UpBright 18V AC/DC Adapter User Manual

1. Introduction

This manual provides essential instructions for the safe and effective use of your UpBright 18V AC/DC Adapter. This adapter is designed to power and charge compatible Hunter Douglas PowerView and PowerRise motorized shades and blinds.

2. Important Safety Information

• Rechargeable Batteries Only: This adapter is designed to recharge ONLY rechargeable batteries. Do not attempt to recharge alkaline batteries, as this can cause damage or injury.
• Input Voltage: The adapter supports a worldwide input voltage range of 100-240VAC, 50/60Hz.
• Protection Features: The adapter includes built-in safety features:
  • OVP (Over Voltage Output Protection): Protects against excessive output voltage.
  • OCP (Over Current Output Protection): Protects against excessive output current.
  • SCP (Short Circuit Output Protection): Protects against short circuits.
• Always ensure the adapter is used in a well-ventilated area.
• Do not expose the adapter to water or excessive moisture.
• Disconnect the adapter from the power outlet when not in use for extended periods.

3. Package Contents

Your package should contain the following item:

• 1x UpBright 18V AC/DC Adapter

4. Setup Instructions

Follow these steps to connect your UpBright AC/DC adapter to your Hunter Douglas motorized shades:

1. Locate the power input port on your Hunter Douglas motorized shade or blind. This is typically a barrel connector.
2. Connect the male jack connector end of the adapter cable to the power input port on your shade. Ensure a secure connection.
3. Plug the AC prongs of the UpBright 18V DC Plug-In Wall Transformer into a standard electrical wall outlet (100-240VAC, 50/60Hz).
4. Once connected, your motorized shade should receive power, and if equipped with rechargeable batteries, they will begin charging.

Figure 1: Connection Diagram for UpBright AC/DC Adapter

5. Operation

The UpBright 18V AC/DC Adapter provides continuous power to your Hunter Douglas motorized shades and blinds. If your shades are equipped with rechargeable batteries, the adapter will also facilitate their charging. No specific operational steps are required beyond proper connection.

6. Compatible Models

This UpBright 18V AC/DC Adapter is compatible with various Hunter Douglas PowerView and PowerRise motorized shades and blinds, including but not limited to the following models and part numbers:

• Hunter Douglas PowerView M/N: 2002000036
• Hunter Douglas PowerView Motor version 2 (18V Motorized Shades & Blinds Rechargeable Battery)
• AMIGO Model No: AMS165-1802000FU
• Part No: 7806000000
• Hunter Douglas Luminette Privacy Sheer PowerView Motorization Kit
• Hunter Douglas Part No.: 2989038000, 2989048000
• Model: ADS0366-W180200, ADS0366W180200
• Hunter Douglas Platinum Technology 2.1 18V DC Plug-in Transformer

7. Care and Maintenance

• Keep the adapter clean by wiping it with a dry, soft cloth.
• Avoid dropping the adapter or subjecting it to strong impacts.
• Store the adapter in a cool, dry place when not in use.
• Regularly inspect the cable and connectors for any signs of damage. If damage is found, discontinue use and replace the adapter.

8. Troubleshooting

If your motorized shades are not receiving power or charging, consider the following:

• Check Connections: Ensure that both ends of the adapter (to the shade and to the wall outlet) are securely plugged in.
• Verify Power Outlet: Test the wall outlet with another device to confirm it is supplying power.
• Inspect Adapter: Look for any visible damage to the adapter cable or housing. If damaged, do not use.
• Shade Battery Type: Confirm that the batteries in your shade are rechargeable. This adapter cannot charge non-rechargeable (alkaline) batteries.

9. Product Specifications

10. Warranty and Support

This UpBright product comes with a 30-day refund policy and a 24-month exchange warranty. For support or warranty claims, please contact your retailer or the manufacturer directly.