Introduction
This manual provides essential instructions for the safe assembly, operation, and maintenance of your Micro MMD007 Deluxe Mini Scooter. Please read this manual thoroughly before first use and retain it for future reference. The Micro MMD007 Deluxe Mini Scooter is designed for children aged 3 years and up, with a maximum load capacity of 35 kg. It features a telescopic handlebar for adjustable height.
Safety Information
Warning: Always wear a helmet and protective gear (wrist guards, elbow pads, knee pads) when riding the scooter. Adult supervision is required at all times.
- Ensure all locking mechanisms are securely fastened before each use.
- Do not ride on public roads, uneven surfaces, or near traffic.
- Avoid riding in wet conditions, at dusk, or at night.
- The scooter is designed for one rider only.
- Regularly check for loose parts, wear, or damage. Do not use if damaged.
- Familiarize yourself with the braking mechanism before riding.

Setup
The Micro MMD007 Deluxe Mini Scooter requires minimal assembly.
- Handlebar Insertion: Insert the handlebar stem into the opening on the scooter deck until it clicks securely into place. Ensure the locking mechanism is engaged.
- Handlebar Height Adjustment: The telescopic handlebar can be adjusted to suit the rider's height.
- Locate the quick-release clamp on the handlebar stem.
- Open the clamp, adjust the handlebar to the desired height (between 48 cm and 64 cm), and then securely close the clamp.
- Ensure the handlebar is firmly locked and does not move up or down.
- Pre-Ride Check: Before the first ride, and before every subsequent ride, verify that all components are securely attached and in good working order. Check the wheels, brakes, and handlebar for any looseness or damage.

Operating Instructions
The Micro MMD007 Deluxe Mini Scooter is designed for intuitive riding.
- Starting: Place one foot on the scooter deck and use the other foot to push off the ground.
- Steering: The scooter uses a lean-to-steer mechanism. To turn, lean your body in the desired direction. The handlebar will follow your lean.
- Braking: The scooter is equipped with a rear brake. To slow down or stop, gently press your foot down on the brake pedal located above the rear wheel. Apply pressure gradually to avoid sudden stops.
- Stopping: Once stopped, place both feet on the ground.

Maintenance
Regular maintenance ensures the longevity and safe operation of your scooter.
- Cleaning: Wipe the scooter clean with a damp cloth after use. Avoid using harsh chemicals or abrasive cleaners. Do not hose down or immerse the scooter in water.
- Wheel Inspection: Periodically check the wheels for wear and tear. Ensure they spin freely and are not obstructed by debris.
- Brake Check: Verify that the rear brake functions effectively. The brake should engage smoothly and stop the scooter efficiently.
- Fastener Check: Regularly inspect all screws, bolts, and clamps to ensure they are tight. Tighten any loose fasteners as needed.
- Storage: Store the scooter in a dry place, away from direct sunlight and extreme temperatures, to prevent material degradation.

Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Handlebar is loose or wobbly. | Quick-release clamp not fully tightened or handlebar not fully inserted. | Ensure the handlebar stem is fully inserted until it clicks. Tighten the quick-release clamp securely. |
| Scooter does not steer smoothly. | Debris in steering mechanism or worn components. | Inspect the steering mechanism for any obstructions. Clean if necessary. If the issue persists, contact customer support. |
| Brake is not effective. | Worn brake pad or debris. | Check the brake pad for wear. Clean any debris from the brake area. If the brake pad is worn, it may need replacement. |
| Wheels do not spin freely. | Debris in wheel bearings or tight axles. | Remove any visible debris from around the wheels and axles. Ensure axle bolts are not overtightened. |
Specifications
- Model: MMD007
- Brand: Micro
- Age Range: 3 years and up
- Maximum Load Capacity: 35 kg
- Handlebar Height: Adjustable from 48 cm to 64 cm
- Brake Type: Rear Braking
- Frame Material: Metal
- Wheel Material: Plastic
- Number of Wheels: 3
- Product Dimensions: Approximately 60.96 x 15.24 x 27.94 cm (L x W x H)
- Item Weight: Approximately 1.95 kg
- Special Features: Foldable, Lightweight
Warranty and Support
For information regarding warranty coverage, replacement parts, or customer support, please refer to the official Micro Mobility Systems website or contact your local retailer. Keep your proof of purchase for warranty claims.




