Introduction
This manual provides instructions for the safe and effective use of your Coleman CPX 6 Classic XL 700 Lumens LED Lantern. Please read these instructions thoroughly before operating the lantern and retain them for future reference.
The Coleman CPX 6 Classic XL LED Lantern is designed for outdoor use, providing up to 700 lumens of light. It features an IPX4 waterproof rating, two light modes, and compatibility with the Coleman CPX 6 power system, allowing use with either D-cell batteries or a rechargeable power cartridge (sold separately).
Figure 1: Front view of the Coleman CPX 6 Classic XL 700 Lumens LED Lantern. This image shows the overall design, including the handle, clear globe, LED light source, and control knob at the base.
Setup
Power Source Installation
The lantern operates using either four (4) D-cell batteries or a Coleman CPX 6 rechargeable power cartridge (sold separately).
- Ensure the lantern is turned off.
- Locate the battery compartment at the bottom of the lantern.
- Twist the base counter-clockwise to unlock and remove it.
- For D-cell batteries: Insert four (4) D-cell batteries into the battery cartridge, observing the polarity markings (+/-).
- For CPX 6 rechargeable cartridge: Insert the fully charged CPX 6 rechargeable power cartridge into the compartment.
- Replace the base by aligning the tabs and twisting clockwise until securely locked.
Figure 2: Close-up view of the lantern's base, illustrating the control knob and the area where the battery compartment is accessed.
Operating Instructions
Turning On/Off and Mode Selection
The lantern features a rotary switch for power control and mode selection.
- Locate the rotary switch on the front of the lantern's base.
- Rotate the switch clockwise to the first detent for Low mode (140 lumens).
- Continue rotating the switch clockwise to the second detent for High mode (700 lumens).
- To turn the lantern off, rotate the switch counter-clockwise to the "OFF" position.
Figure 3: Detailed view of the control knob and mode indicators on the lantern's body.
Handle Usage
The large bail handle allows for easy carrying and hanging of the lantern.
- Use the handle to transport the lantern.
- Hang the lantern from a hook or branch for overhead illumination.
Figure 4: Top section of the lantern, highlighting the robust bail handle for carrying or hanging.
Maintenance
Cleaning
- Wipe the exterior of the lantern with a damp cloth. Do not use abrasive cleaners or solvents.
- Ensure the lantern is completely dry before storage or next use.
Storage
- For long-term storage, remove D-cell batteries to prevent leakage and corrosion.
- Store the lantern in a cool, dry place away from direct sunlight.
LED Light Source
The LED light source is designed for long life and does not require replacement.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Lantern does not turn on. |
|
|
| Light is dim. |
|
|
Specifications
- Model Number: 2000020936
- Light Source Type: LED
- Brightness: 700 Lumens (High), 140 Lumens (Low)
- Power Source: 4 x D-cell batteries or Coleman CPX 6 rechargeable cartridge (sold separately)
- Runtime: Up to 8 hours (High), Up to 60 hours (Low)
- Water Resistance: IPX4 (Water Resistant)
- Material: Polystyrene
- Dimensions (L x W x H): 8.3" x 8.4" x 13.2"
- Weight: 0.27 g (without batteries)
- Special Features: Glare reduction (textured tube), Large bail handle
Warranty Information
Coleman products are manufactured to high-quality standards. For specific warranty details, please refer to the warranty card included with your purchase or visit the official Coleman website. Keep your proof of purchase for any warranty claims.
Customer Support
For further assistance, product information, or to purchase accessories, please visit the official Coleman website or contact Coleman customer service.
Official Website: www.coleman.com
(Note: Specific contact numbers or email addresses may vary by region. Please check the website for the most current information.)
