Sonic Alert 120/220 Volt Travel Size Alarm Clock/Bed Shaker

Introduction

This manual provides detailed instructions for the setup, operation, and maintenance of your Sonic Alert 120/220 Volt Travel Size Alarm Clock with Super Shaker. Please read this manual thoroughly before using the product to ensure proper function and longevity.

An image showing the Sonic Alert alarm clock with a green digital display showing '8:16', connected to a white circular Super Shaker bed vibrator. The clock features control buttons on top and a volume knob on the side.

Setup

1. Unpacking: Carefully remove all components from the packaging. Verify that you have the alarm clock unit, the Super Shaker vibrating unit, and the power cord.
2. Power Connection: Connect the power cord to the alarm clock and then plug it into a standard electrical outlet. This alarm clock is designed to operate on both 120V and 220V systems, making it suitable for international travel.
3. Battery Backup Installation: For battery backup, install a 9-volt battery (not included) into the battery compartment located on the bottom of the unit. This backup maintains time and alarm settings for up to one week during power outages.
4. Connecting the Super Shaker: Plug the Super Shaker vibrating unit's cord into the designated jack on the back of the alarm clock. Place the Super Shaker under your pillow or mattress for effective vibration.
5. Initial Time Setting: Upon first power-up, the display may flash. Refer to the 'Operating Instructions' section to set the current time.

Operating Instructions

• Setting Time (12/24-Hour Format):
  Press and hold the TIME button. While holding, use the FAST and SLOW buttons to adjust the hours and minutes. Release the TIME button when the correct time is displayed. To switch between 12-hour and 24-hour formats, press the 12/24 HR button.
• Setting Alarms (AL1, AL2):
  This unit features dual alarms. Press and hold the AL. SET button for Alarm 1 (AL1) or Alarm 2 (AL2). While holding, use the FAST and SLOW buttons to set the desired alarm time. Release the AL. SET button. To activate an alarm, slide the corresponding AL1 or AL2 switch to the desired mode (VIB/BUZZ, VIB, BUZZ).
• Adjusting Alarm Duration:
  The alarm duration can be set from 1 minute to 59 minutes. Consult the full manual for specific button sequences, typically involving the AL. SET button and time adjustment buttons.
• Adjusting Snooze Time:
  The snooze time can be selected from 1 minute to 30 minutes. Press the SNOOZE button during an active alarm to temporarily silence it for the set duration.
• Alarm Modes:
  Use the slide switch on the side of the unit to select the alarm mode for each alarm (AL1 and AL2):
  • VIB/BUZZ: Activates both vibration and audible alarm.
  • VIB: Activates vibration only.
  • BUZZ: Activates audible alarm only.
  • OFF: Disables the alarm.
• Volume Adjustment:
  Rotate the VOL knob located on the side of the unit to adjust the audible alarm volume.
• Dimmer Function:
  Press the 5-LEVEL DIMMER button to cycle through five brightness levels for the display.

Maintenance

• Cleaning: Disconnect the power cord before cleaning. Use a soft, dry cloth to wipe the unit. Do not use liquid cleaners or abrasive materials.
• Battery Replacement: Replace the 9-volt battery in the backup compartment annually or if the display flashes during a power outage, indicating low battery.

Troubleshooting

• Alarm Not Sounding/Vibrating:
  • Ensure the alarm is activated and the mode switch is not set to OFF.
  • Check if the Super Shaker is properly connected.
  • Verify the volume knob is turned up for audible alarms.
• Display Not Working:
  • Check if the power cord is securely plugged into an active outlet.
  • If using battery backup, ensure the battery is fresh and correctly installed.
• Incorrect Time Display:
  • Reset the time as per the 'Setting Time' instructions.
  • If the time consistently loses accuracy, consider replacing the backup battery.

Specifications

• Alarm Loudness: 113dB extra-loud alarm
• Power Source: Corded Electric (120/220 Volt compatible), Battery Powered (9V for backup)
• Display Type: Digital, Jumbo Size
• Alarm Features: Dual alarm, adjustable tone & volume, selectable snooze (1-30 min), selectable alarm duration (1-59 min)
• Time Formats: 12-hour / 24-hour
• Energy Efficiency: Green technology uses 60% less energy
• Dimmer: 5-level dimmer function
• Included: Power cord, Super Shaker vibrating unit

Warranty and Support

This Sonic Alert product is covered by a 1-year Sonic Alert blastproof warranty. For warranty claims or technical support, please contact Sonic Alert directly. Do not attempt to open the unit or remove any labels, as this may void the warranty. There are no user-serviceable parts inside.

For further assistance, please visit the official Sonic Alert website or refer to the contact information provided with your product packaging.