1. Important Safety Information
Read and understand all instructions before installing or operating this appliance. Failure to follow these instructions could result in property damage, personal injury, or death.
General Safety Precautions:
- Ensure proper ventilation when operating the unit.
- Do not use Teflon tape between the gas regulator and the inlet pipe to avoid improper operation.
- Always check for gas leaks after connecting the gas supply.
- Keep flammable materials away from the water heater.
- This appliance is designed for outdoor use. If installed indoors, a flue pipe or duct and adequate ventilation are required.
Integrated Safety Protections:
The CAMPLUX BW422 is equipped with multiple safety features:
- Overheat Protection: Automatically shuts off gas supply if water temperature exceeds 167 ℉ (75 ℃).
- Dry Combustion Protection: Prevents operation without water flow.
- Anti-Freezing Protection: The drain plug allows for complete water drainage to prevent freezing damage in cold environments.
- Low Water Flow Protection: Ensures the unit only operates with sufficient water pressure (4.0-110 PSI).
- Flame Failure Protection: Automatically cuts off gas if the flame extinguishes.
- High Water Pressure Protection: Designed to operate safely within specified water pressure limits.

Figure 1: CAMPLUX BW422 6-in-1 Safety Protection Features
2. Product Overview
The CAMPLUX BW422 is an outdoor tankless propane water heater designed to provide instant hot water for various applications such as camping, remote cabins, tiny houses, and mobile homes. It offers a high flow rate and efficient heating performance.

Figure 2: CAMPLUX BW422 Tankless Water Heater
Key Features:
- Instant Hot Water: Delivers up to 4.22 gallons per minute (16L) of hot water.
- High Heat Output: 110,000 BTU/hour for efficient heating.
- Wide Water Pressure Range: Activates with water pressure between 4.0-110 PSI.
- User-Friendly Interface: Features an LED display and ECO/FULL knob for temperature control.

Figure 3: Performance Specifications
3. What's in the Box
The CAMPLUX BW422 package includes the following components:
- 1x CAMPLUX BW422 Tankless Water Heater
- 1x 5 feet CSA Certified Gas Regulator
- 1x 5 feet On/Off Switch Shower Head
- 1x 1/2" BSP Female * 3/4" GHT Male Garden Hose Adapter
- 1x 1/2" BSP Female to 5/8" NPT Male Flare Adapter
- Hardware Pack (for mounting)
- User Manual

Figure 4: Included Components
4. Installation Guide
Follow these steps for proper installation of your CAMPLUX BW422 water heater. Ensure all connections are secure and leak-free.
Step 1: Wall-Mounted Installation
Drive nails or screws into the wall at the desired location, then hang the water heater securely.

Figure 5: Wall-Mounted Installation
Step 2: Connect Water Supply
Connect a water hose (not provided) to the cold water inlet of the unit. Ensure a tight connection.

Figure 6: Water Supply Connection
Step 3: Connect Water Outlet
Connect the provided shower kit to the water outlet. Tighten the fitting, ensuring the gasket is properly seated to prevent leaks.

Figure 7: Water Outlet Connection
Step 4: Connect Gas Supply
Connect the 5-foot CSA certified gas regulator to a 20lb propane tank and then to the gas inlet on the water heater. Check all gas connections for leaks using a soapy water solution.

Figure 8: Gas Supply Connection
Step 5: Insert Batteries
Open the battery compartment and insert two D batteries. Ensure the battery polarity is correct (+/-) as indicated inside the compartment.

Figure 9: Battery Installation
5. Operation
Once installed, operating the CAMPLUX BW422 is straightforward.
Controls:

Figure 10: Control Panel and Drain Plug
- LED Display: Shows the current water temperature.
- Water Flow Knob (Blue): Adjusts the water flow rate. Higher flow rates may result in cooler water, while lower flow rates allow for hotter water.
- Gas Flow Knob (Red): Adjusts the gas supply to the burner, controlling the flame intensity and thus the water temperature.
- ECO/FULL Knob: Selects between two heating modes.
Heating Modes:
- ECO Mode: Utilizes fewer burners for energy efficiency, suitable for warmer climates or when less hot water is needed.
- FULL Mode: Activates all burners for maximum heat output, ideal for colder climates or when higher water temperatures are desired.

Figure 11: ECO vs. FULL Mode
Starting the Unit:
- Ensure the gas supply is open and batteries are correctly installed.
- Turn on the water supply. The unit requires a minimum water pressure of 4.0 PSI to activate.
- Adjust the water flow and gas knobs to achieve the desired temperature. The LED display will show the current output temperature.
6. Maintenance
Regular maintenance ensures the longevity and efficient operation of your water heater.
Draining for Cold Climates:
If the water heater is stored in a cold climate, it must be properly drained to prevent freeze damage to the heat exchanger or water valves. To drain:
- Disconnect all incoming and outgoing water lines.
- Open the drain plug located at the bottom right of the water heater by turning it counter-clockwise.
- Allow all residual water to drain completely.
- When not in use for extended periods, fully disconnect gas, incoming, and outgoing waterlines. Store the unit in a warm, dry place.
General Cleaning:
- Periodically inspect the exterior for dirt or debris and clean with a damp cloth.
- Check the water inlet filter screen for blockages and clean if necessary.
7. Troubleshooting
If you encounter issues with your water heater, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| No hot water / Unit does not ignite | Low water pressure No gas supply Dead or incorrectly installed batteries Flame failure protection activated | Ensure water pressure is between 4.0-110 PSI Check propane tank and gas connections Replace batteries and verify polarity Check gas connections and ensure proper ventilation |
| Water is not hot enough | High water flow rate Gas flow knob set too low ECO mode selected in cold conditions | Reduce water flow using the blue knob Increase gas flow using the red knob Switch to FULL mode for maximum heat output |
| Unit shuts off unexpectedly | Overheat protection activated Low water flow Gas supply interrupted | Check water temperature and flow Ensure adequate water pressure Verify continuous gas supply |
| Water fittings leak | Loose connections Damaged gaskets | Tighten all water connections Inspect and replace any damaged gaskets |
If troubleshooting steps do not resolve the issue, please contact customer support.
8. Technical Specifications
| Specification | Value |
|---|---|
| Brand | CAMPLUX ENJOY OUTDOOR LIFE |
| Model Number | BW422LP |
| Product Dimensions (W x H) | 17.32" x 27.56" |
| Item Weight | 27 pounds |
| Wattage | 32 KW |
| Voltage | 3 Volts (2 D batteries required) |
| Maximum Flow Rate | 4.22 Gallons Per Minute (16L) |
| Maximum Temperature | 167 Degrees Fahrenheit |
| Heat Output | 110,000 BTU per Hour |
| Maximum Operating Pressure | 130 Pound per Square Inch |
| Mounting Type | Wall |
| Hose Length (Shower) | 59 Inches |
| Certification | CSA 4.3-2019 ANSI Z21.10.3-2019 |
9. Warranty Information
The CAMPLUX BW422 Outdoor Tankless Propane Water Heater comes with a 1 Year Warranty from the date of purchase. Please retain your proof of purchase for warranty claims. The warranty covers manufacturing defects under normal use conditions.
Damage resulting from improper installation, misuse, neglect, freezing, or unauthorized modifications is not covered under warranty.
10. Customer Support
For technical support, questions, or concerns regarding your CAMPLUX BW422 water heater, please contact CAMPLUX customer service:
- Phone: (844) 538-7475
- Online: Contact us through the Amazon platform or visit the official CAMPLUX website.
Our dedicated support team is available to assist you with any issues to ensure a seamless experience with your water heater.