1. Product Overview
The ECHOGEAR SlimView TV Wall Mount provides a secure and minimalist solution for mounting your television. Its low-profile design ensures your TV sits close to the wall, enhancing the aesthetic of your living space. This manual provides detailed instructions for proper installation and use.
2. Installation Guide
Follow these steps carefully to ensure a safe and secure installation of your ECHOGEAR SlimView TV Wall Mount.
2.1. Official Installation Video
For a visual guide, please watch the official installation video below:
An official installation video demonstrating the step-by-step process for mounting the ECHOGEAR SlimView TV Wall Mount. This video covers unboxing, attaching TV brackets, assembling and securing the wall plate, and finally hanging the television.
2.2. Package Contents
Before beginning, verify that all components are present in your package:
2.3. Attaching TV Brackets
Securely attach the vertical TV brackets to the back of your television using the appropriate screws from the hardware kit. Ensure they are aligned with your TV's VESA mounting holes.
2.4. Wall Plate Assembly and Mounting
Assemble the wall plate components if necessary, then mark and drill pilot holes on your wall. Secure the wall plate to the wall using the provided lag bolts. This mount is compatible with:
- 16-inch wood studs
- 24-inch wood studs
- Poured concrete walls
- Concrete block walls
2.5. Hanging the Television
Carefully lift your television and hook the TV brackets onto the top edge of the wall plate. Gently lower the TV until the brackets engage with the bottom of the wall plate, securing it in place. Listen for an audible 'click' to confirm the security system is engaged.
2.6. VESA Compatibility
This mount supports the following VESA patterns:
- 200x100
- 200x200
- 300x200
- 300x300
- 400x200
- 500x200
- 400x300
- 400x400
- 500x400
- 600x400
3. Operation
3.1. Accessing Cables
To access cables behind your television, utilize the quick-release pull strings located at the bottom of the TV brackets. Pulling these strings will disengage the TV from the wall plate, allowing you to tilt the TV forward for cable management without fully removing it from the wall.
3.2. Cable Management
For a tidy installation, consider using ECHOGEAR cable management accessories to route and conceal your television's cables.
4. Maintenance
To ensure the long-term stability and safety of your TV mount, periodic maintenance is recommended:
- Check Connections: Annually inspect all screws and bolts securing the mount to the wall and the TV to the mount. Tighten any that may have loosened over time.
- Clean Surfaces: Use a soft, dry cloth to clean the mount. Avoid abrasive cleaners or solvents.
- Inspect for Damage: Regularly check for any signs of wear, corrosion, or damage to the mount components. If any damage is found, contact ECHOGEAR customer support immediately.
5. Troubleshooting
If you encounter any issues during or after installation, refer to the following common troubleshooting tips:
- TV Not Level: Ensure the wall plate is perfectly level before drilling. Some mounts allow for minor post-installation leveling adjustments. If not, you may need to re-adjust the wall plate.
- Difficulty Hanging TV: Ensure the TV brackets are correctly aligned with the wall plate. Two people are recommended for safely lifting and hanging the TV.
- Cables Difficult to Access: The low-profile design means limited space behind the TV. Utilize the pull-string release mechanism to tilt the TV forward for better access. Consider using right-angle HDMI adapters if space is extremely tight.
- Mount Feels Loose: Immediately remove the TV and re-check all wall and TV connections. Ensure lag bolts are securely fastened into studs or appropriate concrete anchors. Do not re-hang the TV until the mount is completely stable.
If problems persist, please contact ECHOGEAR customer support for assistance.
6. Product Specifications
| Specification | Detail |
|---|---|
| Brand Name | ECHOGEAR |
| Item Weight | 6.97 pounds |
| Product Dimensions | 2.3 x 10.75 x 17.85 inches |
| Item Model Number | EGLL1-BK |
| Color | Original |
| Material | Alloy Steel |
| Mounting Type | Wall Mount |
| Movement Type | Fixed |
| Maximum Compatible Size | 80 Inches |
| Minimum Compatible Size | 32 Inches |
| Compatible Devices | Television |
| UPC | 793795531421 |
| Date First Available | September 27, 2016 |
7. Warranty and Support
ECHOGEAR stands behind the quality of its products. This TV wall mount comes with a 5-year warranty.
For any questions, technical assistance, or warranty claims, please contact our US-based customer support team. Our experts are available 7 days a week to provide assistance.
Customer Support Phone: 1-855-428-2490
You can also refer to the full Installation Manual (PDF) for more detailed information: Download PDF Manual
