Important Safety Information
Please read this manual thoroughly before installing, operating, or performing maintenance on this equipment. Failure to follow these instructions may result in property damage, injury, or death. Keep this manual for future reference.
- This appliance is intended for commercial use only.
- Ensure the unit is properly grounded.
- Do not immerse the unit in water or spray with water.
- Always disconnect power before cleaning or servicing.
- Keep hands clear of moving rollers during operation.
- Surfaces will be hot during and after operation. Use caution.
Setup Instructions
1. Unpacking
Carefully remove the hot dog roller grill from its packaging. Inspect the unit for any shipping damage. Report any damage to the carrier immediately.
2. Placement
Place the grill on a stable, level, non-combustible surface. Ensure adequate clearance around the unit for proper ventilation and safe operation. Do not place near heat-sensitive materials.
3. Electrical Connection
This unit operates on 120 Volts. Connect the grill to a dedicated, properly grounded electrical outlet. Do not use extension cords or adapters.
4. Initial Cleaning
Before first use, clean the rollers and all accessible surfaces with a mild detergent and warm water. Rinse thoroughly and dry completely. Refer to the "Cleaning and Maintenance" section for detailed instructions.
Figure 1: APW Wyott HRS-20S Hot Dog Roller Grill. This image shows the overall design of the roller grill with its slanted non-stick rollers and stainless steel construction.
Operating Instructions
1. Power On and Preheating
- Ensure the unit is plugged into a grounded 120V outlet.
- Turn the power switch to the "ON" position.
- Set the infinite control knob(s) to the desired cooking temperature. For initial preheating, set to a higher temperature.
- Allow the grill to preheat for approximately 15-20 minutes, or until the rollers reach the desired temperature.
2. Loading Hot Dogs
- Place hot dogs evenly across the non-stick rollers. Avoid overcrowding to ensure even cooking.
- The slanted design helps hot dogs roll consistently.
3. Cooking and Holding
- Monitor the hot dogs as they cook. The rollers will continuously turn to ensure even heating.
- Adjust the infinite control knob(s) as needed to maintain the desired cooking or holding temperature.
- Once cooked, the hot dogs can be held at a lower temperature setting until served.
Figure 2: Example of control panel with infinite control knobs. This image illustrates where the temperature control knobs are typically located on the unit.
Cleaning and Maintenance
Regular cleaning and maintenance will extend the life of your APW Wyott HRS-20S hot dog roller grill and ensure optimal performance.
Daily Cleaning
- Disconnect Power: Always unplug the unit and allow it to cool completely before cleaning.
- Remove Debris: Carefully remove any food debris from the rollers and drip tray.
- Clean Rollers: Wipe the non-stick rollers with a damp cloth and mild, non-abrasive detergent. Do not use steel wool or abrasive cleaners, as this can damage the non-stick coating. Rinse with a clean, damp cloth and dry thoroughly.
- Clean Exterior: Wipe down the stainless steel exterior with a damp cloth and mild detergent. Polish with a soft, dry cloth to maintain its finish.
- Clean Drip Tray: Remove and empty the drip tray. Wash it with warm, soapy water, rinse, and dry before replacing.
Periodic Maintenance
- Inspect the power cord for any damage. If damaged, contact a qualified service technician.
- Ensure all feet are intact and providing stable support.
- Check for any unusual noises during operation, which may indicate a need for professional servicing.
Figure 3: Illustrative image of cleaning the non-stick rollers. This image demonstrates the process of wiping down the rollers for daily cleaning.
Troubleshooting
Before contacting service, please review the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Unit does not power on. | No power to outlet; power switch off; tripped circuit breaker. | Check power cord connection; ensure power switch is ON; reset circuit breaker; test outlet with another appliance. |
| Rollers not turning. | Motor issue; obstruction; unit not powered. | Ensure unit is powered; check for obstructions between rollers; if problem persists, contact service. |
| Hot dogs not cooking evenly. | Overcrowding; incorrect temperature setting; uneven surface. | Reduce number of hot dogs; adjust temperature; ensure unit is on a level surface. |
| Unit is smoking excessively. | Grease buildup; food debris. | Clean rollers and drip tray thoroughly. Ensure proper ventilation. |
If these solutions do not resolve the issue, please contact APW Wyott customer support or a qualified service technician.
Specifications
| Model | HRS-20S |
| Brand | APW Wyott |
| Voltage | 120 Volts |
| Fuel Type | Electric |
| Finish Type | Non-Stick |
| Material | Alloy Steel, Stainless Steel (Handle) |
| Installation Type | Free Standing |
| Assembly Required | Yes |
| Dimensions (W x D) | 17-1/4" W x 18-5/8" D |
| Grill Length | 17" |
| Approximate Hot Dog Capacity | 306 Franks Per Hour |
| Roller Quantity | 11 |
Warranty and Support
For warranty information, technical support, or to order replacement parts, please contact APW Wyott customer service directly. Keep your purchase receipt and model number (HRS-20S) available when contacting support.
You can typically find contact information on the manufacturer's official website or on the product's original packaging.