction ensures durability and compatibility with various fluids, capturing the released fluid during the pressing process.

2. Safety Information

Always observe standard laboratory and industrial safety procedures when operating equipment, including hydraulic presses. Failure to do so may result in injury or damage to equipment.

• Ensure the pan is clean and free of debris before each use.
• Verify the pan is correctly positioned within the hydraulic press setup to prevent spillage.
• Wear appropriate personal protective equipment (PPE), such as safety glasses and gloves, when handling samples and operating the press.
• Do not exceed the recommended pressure limits of your hydraulic press or test cylinder outfit.

3. Components

The Carver 237005 package includes the following item:

• 1x Carver 237005 Steel Pan

Figure 1: The Carver 237005 Steel Pan. This image shows the circular stainless steel pan with a slightly raised edge, designed to collect fluid during hydraulic pressing operations.

4. Setup

1. Inspect the Pan: Before first use and subsequent uses, inspect the steel pan for any signs of damage, corrosion, or deformation. Do not use a damaged pan.
2. Clean the Pan: Wash the pan thoroughly with an appropriate cleaning agent suitable for stainless steel and the type of fluid it will contain. Rinse well with distilled water and dry completely.
3. Position in Press: Place the Carver 237005 Steel Pan directly beneath the test cylinder outfit within your hydraulic press. Ensure it is centered and stable to effectively capture extracted fluid.
4. Prepare Sample: Prepare your sample and filter papers as required for your specific fluid extraction procedure.

5. Operating Instructions

The Carver 237005 Steel Pan functions as a collection vessel during fluid extraction processes using a hydraulic press.

1. Load Sample: Place the prepared sample, typically sandwiched between filter papers, into the test cylinder outfit according to the instructions for your specific hydraulic press and test cylinder.
2. Verify Pan Position: Double-check that the Carver 237005 Steel Pan is securely positioned beneath the test cylinder to catch all expelled fluid.
3. Initiate Pressing: Operate the hydraulic press according to its manufacturer's instructions to apply pressure to the sample. Fluid will be extracted and collected in the steel pan.
4. Monitor Collection: Observe the fluid collection in the pan. Ensure it does not overflow.
5. Conclude Operation: Once the extraction is complete, release the pressure from the hydraulic press.
6. Remove Pan: Carefully remove the pan containing the collected fluid.
7. Dispose/Process Fluid: Handle the collected fluid according to your laboratory's safety protocols and experimental requirements.

6. Maintenance

• Cleaning: After each use, thoroughly clean the pan to remove any residual fluids or sample material. Use appropriate cleaning agents and rinse thoroughly.
• Drying: Ensure the pan is completely dry before storage to prevent water spots or potential corrosion.
• Storage: Store the pan in a clean, dry environment, protected from dust and physical damage.
• Inspection: Periodically inspect the pan for any signs of wear, pitting, or damage. Replace if structural integrity is compromised.

7. Troubleshooting

8. Specifications

9. Warranty and Support

For specific warranty information and technical support regarding your Carver 237005 Steel Pan, please refer to the documentation provided with your purchase or contact Carver customer service directly.

Contact information can typically be found on the manufacturer's official website or on the product packaging.