1. Introduction
This service manual provides detailed information, procedures, and specifications for the maintenance, diagnosis, and repair of 1997 and 1998 Honda CR-V models. It is intended for qualified technicians and individuals with a thorough understanding of automotive systems and repair practices. Adherence to these instructions is crucial for safe and effective vehicle servicing.

Image 1: Publication details from the service manual, indicating it was published by Honda Motor Co., Ltd., with copyright information for 1998, part number 61S1001, and a note about being made from 50% recycled paper.
2. Safety Precautions
Always observe standard automotive safety practices when performing any service or repair. This includes, but is not limited to:
- Wearing appropriate personal protective equipment (PPE) such as safety glasses and gloves.
- Disconnecting the battery negative terminal before working on electrical components.
- Ensuring the vehicle is securely supported on jack stands when working underneath.
- Allowing engine and exhaust components to cool before servicing.
- Working in a well-ventilated area, especially when dealing with fluids or fumes.
3. General Information
This section covers general vehicle information, including identification numbers, lifting points, and basic specifications common to all systems. Refer to specific sections for detailed component specifications.
4. Scheduled Maintenance
Regular maintenance is essential for the longevity and performance of your Honda CR-V. This section outlines recommended service intervals and procedures for:
- Oil and filter changes
- Fluid level checks and replacements (transmission, brake, power steering, coolant)
- Tire rotation and inspection
- Brake system inspection
- Spark plug replacement
- Air filter inspection and replacement
5. Engine System
Detailed procedures for engine diagnosis, removal, installation, and overhaul are provided here. This includes cylinder head, block, crankshaft, camshaft, and valve train components. Specific torque specifications and special tool requirements are also covered.
6. Electrical System
This section contains comprehensive information on the vehicle's electrical components, including wiring diagrams, circuit descriptions, and diagnostic procedures for various systems such as charging, starting, lighting, and ignition.

Image 2: An internal page from the service manual detailing the "Ignition Control Module (ICM) Input Test." The image displays a wiring diagram with labeled wires (BLU, WHT/BLU, YEL/GRN, BLK/YEL) and step-by-step instructions for checking voltage and resistance, indicating diagnostic procedures for the ignition system.
6.1 Ignition Control Module (ICM) Input Test
- Remove the distributor ignition (DI) cap, the distributor ignition (DI) rotor, and the leak cover.
- Disconnect the wires from the ICM.
- Turn the ignition switch ON (II). Check for voltage between the BLK/YEL wire and body ground. There should be battery voltage.
- If there is no battery voltage, check the BLK/YEL wire between the under-dash fuse/relay box and the ICM.
- If there is battery voltage, go to step 4.
- Turn the ignition switch ON (II). Check for voltage between the WHT/BLU wire and body ground. There should be battery voltage.
- If there is no battery voltage, check:
- the ignition coil,
- the WHT/BLU wire between the ignition coil and the ICM.
- If there is battery voltage, go to step 5.
- If there is no battery voltage, check:
7. Troubleshooting
This section provides diagnostic charts and procedures to identify the root cause of common vehicle malfunctions. It guides technicians through systematic checks based on symptoms reported by the vehicle owner or observed during inspection.
8. Specifications
Detailed technical specifications for all major components and systems are listed here. This includes torque values, fluid capacities, electrical resistances, and dimensional tolerances necessary for proper assembly and adjustment.