Introduction
This manual provides instructions for the installation, operation, and maintenance of your Denali Pure replacement refrigerator water filter. This filter is designed to provide clean, filtered water from your refrigerator dispenser and ice maker.

Image: A six-pack of Denali Pure replacement refrigerator water filters.
Compatibility
This Denali Pure filter is compatible with refrigerators requiring General Electric MWF and MWFP filter cartridges. It is also compatible with other models including:
- GE Models: MWF, MWFP, MWFA, MWFAP, MWFINT, GWF, GWF01, GWF06, GWFA, HWF, HWFA, FMG-1, FMG
- Kenmore Models: 46-9991, 46 9991, 469991, 9991, 46-9996, 46 9996, 469996, 9996

Image: A Denali Pure filter shown alongside a list of compatible General Electric and Kenmore refrigerator models.
Safety Information
- Read all instructions thoroughly before attempting installation.
- Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
- Ensure the filter is securely installed to prevent leaks.
- Keep out of reach of children.
Installation Instructions
Follow these steps to install your new Denali Pure water filter:
- Locate Filter Compartment: Identify the water filter compartment in your refrigerator. This is typically located in the upper right corner of the fresh food section, or in the grille at the bottom of the refrigerator.
- Remove Old Filter: Twist the old filter counter-clockwise until it releases from the filter housing. Pull the old filter straight out. A small amount of water may drip out; this is normal.
- Prepare New Filter: Remove the protective cap from the new Denali Pure filter.
- Insert New Filter: Push the new filter into the housing and twist it clockwise until it stops and is securely seated. You may feel a slight resistance as the filter seals.
- Flush System: After installation, dispense approximately 2.5 gallons (about 10 liters) of water through the refrigerator dispenser to flush out air and carbon fines. The water flow may be intermittent initially as air is purged from the system.
- Check for Leaks: Inspect the filter area for any signs of water leakage. If a leak occurs, re-seat the filter or contact support.
- Reset Filter Indicator: If your refrigerator has a filter change indicator light, consult your refrigerator's user manual for instructions on how to reset it.

Image: Visual representation highlighting the easy, leak-free, perfect fit, and tool-free installation features of the filter.
Operating Instructions
Once the filter is installed and flushed, your refrigerator's water dispenser and ice maker will provide filtered water. No special operating procedures are required beyond regular use.
Maintenance
For optimal performance and to ensure continuous access to clean, filtered water, it is recommended to replace your Denali Pure water filter every 6 months or after filtering 300 gallons (1136 liters), whichever comes first. Regular replacement helps maintain water quality and flow rate.

Image: A visual reminder to replace the water filter every 6 months for best performance.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Slow water flow from dispenser | Clogged filter, air in system, low water pressure | Flush the system for 2-3 minutes. If problem persists, replace filter. Check household water pressure. |
| Water leaking from filter area | Filter not seated correctly, damaged O-ring | Remove and re-install the filter, ensuring it is twisted clockwise until secure. Inspect O-rings for damage. |
| Bad taste or odor in water | New filter not flushed, filter expired, contamination | Flush the system thoroughly. If taste persists, replace the filter. Ensure filter is replaced every 6 months. |
| No water from dispenser | Filter not installed, water supply off, frozen water line | Ensure filter is correctly installed. Check if refrigerator water supply valve is open. Thaw any frozen lines. |
Specifications
- Filter Type: Replacement Refrigerator Water Filter
- Model Number: WF-MWF-6PK-DL494
- Filtration Media: High-Quality Pressed Activated Carbon & Coconut Shell Cartridge
- Capacity: 300 gallons (1136 liters)
- Recommended Replacement: Every 6 months
- External Testing Certification: WQA, ANSI, NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine, Taste, and Odor.

Image: An illustration detailing the high-quality pressed activated carbon and coconut shell cartridge within the filter.

Image: A graphic illustrating the multiple layers within the filter designed for efficient water filtration.

Image: The NSF Certified logo, indicating the system is tested and certified against NSF/ANSI Standard 42 for reducing chlorine, taste, and odor.
Warranty and Support
Any warranties for this product are offered solely by Denali Pure. This product is a replacement part and is not affiliated with any OEM brands, nor is it covered under any warranties offered by the original manufacturers.
For technical support, warranty claims, or further assistance, please refer to the contact information provided with your purchase or visit the official Denali Pure website.