Teka E 1C CN

Teka Stainless Steel Sink E 1C CN Instruction Manual

Model: E 1C CN (Reference: 10132001)

1. Introduction

Thank you for choosing the Teka E 1C CN Stainless Steel Sink. This manual provides essential information for the safe installation, proper operation, and effective maintenance of your new sink. Please read these instructions carefully before installation and retain them for future reference.

Teka E 1C CN Stainless Steel Sink

Image showing the overall design of the Teka E 1C CN single bowl stainless steel sink.

2. Safety Instructions

  • Always ensure the water supply is turned off before beginning any installation or maintenance work.
  • It is recommended that installation be performed by a qualified professional to ensure proper sealing and connection.
  • Wear appropriate personal protective equipment, such as gloves and eye protection, during installation.
  • Check for leaks thoroughly after installation and before regular use.
  • Do not use corrosive or abrasive cleaning agents that could damage the stainless steel finish.
  • Ensure proper ventilation when using sealants or adhesives.

3. Package Contents

Verify that all components are present before starting the installation:

  • 1 x Teka E 1C CN Stainless Steel Sink
  • 1 x User Manual

4. Setup and Installation

This sink is designed for countertop installation. Follow these general steps for installation:

  1. Prepare the Countertop: Measure and cut an opening in your countertop according to the sink's external dimensions (28 cm x 40.5 cm). Ensure the edges are smooth and clean.
  2. Apply Sealant: Apply a continuous bead of silicone sealant around the perimeter of the sink's flange that will contact the countertop.
  3. Position the Sink: Carefully lower the sink into the prepared countertop opening, ensuring it is properly aligned.
  4. Secure the Sink: Use the provided mounting clips (if included, or standard countertop sink clips) to secure the sink firmly to the underside of the countertop. Tighten evenly to ensure a good seal.
  5. Connect Plumbing: Install the drain assembly (1 1/2 inch) and connect it to your household plumbing. Connect the faucet (not included) according to its manufacturer's instructions.
  6. Test for Leaks: Turn on the water supply and fill the sink. Check all connections for any signs of leakage. Tighten connections as necessary.

5. Operating Instructions

The Teka E 1C CN sink is designed for standard kitchen use. Simply use your faucet to control water flow and temperature. Ensure the drain stopper is properly seated when filling the sink and removed for drainage.

6. Maintenance and Cleaning

To maintain the appearance and longevity of your stainless steel sink, follow these guidelines:

  • Daily Cleaning: Clean the sink regularly with warm water, a mild detergent, and a soft cloth or sponge. Rinse thoroughly and dry with a clean cloth to prevent water spots and mineral buildup.
  • Avoid Abrasives: Do not use abrasive cleaners, steel wool, wire brushes, or scouring pads, as these can scratch the stainless steel surface.
  • Chemicals: Avoid prolonged contact with strong acids, alkalis, bleach, or harsh chemical cleaners, which can stain or corrode the stainless steel. If contact occurs, rinse immediately and thoroughly.
  • Prevent Stains: Do not leave wet sponges, tea bags, or other items that can cause stains on the sink surface for extended periods.
  • Drain Care: Regularly clean the drain area to prevent blockages and odors.

7. Troubleshooting

Here are some common issues and their potential solutions:

  • Slow Drainage:
    • Check if the drain stopper is fully open.
    • Clear any visible debris from the drain opening.
    • If the issue persists, a blockage may be further down the plumbing. Consult a plumber if necessary.
  • Water Spots/Stains:
    • These are often caused by mineral deposits from hard water. Dry the sink thoroughly after each use.
    • For existing spots, use a stainless steel cleaner or a solution of vinegar and water, then rinse and dry.
  • Leaks:
    • Check all plumbing connections under the sink. Tighten any loose fittings.
    • Inspect the sealant around the sink's edge. If damaged, reapply sealant.
    • If leaks persist, professional assistance may be required.

8. Specifications

BrandTeka
Model NumberE 1C CN (10132001)
Material18/10 CN Stainless Steel
FinishMatte Stainless Steel
ColorGrey
Product Dimensions (L x W x H)28 x 40.5 x 15 cm
Weight1.66 kg
Bowl Depth15 cm
Drain Size1 1/2 inch
Installation MethodCountertop
ShapeOblong
Number of Bowls1

9. Warranty and Support

For warranty information and customer support, please refer to the documentation provided with your purchase or contact your retailer. Teka strives to provide high-quality products and support.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.