Bosch Serie 4 WTH85208IT Condensation Dryer 8kg A++ User Manual

1. Introduction

This manual provides essential instructions for the safe and efficient operation, installation, and maintenance of your Bosch Serie 4 WTH85208IT condensation dryer. Please read this manual thoroughly before using the appliance and keep it for future reference.

The Bosch WTH85208IT is an 8kg capacity, A++ energy-rated condensation dryer designed for household use. It features a front-loading design and various drying programs to suit different fabric types.

Figure 1: Front view of the Bosch Serie 4 WTH85208IT condensation dryer. This image displays the appliance's white exterior, front-loading door, control panel with a rotary dial and digital display, and the lower ventilation grille.

2. Safety Information

Always adhere to the following safety guidelines to prevent personal injury or damage to the appliance.

• Read all instructions before use.
• Do not allow children to play with the appliance.
• Ensure the appliance is properly earthed.
• Do not dry unwashed items in the tumble dryer.
• Items soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer.
• Remove all objects from pockets such as lighters and matches.

3. Setup and Installation

3.1 Unpacking

• Carefully remove the dryer from its packaging.
• Inspect the appliance for any transport damage.
• Remove all packaging materials, including polystyrene blocks and protective film.

3.2 Positioning

• Place the dryer on a firm, level surface.
• Ensure adequate ventilation around the appliance. Do not block the ventilation openings.
• Avoid installing the dryer in rooms where there is a risk of frost.

3.3 Electrical Connection

• Connect the appliance to an earthed socket.
• Ensure the voltage and frequency match the specifications on the rating plate.
• Do not use extension cords or multi-plugs.

3.4 Condensate Drain Connection (Optional)

The dryer collects condensed water in a container. For continuous drainage, you can connect the appliance to a drain hose.

1. Locate the condensate drain hose at the back of the dryer.
2. Remove the hose from its holder.
3. Connect the hose to a suitable drain pipe or siphon.
4. Ensure the hose is not kinked or blocked.

4. Operating Instructions

4.1 Before First Use

• Wipe the drum with a damp cloth to remove any dust from manufacturing.
• Run a short drying cycle with a damp cloth to clean the interior.

4.2 Loading Laundry

• Sort laundry by fabric type and desired dryness level.
• Do not overload the dryer. Refer to the maximum load capacity of 8kg.
• Close the door firmly.

4.3 Selecting a Program

1. Turn the program selector dial to choose the desired drying program (e.g., Cotton, Synthetics, Delicates, Sportswear).
2. The display will show the estimated drying time.
3. Adjust additional options if available (e.g., dryness level, anti-crease, low heat).

4.4 Starting and Ending a Program

• Press the "Start/Pause" button to begin the drying cycle.
• The dryer will automatically stop when the program is complete.
• Open the door and remove the laundry.

5. Maintenance and Cleaning

5.1 Cleaning the Lint Filter

The lint filter must be cleaned after every drying cycle to ensure efficient operation and prevent fire hazards.

1. Open the dryer door.
2. Pull out the lint filter.
3. Remove any lint by hand or with a soft brush.
4. Rinse the filter under running water if heavily soiled.
5. Reinsert the clean filter.

5.2 Emptying the Condensate Container

If not connected to a drain, the condensate container must be emptied after each drying cycle.

1. Pull out the condensate container.
2. Pour out the collected water.
3. Push the container back into place until it clicks.

5.3 Cleaning the Heat Exchanger/Condenser

The heat exchanger should be cleaned periodically (e.g., every few months) to maintain energy efficiency.

1. Ensure the appliance is switched off and unplugged.
2. Open the service flap at the bottom left of the dryer.
3. Release the locking levers and pull out the heat exchanger.
4. Rinse the heat exchanger thoroughly under running water.
5. Clean any lint from the seals.
6. Reinsert the heat exchanger and close the service flap securely.

5.4 Cleaning the Appliance Exterior

Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners or solvents.

6. Troubleshooting

If the problem persists after attempting these solutions, please contact customer service.

7. Technical Specifications

• Model: WTH85208IT
• Brand: Bosch
• Type: Condensation Dryer
• Capacity: 8 kg
• Energy Efficiency Class: A++
• Dimensions (H x W x D): 84.2 cm x 59.8 cm x 59.9 cm
• Weight: 53 kg
• Noise Level: 65 dB
• Power Supply: 220-240V, 50Hz
• ASIN: B01KT6KBMG
• GTIN: 04242002962078

Figure 2: Energy label for the Bosch Serie 4 WTH85208IT dryer. This label indicates an A++ energy efficiency rating, an annual energy consumption of 236.0 kWh, a cycle time of 203 minutes, an 8.0 kg capacity, and a noise level of 65 dB.

8. Warranty and Support

Your Bosch WTH85208IT dryer comes with a manufacturer's warranty. Please refer to the separate warranty document provided with your purchase for specific terms and conditions, including warranty period and coverage details.

For technical assistance, spare parts, or to schedule a service appointment, please contact Bosch customer service. You can find contact information on the official Bosch website or in the warranty documentation.

When contacting support, please have your appliance's model number (WTH85208IT) and serial number ready. The serial number is typically located on a sticker inside the dryer door or on the back of the appliance.