Tecnolite LED-12V-360W-PR 360W Power Supply Driver User Manual

1. Introduction

This manual provides detailed instructions for the safe and efficient use of the Tecnolite LED-12V-360W-PR 360W Power Supply Driver. This device is designed for project applications, converting AC input voltage to a stable 12V DC output for LED lighting systems and other compatible devices. Please read this manual thoroughly before installation and operation.

Figure 1: Tecnolite LED-12V-360W-PR 360W Power Supply Driver. This image shows the aluminum casing, ventilation slots, input/output terminals, and voltage selection switch.

2. Safety Information

Always observe the following safety precautions to prevent injury or damage to the device:

• CAUTION! HIGH VOLTAGE INSIDE. Do not remove this cover. Only qualified service personnel should perform maintenance or repairs.
• Ensure the input voltage switch (115V/230V) is correctly set before connecting to the power source to avoid damaging the unit.
• Disconnect power before making any connections or adjustments.
• Install the driver in a well-ventilated area to prevent overheating.
• Do not expose the unit to moisture or extreme temperatures.
• Ensure proper grounding (indicated by the # symbol on the terminal block).
• Do not exceed the maximum load capacity of 360W.

3. Product Features

• Designed for project applications.
• Wide input voltage range: 100-277 VAC.
• Stable output voltage: 12 VDC.
• High power output: 360 W maximum load.
• Durable aluminum casing for heat dissipation and protection.
• Integrated drivers for efficient power conversion.

4. Setup and Installation

1. Unpacking: Carefully remove the power supply from its packaging and inspect for any physical damage.
2. Mounting: Mount the driver securely in a location that allows for adequate ventilation. Ensure no obstructions block the ventilation slots.
3. Input Voltage Selection: Locate the voltage selection switch on the side of the unit. Set it to either 115V or 230V according to your local mains voltage. Incorrect selection can damage the unit.
4. Wiring Input (AC): Connect the AC input wires to the terminal block labeled 'L' (Live), 'N' (Neutral), and '#' (Ground). Ensure all connections are tight and secure.
5. Wiring Output (DC): Connect your 12V DC load (e.g., LED strips, modules) to the output terminals labeled '+V' and '-V'. Observe correct polarity (+ to + and - to -).
6. Final Check: Double-check all connections and the input voltage selection before applying power.

5. Operating Instructions

Once the power supply is correctly installed and wired, you can apply power. The unit will convert the AC input to a stable 12V DC output. The output voltage can be finely adjusted using the '+V ADJ' potentiometer if necessary, though it is typically pre-calibrated.

• Ensure the total power consumption of connected devices does not exceed 360W.
• Monitor the unit for any unusual noises or excessive heat during initial operation.

6. Maintenance

The Tecnolite LED-12V-360W-PR driver requires minimal maintenance. Follow these guidelines to ensure longevity:

• Keep the unit clean and free from dust and debris. Use a soft, dry cloth for cleaning.
• Periodically check ventilation openings to ensure they are not blocked.
• Inspect wiring connections for tightness and signs of wear or corrosion.
• Do not attempt to open the casing, as it contains high voltage components and should only be serviced by qualified personnel.

7. Troubleshooting

8. Specifications

9. Warranty and Support

For warranty information or technical support, please contact Tecnolite customer service or visit the official Tecnolite brand store.

Tecnolite Brand Store: Tecnolite on Amazon.com.mx