Product Overview
The Flytec Element Speed is a sophisticated flight instrument designed to provide pilots with essential information for safe and efficient flight. It helps you understand the surrounding air conditions in all directions, focusing on horizontal movement and its influencing factors.
Key features include:
- Unique Flytec quality with altimeter and climb/sink display.
- Ground speed and current glide ratio.
- Wind direction and wind speed.
- Launch distance and direction, up to the last thermal.
- Vario profiles.
Figure 1: Flytec Element Speed device. The display shows an altitude of 2735m, ground speed of 4.2 km/h, time 13:09:18, and wind speed of 8 km/h from the South. Below the display are four control buttons: MENU/OK, SET A1/2, A3/CLR, and a speaker/return button.
Setup Guide
1. Initial Power On
- Ensure the device has sufficient power. This model does not include batteries, so ensure compatible batteries are installed.
- Press and hold the power button (usually integrated with the MENU/OK button or a dedicated side button) until the display illuminates.
- The device will perform a self-test and then display the main flight screen.
2. Basic Configuration
- Language Setting: Navigate to the 'Settings' menu using the MENU/OK button. Select 'Language' and choose your preferred language.
- Unit Setting: In the 'Settings' menu, select 'Units' to configure altitude (meters/feet), speed (km/h, mph, knots), and temperature units.
- Time and Date: Set the correct time and date. The device may automatically synchronize with GPS once a signal is acquired.
- Altimeter Calibration: For accurate altitude readings, calibrate the altimeter before each flight. This can be done manually by entering a known altitude or automatically via GPS. Refer to the 'Operating Instructions' for detailed calibration steps.
Operating Instructions
1. Main Display Overview
The main display provides real-time flight data. Key indicators include:
- Altitude (ALTI): Current altitude above sea level or ground.
- Climb/Sink Rate (Vario): Vertical speed, indicating ascent or descent.
- Ground Speed (GND): Horizontal speed over the ground.
- Glide Ratio: The ratio of horizontal distance covered to vertical distance lost.
- Wind: Displays wind direction and speed.
- Time: Current time.
2. Button Functions
- MENU/OK: Press briefly to access menus or confirm selections. Hold to power on/off or access advanced settings.
- SET A1/2: Used for setting Altimeter 1 and Altimeter 2, or for navigating through menu options.
- A3/CLR: Used for setting Altimeter 3, clearing data, or navigating through menu options.
- Speaker/Return Button: Activates/deactivates audio vario, or acts as a 'back' button in menus.
3. Pre-Flight Checks
- Verify battery level.
- Ensure GPS signal acquisition.
- Calibrate altimeter to local QNH or known elevation.
- Check vario sound settings.
4. During Flight
- Monitor altitude, climb/sink rate, and ground speed.
- Use wind information to optimize flight path.
- Observe glide ratio for efficient cross-country flying.
- The device automatically records flight data for post-flight analysis.
Maintenance
- Cleaning: Wipe the device with a soft, damp cloth. Do not use abrasive cleaners or solvents. Ensure the device is dry before storage.
- Storage: Store the Element Speed in a cool, dry place away from direct sunlight and extreme temperatures. If storing for extended periods, remove batteries to prevent leakage.
- Battery Replacement: Replace batteries as needed. Refer to the specifications for compatible battery types.
- Software Updates: Periodically check the official Flytec website for firmware updates to ensure optimal performance and access to new features.
Troubleshooting
| Issue | Possible Cause | Solution |
|---|---|---|
| Device does not power on. | Low or depleted batteries; incorrect battery installation. | Replace batteries with fresh ones. Ensure batteries are inserted with correct polarity. |
| No GPS signal. | Obstructed view of the sky; device indoors. | Move to an open area with a clear view of the sky. Wait a few minutes for signal acquisition. |
| Inaccurate altitude readings. | Altimeter not calibrated; rapid weather changes. | Calibrate the altimeter to a known altitude or local QNH before flight. Recalibrate if weather conditions change significantly. |
| Vario sound not working. | Audio vario disabled; volume too low. | Check settings to ensure audio vario is enabled. Adjust volume using the appropriate button or menu option. |
Specifications
| Feature | Detail |
|---|---|
| Brand | Flytec |
| Model Name | Flytec Element Speed |
| Product Model Number | 4330257691 |
| UPC | 634392669080 |
| Package Dimensions | 22.86 x 22.86 x 10.16 cm |
| Batteries Included | No |
| Battery Usage | Requires batteries (not included) |
| First Available Date | 2016/08/19 |
| ASIN | B01IU8FQ70 |
Warranty Information
The Flytec Element Speed is covered by a manufacturer's warranty. For specific details regarding warranty duration, coverage, and terms, please refer to the official Flytec website or the documentation provided with your purchase. Keep your proof of purchase for warranty claims.
Customer Support
For technical assistance, troubleshooting beyond this manual, or general inquiries, please visit the official Flytec website. You may find FAQs, additional resources, and contact information for customer service there.
Official Flytec Website: www.flytec.com (Note: This is a placeholder URL. Please refer to your product packaging or official documentation for the correct support website.)
