Green Valley SK-X715 Magnetic Ski and Snowboard Carrier User Manual

1. Introduction

This manual provides essential instructions for the safe and effective use of your Green Valley SK-X715 Magnetic Ski and Snowboard Carrier. This carrier is designed for transporting up to 3 pairs of skis (including carving skis) or 2 snowboards on the roof of your vehicle. Please read all instructions carefully before installation and use to ensure proper operation and safety.

2. Safety Information

• Always ensure the magnetic plates are clean and free of debris before attachment to guarantee maximum adhesion.
• Verify the carrier is securely attached to the vehicle roof before each journey and periodically during long trips.
• Do not exceed the maximum speed limit recommended by the vehicle manufacturer or local traffic laws when the carrier is loaded.
• Ensure skis and snowboards are properly secured within the carrier's clamps and the anti-theft mechanisms are engaged.
• Avoid sudden braking or sharp turns when the carrier is loaded.
• The carrier is compliant with ISO/PAS 11154:2006 and has passed CITY CRASH TEST standards.

3. Setup and Installation

The Green Valley SK-X715 utilizes strong magnetic plates for attachment to your vehicle's roof. Its design accommodates particularly rounded roofs.

1. Clean the vehicle roof surface where the carrier will be placed. Ensure it is dry and free of dust, dirt, or wax.
2. Carefully place the magnetic carrier onto the desired position on the roof. The special protection on the magnetic plates prevents damage to your vehicle's paintwork.
3. Press down firmly on the carrier to ensure full contact and strong adhesion of the magnetic plates to the roof.
4. Verify that the carrier is stable and cannot be easily dislodged by hand.

Image 1: Green Valley SK-X715 Magnetic Ski and Snowboard Carrier shown installed on a vehicle roof, demonstrating its low profile and secure magnetic attachment.

4. Operating Instructions

Once the carrier is securely installed on your vehicle, you can load your skis or snowboards.

1. Open the carrier's clamping mechanisms.
2. Place your skis or snowboards into the designated slots. Ensure they are evenly distributed and do not obstruct your view or vehicle's antennas.
3. Close the clamping mechanisms firmly until they lock into place.
4. Engage the double anti-theft system for both the skis/snowboards and the carrier itself to prevent unauthorized removal.
5. Before driving, gently tug on the skis/snowboards and the carrier to confirm everything is tightly secured.

5. Maintenance

Regular maintenance ensures the longevity and safe operation of your ski and snowboard carrier.

• After each use, especially after exposure to snow, salt, or dirt, clean the carrier with mild soap and water. Rinse thoroughly and dry completely.
• Inspect the magnetic plates for any signs of wear, damage, or embedded debris. Clean them as needed.
• Check all moving parts, clamps, and locking mechanisms for smooth operation. Lubricate if necessary with a silicone-based lubricant.
• Store the carrier in a dry place when not in use.

6. Troubleshooting

• Issue: Carrier does not adhere securely.
  Solution: Ensure the vehicle roof and magnetic plates are perfectly clean and dry. Remove any wax, dirt, or ice. Reposition the carrier to a flatter section of the roof if possible.
• Issue: Difficulty closing clamping mechanisms.
  Solution: Ensure skis/snowboards are correctly positioned and not overlapping. Check for any obstructions in the clamping area.
• Issue: Anti-theft lock is stiff.
  Solution: Apply a small amount of graphite lubricant to the lock mechanism. Ensure the key is fully inserted and turned correctly.

7. Specifications

8. Warranty and Support

For warranty information or technical support, please refer to the documentation provided with your purchase or contact Green Valley customer service directly. Keep your proof of purchase for any warranty claims.