Everbilt Outside Faucet Cover Instruction Manual

Introduction

Thank you for choosing the Everbilt Outside Faucet Cover. This manual provides essential information for the proper setup, operation, and maintenance of your faucet cover to ensure effective freeze protection for your outdoor faucets during cold weather conditions. Please read these instructions carefully before use.

Safety Information

Always prioritize safety when working with outdoor fixtures. While this product is designed for simple installation, observe the following:

• Ensure the faucet is turned off and drained before installing the cover, especially if freezing temperatures are imminent.
• Do not force the cover onto the faucet. It should fit snugly but without excessive pressure.
• Regularly inspect the cover for any damage or wear, particularly after severe weather. Replace if damaged to maintain effectiveness.
• Keep out of reach of children and pets.

Setup

Follow these steps to properly install your Everbilt Outside Faucet Cover:

1. Prepare the Faucet: Ensure your outdoor faucet is completely turned off. If possible, turn off the water supply to the outdoor faucet from an indoor shut-off valve and drain any remaining water from the faucet by opening it briefly.
2. Position the Cover: Place the Everbilt Faucet Cover over the outdoor faucet, ensuring it completely encloses the faucet head and extends slightly onto the wall. The foam material should create a tight seal against the wall.
3. Secure the Cover: Locate the drawstring or securing mechanism on the cover. Pull the drawstring tight around the faucet pipe and against the wall. Use the provided toggle or knot to secure the drawstring firmly, preventing the cover from being dislodged by wind or other elements.

Image: The Everbilt Outside Faucet Cover, showing its foam construction and drawstring for securing it around an outdoor faucet. This image illustrates the product's design for insulating outdoor water fixtures.

Operating

Once installed, the Everbilt Outside Faucet Cover operates passively by providing an insulating barrier against freezing temperatures. No active operation is required.

• Monitoring: Periodically check the cover during prolonged cold spells to ensure it remains securely in place and undamaged.
• Removal: When freezing temperatures are no longer a threat, loosen the drawstring and remove the cover. Store it in a dry place for future use.

Maintenance

Proper maintenance will extend the life of your faucet cover:

• Cleaning: If the cover becomes dirty, gently wipe it with a damp cloth. Avoid harsh chemicals or abrasive cleaners that could damage the foam material.
• Storage: After the cold season, clean the cover and allow it to air dry completely. Store it in a cool, dry place away from direct sunlight and pests. This helps prevent material degradation and ensures it's ready for the next winter.
• Inspection: Before each winter season, inspect the cover for any tears, cracks, or significant compression of the foam. A compromised cover may not provide adequate insulation.

Troubleshooting

If you encounter issues with your faucet cover, consider the following:

• Cover Falls Off: Ensure the drawstring is pulled tight and securely fastened. The cover should fit snugly against the wall. High winds may require additional securing methods if the drawstring alone is insufficient.
• Faucets Still Freezing:
  • Verify the cover is properly installed and creating a tight seal.
  • Confirm that the water supply to the outdoor faucet was turned off from an indoor valve and the faucet was drained. The cover insulates the exterior, but internal pipes can still freeze if water is left in them.
  • Check for damage to the cover that might reduce its insulating properties.
• Damage to Cover: If the cover is torn, cracked, or significantly degraded, its effectiveness will be reduced. Replace damaged covers promptly.

Specifications

Image: A diagram illustrating the dimensions of the Everbilt Outside Faucet Cover, indicating a height of approximately 7.6 inches (19 cm). This provides a visual reference for the product's size.

Warranty and Support

For specific warranty information or product support, please refer to the packaging or contact Everbilt customer service directly. Keep your purchase receipt for warranty claims.