Lorell 47921

Lorell Wellness by Design Executive Chair Model 47921 Instruction Manual

Model: 47921

Introduction

This manual provides essential information for the proper setup, operation, and maintenance of your Lorell Wellness by Design Executive Chair, Model 47921. Please read these instructions carefully before assembly and use to ensure optimal performance and safety.

Lorell Wellness by Design Executive Chair in an office setting

Image: The Lorell Wellness by Design Executive Chair, Model 47921, shown in a modern office environment with a desk and computer.

Important Safety Information

WARNING: Do not exceed the maximum weight capacity of 275 lb. Ensure proper assembly before use. Be cautious when using the tilting mechanism to avoid injury.

  • Always ensure all bolts and screws are securely tightened before use.
  • Do not stand on the chair.
  • Avoid placing heavy objects on the chair's backrest when reclined.
  • Keep hands and fingers clear of moving parts during adjustments.

Setup and Assembly

The Lorell Wellness by Design Executive Chair requires assembly. Please follow the included instructions for proper setup. Ensure all components are present before beginning assembly.

Detailed dimensions diagram for Lorell Executive Chair Model LLR47921

Image: A technical diagram illustrating the dimensions of the Lorell Executive Chair, Model LLR47921, in both centimeters and inches.

Assembly Tips:

  • Lay out all parts on a clean, soft surface to prevent scratches.
  • Do not overtighten screws during initial assembly; tighten fully once all parts are aligned.
  • Refer to the detailed assembly guide provided in the product packaging for step-by-step instructions.

Operating Instructions

1. Seat Height Adjustment

To adjust the seat height, locate the lever on the right side beneath the seat. Lift the lever to raise the seat. To lower the seat, lift the lever while seated. Release the lever at the desired height.

2. Tilt Function and Lock

The chair features a tilt mechanism allowing the backrest and seat to recline together. To enable tilting, pull out the lever on the left side beneath the seat. To lock the chair in an upright position, push the lever in. The tilt tension can be adjusted by rotating the knob located at the front center beneath the seat.

3. 360-Degree Swivel

The chair is designed with a 360-degree swivel function, allowing for easy rotation and movement without repositioning the base.

4. Flip-Up Armrests

The armrests can be flipped up to allow for closer access to a desk or to provide more space when not in use. Simply lift the armrests upwards until they lock into the vertical position. To lower them, gently pull them down.

Side view of Lorell Executive Chair showing the flip-up armrest mechanism

Image: A close-up side view of the Lorell Executive Chair, highlighting the design of the armrests and their pivot point for the flip-up function.

Maintenance

Cleaning Instructions:

The bonded leather upholstery of your chair should be spot cleaned. Use a soft, damp cloth with a mild soap solution. Avoid harsh chemicals or abrasive cleaners, as these can damage the material. Wipe dry immediately after cleaning.

General Care:

  • Regularly check and tighten all screws and bolts to ensure stability.
  • Avoid prolonged exposure to direct sunlight to prevent fading and cracking of the leather.
  • Keep sharp objects away from the upholstery to prevent punctures or tears.

Troubleshooting

1. Chair Sinks or Does Not Hold Height

This typically indicates an issue with the pneumatic gas lift cylinder. If the chair consistently sinks after adjustment, the cylinder may need replacement. Contact customer support for assistance.

2. Wheels Do Not Roll Smoothly

Check the casters for any accumulated debris such as hair or lint. Clean the wheels thoroughly. If the issue persists, the casters may need replacement.

3. Squeaking Noises

Squeaking can often be resolved by tightening all assembly bolts. If the noise continues, apply a small amount of silicone-based lubricant to moving parts and joints, avoiding contact with upholstery.

Specifications

FeatureDetail
BrandLorell
Model Number47921
ColorBlack
MaterialBonded Leather (Faux Leather), Foam Fill
Product Dimensions (D x W x H)27.7"D x 30"W x 46.7"H
Seat HeightAdjustable from 19.75" to 23.5"
Seat Depth18.5 inches
Backrest Width22.5 inches
Maximum Weight Recommendation275 Pounds
Special FeaturesArm Rest, Back Support, Head Support, High Back, Tilt Lock, 360-degree Swivel
Item Weight53 pounds

Warranty and Support

For information regarding product warranty or to obtain support for your Lorell Wellness by Design Executive Chair, please contact Lorell customer service directly. Refer to the contact information provided in your product packaging or on the official Lorell website.